- 您现在的位置：买卖IC网 > PDF目录10253 > CS8406-CSZ (Cirrus Logic Inc)IC XMITTER DGTL 192KHZ 28SOIC PDF资料下载
参数资料
| 型号： | CS8406-CSZ |
| 厂商： | Cirrus Logic Inc |
| 文件页数： | 13/28页 |
| 文件大小： | 0K |
| 描述： | IC XMITTER DGTL 192KHZ 28SOIC |
| 标准包装： | 27 |
| 类型： | 数字音频接口发射器 |
| 应用： | 车载音频 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 28-SOIC |
| 包装： | 管件 |
| 产品目录页面： | 759 (CN2011-ZH PDF) |
| 配用： | 598-1017-ND - BOARD EVAL FOR CS8416 RCVR |
| 其它名称： | 598-1757 CS8406-CSZ-ND Q3602527 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
20
DS580F6
CS8406
MMTCS - Select A or B channel status data to transmit in Mono Mode
Default = ‘0’
0 - Use channel A CS data for the A subframe and use channel B CS data for the B subframe
1 - Use the same CS data for both the A and B subframe outputs. If MMTLR = 0, use the left channel CS
data. If MMTLR = 1, use the right channel CS data.
MMTLR - Channel Selection for AES Transmitter Mono Mode
Default = ‘0’
0 - Use left channel input data for consecutive subframe outputs
1- Use right channel input data for consecutive subframe outputs
8.4
Data Flow Control (03h)
The Data Flow Control register configures the flow of audio data. The output data should be muted prior to
changing bits in this register to avoid transients.
TXOFF - AES3 Transmitter Output Driver Control
Default = ‘0
0 - AES3 transmitter output pin drivers normal operation
1 - AES3 transmitter output pin drivers drive to 0 V.
AESBP - AES3 bypass mode selection
Default = ‘0’
0 - Normal operation
1 - Connect the AES3 transmitter driver input di rectly to the RXP pin, which becomes a normal TTL
threshold digital input.
8.5
Clock Source Control (04h)
This register configures the clock sources of various blocks. In conjunction with the Data Flow Control reg-
ister, various Receiver/Transmitter/Transceiver modes may be selected.
RUN - Controls the internal clocks, allowing the CS8406 to be placed in a “powered down” low current con-
sumption, state.
Default = ‘0’
0 - Internal clocks are stopped. Internal state machines are reset. The fully static
control port registers are operational, allowing registers to be read or changed. Reading and
writing the U and C data buffers is not possible. Power consumption is low.
1 - Normal part operation. This bit must be set to 1 to allow the CS8406 to begin operation.
All input clocks should be stable in frequency and phase when RUN is set to 1.
CLK1:0 - Output master clock (OMCK) input frequency to output sample rate (Fs) ratio selector. If these bits
are changed during normal operation, always stop the CS8406 first (RUN = 0), write the new value, then
start the CS8406 (RUN = 1).
7
6
5
432
1
0
0
TXOFF
AESBP
0
7
6
5
432
1
0
0
RUN
CLK1
CLK0
0
相关PDF资料 |
PDF描述 |
|---|---|
| 14281-18PG-3ES | CONN RCPT 18POS PNL MNT PIN |
| AD7708BRU | IC ADC 16BIT R-R 8/10CH 28-TSSOP |
| MS3106F20-29PW | CONN PLUG 17POS STRAIGHT W/PINS |
| MS3106F20-29P | CONN PLUG 17POS STRAIGHT W/PINS |
| MS3106E20-29P | CONN PLUG 17POS STRAIGHT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CS8406-CSZR | 功能描述:音频发送器、接收器、收发器 IC 192 kHz Digital Audio Transmitter RoHS:否 制造商:Cirrus Logic 工作电源电压:3.3 V, 5 V 电源电流:11.8 mA 通道数量:1 最大工作温度:+ 70 C 接口类型:I2C, SPI 安装风格:SMD/SMT 封装 / 箱体:TSSOP-28 封装: |
| CS8406-CZ | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:192 KHZ DIGITAL AUDIO INTERFACE TRANSMITTER |
| CS8406-CZR | 制造商:Cirrus Logic 功能描述:DGTL AUD TRANSMITTER 1TX 28TSSOP - Tape and Reel |
| CS8406-CZZ | 功能描述:音频发送器、接收器、收发器 192kHz Digital Audio Transmitter RoHS:否 制造商:Cirrus Logic 工作电源电压:3.3 V, 5 V 电源电流:11.8 mA 通道数量:1 最大工作温度:+ 70 C 接口类型:I2C, SPI 安装风格:SMD/SMT 封装 / 箱体:TSSOP-28 封装: |
| CS8406-CZZR | 功能描述:音频发送器、接收器、收发器 IC 192 kHz Digital Audio Transmitter RoHS:否 制造商:Cirrus Logic 工作电源电压:3.3 V, 5 V 电源电流:11.8 mA 通道数量:1 最大工作温度:+ 70 C 接口类型:I2C, SPI 安装风格:SMD/SMT 封装 / 箱体:TSSOP-28 封装: |
发布紧急采购，3分钟左右您将得到回复。