- 您现在的位置：买卖IC网 > Datasheet目录218 > CUB5TCB0 (Red Lion Controls)METER PANEL LCD THERMOCOUPLE RED Datasheet资料下载
参数资料
| 型号： | CUB5TCB0 |
| 厂商： | Red Lion Controls |
| 文件页数： | 11/12页 |
| 文件大小： | 0K |
| 描述： | METER PANEL LCD THERMOCOUPLE RED |
| 标准包装： | 1 |
| 系列： | CUB5 |
| 类型： | 热电偶 |
| 显示器类型： | LCD |
| 显示器正面尺寸： | 2.95" L x 1.54" W（74.9 x 39.1mm） |
| 显示器位数： | 5 |
| 显示器位数 - 高度： | 0.480"（12.19mm） |
| 背光： | 绿，红 |
| 安装类型： | 面板安装 |
| 端子： | 螺钉端子 |
| 电源电压： | 9 V ~ 28 V |
| 其它名称： | CUB5TCB0-ND Q4711466 RLC142 |
{
( Auto )
ON
ON
OFF
( LAtCH )
OFF
OFF
STATE
?
OFF
When the user input or RST button is activated (momentary action), the
corresponding “on” output is reset immediately and remains off until the
trigger point is crossed again. (Previously latched alarms will be off if power
up Display Value is lower than setpoint value.)
L-dLY = Latch with delay reset action; This action latches the output on at the
trigger point per the Setpoint Action shown in Setpoint Output Figures. Latch
means that the output can only be turned off by the front panel RST button
or user input manual reset, serial reset command or meter power cycle. When
the user input or RST button is activated (momentary action), the meter
delays the event until the corresponding “on” output crosses the trigger off
point. (Previously latched outputs are off if power up Display Value is lower
than setpoint value. During a power cycle, the meter erases a previous L-dLY
reset if it is not activated at power up.)
MANUAL
RESET
SP
Hys
SP - Hys
OFF OFF OFF
OUTPUT
ON ON
OFF ON OFF ON OFF ( L-dLY )
STANDBY OPERATION
Stb-n ? NO YES
? NO
When YES , the output is disabled (after a power up) until the trigger point is
crossed. Once the output is on, the output operates normally per the Setpoint
Action and OutputReset Action.
PROBE BURN-OUT ACTION
brn-n ?
OFF ON
Enter the probe burn-out action. In the event of a temperature probe failure
(open), the output can be programmed to be on or off.
CHANGE DISPLAY COLOR w/OUTPUT STATE
Setpoint Output Reset Actions
ChC-n
?
?
NO
NO
YES
rEn-n
?
OUTPUT RESET WITH DISPLAY RESET
? NO YES
YES
This parameter enables the backlight CUB5 to switch the backlight color when
the output state changes. This parameter is only active for the backlight version.
This parameter enables the RST button or user input to reset the output when
the display is reset.
Note: For this parameter to operate, the RST button or User Input being used
must be set to dSP and the Input value must be displayed. If these conditions are
not met, the output will not reset.
5.5 MODULE 5 - S ERIAL S ETUP P ARAMETERS ( 5-SEr )
5-SEr
SEL
PARAMETER MENU
Pro
bAUd
Baud Rate
dAtA
Data Bit
PAr
Parity Bit
Addr
Meter
Address
Abbr
Abbreviated
Printing
OPt
Print
Options
The Serial Setup Parameters are only active when one of the optional serial communications/programming cards is installed in the meter.
Refer to the CUB5COM bulletin for details and setup for the CUB5 RS232 or RS485 serial communications.
Refer to the CUB5USB bulletin for details on the CUB5 USB programming and programming requirements.
LIMITED WARRANTY
The Company warrants the products it manufactures against defects in materials and workmanship for a period limited to two years
from the date of shipment, provided the products have been stored, handled, installed, and used under proper conditions. The
Company’s liability under this limited warranty shall extend only to the repair or replacement of a defective product, at The
Company’s option. The Company disclaims all liability for any affirmation, promise or representation with respect to the products.
The customer agrees to hold Red Lion Controls harmless from, defend, and indemnify RLC against damages, claims, and expenses
arising out of subsequent sales of RLC products or products containing components manufactured by RLC and based upon personal
injuries, deaths, property damage, lost profits, and other matters which Buyer, its employees, or sub-contractors are or may be to
any extent liable, including without limitation penalties imposed by the Consumer Product Safety Act (P.L. 92-573) and liability
imposed upon any person pursuant to the Magnuson-Moss Warranty Act (P.L. 93-637), as now in effect or as amended hereafter.
No warranties expressed or implied are created with respect to The Company’s products except those expressly contained herein.
The Customer acknowledges the disclaimers and limitations contained herein and relies on no other warranties or affirmations.
11
相关PDF资料 |
PDF描述 |
|---|---|
| CUB5USB0 | USB OPTION CARD |
| CUB5VR00 | METER LCD DC VOLT 8DIGIT |
| CUR-3285-MB | BOX ABS 8.25X5.15X3.13" BLACK |
| CUR-3286-MB | BOX ABS 10.15X6.15X3.13" BLACK |
| CUR-793-MB | BOX ABS 4.1" X 2.23" X 2" W/BKTS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CUB5TCR0 | 功能描述:THERMO METER REFLECTIVE RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:* 标准包装:12 系列:* 其它名称:Q7072030 |
| CUB5TR00 | 制造商:Red Lion Controls 功能描述:PRESET TIMR & CYCLE COUNTR W/REFL DSPLY 制造商:Red Lion Controls 功能描述:TIMER, ELECTRONIC , 8DIGIT, 9V TO 28V; Supply Voltage Range:9V DC to 28V DC; Panel Cutout Height:39.1mm; Panel Cutout Width:74.9mm; Time Range:- ;RoHS Compliant: Yes |
| CUB5USB0 | 功能描述:USB OPTION CARD RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:* 标准包装:12 系列:* 其它名称:Q7072030 |
| CUB5VB00 | 功能描述:DC VOLTMETER RED/GREEN BKLT RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:* 标准包装:12 系列:* 其它名称:Q7072030 |
| CUB5VR00 | 功能描述:METER LCD DC VOLT 8DIGIT RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:* 标准包装:12 系列:* 其它名称:Q7072030 |
发布紧急采购，3分钟左右您将得到回复。