- 您现在的位置：买卖IC网 > PDF目录19098 > CUB7CVR0 (Red Lion Controls)COUNTER 8-DIGIT HV RED PDF资料下载
参数资料
| 型号： | CUB7CVR0 |
| 厂商： | Red Lion Controls |
| 文件页数： | 1/8页 |
| 文件大小： | 0K |
| 描述： | COUNTER 8-DIGIT HV RED |
| 标准包装： | 1 |
| 系列： | CUB7 |
| 计数速率： | 10kHz |
| 数字/字母数： | 8 |
| 输入类型： | 电压 |
| 电源电压： | 不需要（包括电池） |
| 显示器类型： | LCD 红色背光 |
| 产品目录页面： | 2853 (CN2011-ZH PDF) |
| 其它名称： | RLC140 |
Bulletin No. CUB7N-D
Drawing No. LP0825
Released 09/12
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
MODEL CUB7 – MINIATURE ELECTRONIC 8 DIGIT COUNTER or TIMER
l 0.35" (8.9 mm) HIGH LCD DIGITS, REFLECTIVE OR TRANSMISSIVE
WITH YELLOW/GREEN OR RED BACKLIGHTING (6-26 VDC power
supply required for version with LED backlighting)
l INTERNAL LITHIUM BATTERY PROVIDES UP TO 7 YEARS OF
TYPICAL UNINTERRUPTED OPERATION
l COUNT SPEEDS UP TO 10KHZ
l 9 PROGRAMMABLE TIME RANGES
l CONTACT, LOGIC, OPEN COLLECTOR, OR HIGH VOLTAGE INPUTS
R
C UL US LISTED
3RSD
PROCESS CONTROL EQUIPMENT
l STANDARD WIRE CONNECTIONS OR OPTIONAL PLUG-IN TERMINAL
BLOCK
l NEMA 4X/IP65 SEALED FRONT BEZEL THAT FITS 1/32 DIN CUT-OUT
DESCRIPTION
The CUB7 series is an 8-digit lithium battery powered miniature counter or
timer with large 0.35" (8.9 mm) high digits. It has an LCD read-out available in
Positive Imagine Reflective, Negative Image Transmissive with yellow/green or
red backlighting. The backlight versions require an external 6-26 VDC power
supply. The CUB7 series is housed in a lightweight, high impact plastic case
with a clear viewing window. The sealed front panel with silicon rubber keypad
meets NEMA 4X/IP65 specification for wash-down and/or dusty environments,
when properly installed with supplied panel gasket and mounting clip.
Both counter and timer CUB7 models are available with a low voltage input
(28 VDC max) or an isolated high voltage input (50-250 VDC/VAC). The low
voltage input has DIP switch selections for SINKING or SOURCING along
with a HIGH/LOW FREQUENCY selection (low frequency for contact inputs).
Both units have front panel keypads that can be used to reset the display. The
keypad can be enabled/disabled via a single DIP switch. The standard unit uses
22 gauge wires for external connections, an optional plug-in terminal block is
available.
SAFETY SUMMARY
All safety related regulations, local codes and instructions that appear in the
literature or on equipment must be observed to ensure personal safety and to
prevent damage to either the instrument or equipment connected to it. If
equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
CAUTION: Risk of Danger. CAUTION: Risk of electric shock.
Read complete instructions prior to
installation and operation of the unit.
SPECIFICATIONS
1. DISPLAY : 8-digit LCD, 0.35" (8.90 mm) high digits
2. POWER : Non-replaceable internal 3.6 VDC lithium battery provides 7 years
of typical continuous operation (high count speeds in SNK mode & extreme
ambient temperatures will decrease battery life, use of SRC mode can extend
battery life)
OPTIONAL LED BACKLIGHT POWER : 6-26 VDC @ 25 mA max.
Must use an NEC Class 2 or Limited Power Source (LPS) rated power supply.
Note: External power shall incorporate disconnecting device (switch or circuit
breaker) and provide Double/Reinforced isolation from MAINS supply.
3. LOW VOLTAGE INPUT :
COUNTERS: CUB7CCS0, CUB7CCR0, CUB7CCG0
SNK mode (DIP switch 1 off, internal pull-up to battery)
V IN High Min = 1.25 VDC; V IN Low Max = 0.45 VDC
I IN Max = 8 μA; V IN Max = 3.6 VDC
Count Speed: (count on negative edge)
High freq mode (DIP switch 2 off): max 5 kHz @ 50% duty cycle
Low freq mode (DIP switch 2 on): max 30 Hz @ 50% duty cycle
Note: The three models listed above may be used for count inputs with
10-50 VAC signals when using a VCM10000 converter module. DIP
switches must be set for SNK and Low frequency.
SRC mode (DIP switch 1 on, internal 20 k W pull-down to common)
V IN High Min = 1.25 VDC; V IN Low Max = 0.45 VDC
I IN Max = 5 mA; V IN Max = 28 VDC
Count Speed: (count on negative edge)
High freq mode (DIP switch 2 off): max 10 kHz @ 50% duty cycle
Low freq mode (DIP switch 2 on): max 50 Hz @ 50% duty cycle
TIMERS:
Models: CUB7TCS0, CUB7TCR0, CUB7TCG0 For these models, the
unit will time when the CUB7 input is low.
SNK mode (DIP switch 1 off, internal pull-up to battery)
V IN High Min = 1.25 VDC; V IN Low Max = 0.45 VDC
I IN Max = 8 μA; V IN Max = 3.6 VDC
Note: The three models listed above may be used with 10-50 VAC
DIMENSIONS In inches (mm)
1.10
(27.9)
Note: Recommended minimum clearance (behind the panel) for
mounting clip installation is 2.1" (53.4) H x 5.5" (140) W.
0.87
(22.1)
2.00 (50.8)
1.64 (41.6)
With Wires
1
2.17 (55)
With Terminal Block
相关PDF资料 |
PDF描述 |
|---|---|
| CMI01Y | LED YELLOW T1 3/4 PC MNT |
| 5680FX;5LC | LED T1 DUAL X/AMBER RA PCB |
| CUB4L000 | COUNTER, REFLECTIVE |
| 5322F7 | LED YELLOW T1 .25" HI RTANG ASSY |
| 5381H7LC | LED T1-3/4 YLW 583NM VERT ASSY |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CUB7CVS0 | 功能描述:COUNTER 8-DIGIT HV REFLECTIVE RoHS:是 类别:工业控制，仪表 >> 计数器 系列:CUB7 其它有关文件:Declaration of Conformity 标准包装:1 系列:99766 计数速率:25Hz 数字/字母数:5 输入类型:机电式脉冲 输出类型:- 电源电压:24V 显示器类型:十进制拨轮 |
| CUB7P000 | 功能描述:COUNTER 8-DIGIT CONTACT REFLECTV RoHS:是 类别:工业控制，仪表 >> 计数器 系列:CUB7 其它有关文件:Declaration of Conformity 标准包装:1 系列:99766 计数速率:25Hz 数字/字母数:5 输入类型:机电式脉冲 输出类型:- 电源电压:24V 显示器类型:十进制拨轮 |
| CUB7P010 | 功能描述:COUNTER 8-DIGIT CONTACT GREEN RoHS:是 类别:工业控制，仪表 >> 计数器 系列:CUB7 其它有关文件:Declaration of Conformity 标准包装:1 系列:99766 计数速率:25Hz 数字/字母数:5 输入类型:机电式脉冲 输出类型:- 电源电压:24V 显示器类型:十进制拨轮 |
| CUB7P020 | 功能描述:COUNTER 8-DIGIT CONTACT RED RoHS:是 类别:工业控制，仪表 >> 计数器 系列:CUB7 其它有关文件:Declaration of Conformity 标准包装:1 系列:99766 计数速率:25Hz 数字/字母数:5 输入类型:机电式脉冲 输出类型:- 电源电压:24V 显示器类型:十进制拨轮 |
| CUB7P100 | 功能描述:COUNTER 8-DIGIT VOLTAGE REFLECTV RoHS:是 类别:工业控制，仪表 >> 计数器 系列:CUB7 其它有关文件:Declaration of Conformity 标准包装:1 系列:99766 计数速率:25Hz 数字/字母数:5 输入类型:机电式脉冲 输出类型:- 电源电压:24V 显示器类型:十进制拨轮 |
发布紧急采购，3分钟左右您将得到回复。