- 您现在的位置：买卖IC网 > Datasheet目录620 > CUB7T000 (Red Lion Controls)TIMER LCD PROGRAM 8 DIGIT Datasheet资料下载
参数资料
| 型号： | CUB7T000 |
| 厂商： | Red Lion Controls |
| 文件页数： | 1/4页 |
| 文件大小： | 0K |
| 描述： | TIMER LCD PROGRAM 8 DIGIT |
| 标准包装： | 1 |
| 系列： | CUB7 |
| 工作模式： | 累积 |
| 输出类型： | 无 |
| 电源电压： | 不需要（包括电池） |
| 端接类型： | 螺丝端子 |
| 显示器类型： | LCD 无背光 |
| 其它名称： | RLC7T0 |
Bulletin No. CUB7T0-D
Drawing No. LP0648
Released 6/09
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
MODEL CUB7T0 PROGRAMMABLE GENERAL PURPOSE ELECTRONIC TIMER
? 9 PROGRAMMABLE TIMER RANGES
? 3 (8 Digit 0.35") LCD DISPLAY OPTIONS (Reflective, Red
Transmissive, Yellow/Green Transmissive) with “Timer Active”
annunciator
? CONTACT INPUT
? REPLACEABLE INTERNAL LITHIUM BATTERY (provides up to 6
years of uninterrupted operation)
? BOTH FRONT PANEL PROGRAM AND RESET BUTTONS ARE
INDIVIDUALLY ENABLED
? WIRE CONNECTIONS VIA SCREW CLAMP TYPE TERMINALS
? FRONT PANEL AND REMOTE RESET INPUT
? NEMA 4X/IP65 SEALED FRONT BEZEL
DESCRIPTION
The CUB7T0 is an 8-digit miniature programmable timer with large 0.35
inch (8.90 mm) high digits. It has an LCD read-out available in Positive Image
Reflective (CUB7T000), Negative Image Transmissive with yellow/green
backlighting (CUB7T010) or red backlighting (CUB7T020). The backlight
versions require an external 9 to 28 VDC power supply. The display will wrap
around from a full display of “99999999” to “00000000” when an overflow
occurs. An annunciator, located in the upper left hand corner of the display,
blinks at 2 Hz when the signal input is activated. The CUB7T0 operates from
a switch contact or an open collector NPN transistor.
The CUB7T timers use a CMOS LSI chip, mounted on a gold-plated
substrate, that is electrically connected by ultrasonic wire-bonding. Proven
micro-electronic assembly and manufacturing techniques provide these units
with the reliability and dependability required for industrial service.
The CUB7T series is housed in a lightweight, high impact plastic case with
a clear viewing window. The sealed front panel with the silicone rubber buttons
meets NEMA 4X/IP65 specifications for wash-down and/or dusty environments,
when properly installed.
SAFETY SUMMARY
All safety related regulations, local codes and instructions that appear in the
manual or on equipment must be observed to ensure personal safety and to
prevent damage to either the instrument or equipment connected to it. If
equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
Do not use this unit to directly command motors, valves, or other actuators
not equipped with safeguards. To do so, can be potentially harmful to persons
or equipment in the event of a fault to the unit.
CAUTION: Risk of Danger.
Read complete instructions prior to
installation and operation of the unit.
SPECIFICATIONS
1. DISPLAY : 8-digit LCD, 0.35" (8.90 mm) high digits.
2. POWER SOURCE : Replaceable Internal 3.0 V lithium battery to provide up
to 6 years of continuous operation. (Battery life is dependent upon usage.
Contacts that remain closed for long periods of time reduce battery life.)
3. BACKLIGHT POWER REQUIREMENTS: 9 to 28 VDC; 35 mA. typical,
50 mA max. Above 26 VDC, derate max. operating temperature to 40°C.
Must use a NEC Class 2 or SELV rated power supply.
4. ANNUNCIATOR : Annunciator in the upper left corner of the display flashes
at a 2 Hz rate when the signal input is activated.
5. SIGNAL INPUT : (LS terminal #4)
Contact Input (CUB7T0xx) : Switch Contact or solid state Transistor Switch
to Common. Contact burden 15 μ A max. A maintained closed switch to
COM will actuate the timer.
6. REMOTE RESET : 15 msec min. pulse width (active low) from 3.0 V
bipolar output, an open collector transistor, or a switch contact to common.
7. ACCURACY : 0.025%
8. ENVIRONMENTAL CONDITIONS :
Operating Temperature Range : 0 to 50 °C Derate max. operating
temperature to 40 °C above 26 VDC (Backlight versions).
Storage Temperature : -30 to 80 °C
Operating and Storage Humidity : 85% max. relative humidity (non-
condensing) from 0 °C to 50 °C.
Vibration According to IEC 68-2-6: Operational 5 to 500 Hz, in X, Y, Z
direction for 1.5 hours, 5 g’s.
Shock According to IEC 68-2-27: Operational 30 g's, 11 msec in 3 directions.
Altitude : Up to 2000 meters
9. CONNECTIONS : Wire clamping screw terminals.
Wire Strip Length: 0.3" (7.5 mm)
Wire Gage: 30-14 AWG copper wire
Torque: 5 inch-lbs (0.565 N-m) max
10. CERTIFICATIONS AND COMPLIANCES :
SAFETY
Type 4X Indoor Enclosure rating (Face only)
DIMENSIONS In inches (mm)
Note: Recommended minimum clearance (behind the panel) for mounting clip installation is
2.15" (53.4) H x 3.00" (140) W.
0.11 (2.8)
PANEL CUT-OUT
1.77 +0.024
85374216
2.00 (50.8)
1.10 (27.9)
0.10 (2.5)
1.56 (39.6)
0.87 (22.0)
-0.000
-0.0
(45 +0.6 )
-0.000
0.874 +0.012
-0.0
(22.2 +0.3 )
1
相关PDF资料 |
PDF描述 |
|---|---|
| CUB7W020 | COUNTER 8-DIGIT RED BKLT VOLT-IN |
| D-659-0001 | TOOL REMOVAL MTC CONN WAFER |
| D7-1 | DIE, .041 HOLE DIA |
| DH2X61-18A | DIODE FST REC 1800V2X60A SOT227B |
| DHG100X1200NA | DIODE ARRAY 1200V 50A SOT227B |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CUB7T100 | 功能描述:TIMER LCD PROGRAM V IN 8 DIGIT RoHS:是 类别:工业控制，仪表 >> 定时器 系列:CUB7 标准包装:10 系列:- 计时范围:- 工作模式:累积 输出类型:- 电源电压:4.5 V ~ 10 V 端接类型:PCB 引脚 显示器类型:无显示器 其它名称:2001PC-001 5VDCQ1273012Q1443992 |
| CUB7T120 | 制造商:Red Lion Controls 功能描述:ELECTRONIC TIMER VOLTAGE RED LCD |
| CUB7TCG0 | 功能描述:TIMER LCD PROGRAM 8-DIGIT LV GRN RoHS:是 类别:工业控制，仪表 >> 定时器 系列:CUB7 标准包装:10 系列:- 计时范围:- 工作模式:累积 输出类型:- 电源电压:4.5 V ~ 10 V 端接类型:PCB 引脚 显示器类型:无显示器 其它名称:2001PC-001 5VDCQ1273012Q1443992 |
| CUB7TCG1 | 制造商:Red Lion Controls 功能描述:TIMER SOURCE GREEN DISPLAY 8-DIGIT 制造商:Red Lion Controls 功能描述:TIMER LCD GREEN DIS .001S-1H PAN |
| CUB7TCR0 | 功能描述:TIMER LCD PROGRAM 8-DIGIT LV RED RoHS:是 类别:工业控制，仪表 >> 定时器 系列:CUB7 标准包装:10 系列:- 计时范围:- 工作模式:累积 输出类型:- 电源电压:4.5 V ~ 10 V 端接类型:PCB 引脚 显示器类型:无显示器 其它名称:2001PC-001 5VDCQ1273012Q1443992 |
发布紧急采购，3分钟左右您将得到回复。