- 您现在的位置：买卖IC网 > PDF目录237665 > D4C-3533 SNAP ACTING/LIMIT SWITCH, SPDT, MOMENTARY, 0.1A, 30VDC, 4.8mm, PANEL MOUNT PDF资料下载
参数资料
| 型号： | D4C-3533 |
| 元件分类： | 开关 |
| 英文描述： | SNAP ACTING/LIMIT SWITCH, SPDT, MOMENTARY, 0.1A, 30VDC, 4.8mm, PANEL MOUNT |
| 文件页数： | 6/15页 |
| 文件大小： | 1374K |
| 代理商： | D4C-3533 |
14
D4C
Operation
Operation method, shapes of cam and dog, operating frequency,
and overtravel have a significant effect on the service life and
precision of a Limit Switch. For this reason, the dog angle must be
30
° max., the surface roughness of the dog must be 6.3 S min. and
hardness must be Hv 400 to 500.
To allow the plunger-type actuator to travel properly, adjust the dog
and cam to the proper setting positions. The proper position is
where the plunger groove fits the bushing top.
To allow the roller lever-type actuator to travel properly, adjust the
dog and cam so that the arrow head is positioned between the two
convex markers as shown below.
Mounting
A maximum of 6 Switches may be group-mounted. In this case, pay
attention to the mounting direction so that the convex part of the
group-mounting guide on one Switch fits into the concave part of
the guide on the other Switch as shown in the figure below. For
group mounting, the mounting panel must have a thickness (t) of
6 mm min.
If the mounting panel is warped or has protruding parts, a
malfunction may result. Make sure that the mounting panel is not
warped and has even surfaces.
Use a Switch with a rubber cap when using the plunger type in an
environment where malfunction is possible due to environmental
conditions such as dust or cutting chips which may not allow
resetting.
Do not expose the Switch to water exceeding 70°C or use it in
steam.
When the D4C is used in a circuit of a device to be exported to
Europe, classified as Overvoltage Class III as specified in IEC664,
provide a contact protection circuit.
Tighten each screw to a torque according to the following table.
Micro-load Models (D4C-4, -5, -6)
Micro-load models
can be used for
switching in the range
shown below.
2.8 mm
Dog
Bushing top
Groove
2.8 mm
Arrow head
Not correct
Correct
Convex
markers
Not correct
Correct
No.
Type
Appropriate tightening torque*
1
M5 Allen-head bolt
4.90 to 5.88 Nm
2
M3.5 head mounting screw
0.78 to 0.88 Nm
3
M5 Allen-head bolt
4.90 to 5.88 Nm
Group-mounting guide
(Front: convex
Rear: concave)
Mounting panel
16 mm
Group-mounting guide
(Front: convex Rear: concave)
t
Group Mounting
Two, 5.2-dia. or M5 screw holes
25
±0.1
Mounting Holes
* By removing the two screws from
the head, the head direction can
be rotated 180
°. After changing the
head direction, re-tighten to the
torque specified above. Be careful
not to allow any foreign substance
to enter the Switch.
30
24
12
5
0
1
10
100
1,000
0.1
1 mA
26 mA
0.16 mA
800 mW
5 mW
100 mA 160 mA
Switching
range for
micro-load
models
Switching
range for
standard-
load
models
Switching
not possible
in this range
Current (mA)
V
oltage
(V)
相关PDF资料 |
PDF描述 |
|---|---|
| D4N-2122 | SNAP ACTING/LIMIT SWITCH, DPST, MOMENTARY, 2.5A, 250VDC, PANEL MOUNT |
| D4N-2A26 | SNAP ACTING/LIMIT SWITCH, DPST, MOMENTARY, 2.5A, 250VDC, PANEL MOUNT |
| D4N-2E22 | SNAP ACTING/LIMIT SWITCH, DPST, MOMENTARY, 2.5A, 250VDC, PANEL MOUNT |
| D4N-3220 | SNAP ACTING/LIMIT SWITCH, DPST, MOMENTARY, 2.5A, 250VDC, PANEL MOUNT |
| D4N-3ALE | SNAP ACTING/LIMIT SWITCH, DPST, MOMENTARY, 2.5A, 250VDC, PANEL MOUNT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| D4C-4 | 功能描述:旋钮开关 ROTARY SWITCH 5 POSITION RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver |
| D4C4201 | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SWITCH SPDT .1A 125V PIN PLUNGER 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:Switch Limit N.O./N.C. SPDT Top Pin Plunger Cable 0.1A 125VAC 30VDC 11.77N Linear Screw Mount |
| D4C-4201 | 功能描述:限位开关 LS 0.1A 125VAC NOLED PID RoHS:否 制造商:Honeywell 触点形式:SPDT 执行器:Non-Contact 电流额定值:30 mA 电压额定值 AC: 电压额定值 DC:3.6 V 工作力:10 g IP 等级:IP 67 NEMA 额定值:1, 4, 12, 13 端接类型:4-Pin M12 Connector 安装:SMD/SMT |
| D4C4202 | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SWITCH SPDT .1A 125V ROLLR PLNGR 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:Switch Limit N.O./N.C. SPDT Top Roller Plunger Cable 0.1A 125VAC 30VDC 11.77N Linear Screw Mount |
| D4C-4202 | 功能描述:限位开关 L.S. RLLR PLUNG R O.1A RoHS:否 制造商:Honeywell 触点形式:SPDT 执行器:Non-Contact 电流额定值:30 mA 电压额定值 AC: 电压额定值 DC:3.6 V 工作力:10 g IP 等级:IP 67 NEMA 额定值:1, 4, 12, 13 端接类型:4-Pin M12 Connector 安装:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。