- 您现在的位置：买卖IC网 > PDF目录171132 > DFA20E48D12 (POWER-ONE INC) 2-OUTPUT 20 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | DFA20E48D12 |
| 厂商： | POWER-ONE INC |
| 元件分类： | 电源模块 |
| 英文描述： | 2-OUTPUT 20 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | ROHS COMPLIANT PACKAGE-7 |
| 文件页数： | 3/4页 |
| 文件大小： | 109K |
| 代理商： | DFA20E48D12 |
Additional output capacitance may be added for
increased filtering, but should not exceed 400μF.
Remote ON/OFF Operation
The remote ON/OFF pin may be left floating if this
function is not used. It is recommended to drive this pin
with an open collector arrangement or a relay contact.
When the ON/OFF pin is pulled low with respect to the -
INPUT, the converter is placed in a low power drain state.
Output TRIM
The TRIM pin may be used to adjust the output ±5% from
the nominal setting. This function allows adjustment for
voltage drops in the system wiring. Figure 1 shows the
proper connections to use this function. If the TRIM
function is not required, the pin may be left floating.
NOTES
(1) All parameters measured at Tc=25°C, nominal input voltage and
full rated load unless otherwise noted.
(2) Noise measurement bandwidth is 0-20 MHz for peak-peak
measurements, 10 kHz to 1 MHz for RMS measurements. Output
noise is measured with a 1μF tantalum located 1" away from the
converter to simulate PCB standard decoupling. Input reflected
ripple is measured into a 1 μH source impedance.
(3) Load regulation for the outputs is specified as the voltage change
when both outputs are changed from maximum to minimum at the
same time.
(4) Cross regulation is defined as the change in one output when the
other output is changed from full load to 25% of full load. The
converter can be run at no load on either or both outputs with no
damage.
(5) Short term stability is specified after a 30-minute warmup at full
load, constant line and recording the drift over a 24-hour period.
(6) The input ripple rejection is specified for DC to 120 Hz ripple with
a modulation amplitude of 1% of Vin.
DFA20 SERIES APPLICATION NOTES:
External Capacitance Requirements
No external capacitance is required for operation of the
DFA20 Series. The use of input capacitors with less than
0.5V ESR may cause peaking in the input filter and
degrade filter performance. External output capacitance
is not required for operation, however it is recommended
that 1μF to 10μF of tantalum and 0.001 to 0.1μF ceramic
capacitance be selected for reduced system noise.
DFA20 SERIES BLOCK DIAGRAM
4
+ OUTPUT
SHIELDED ISOLATION TRANSFORMER
+
6
– OUTPUT
5
CMN
7
TRIM
SHIELDED COPPER CASE
+
–
2
– INPUT
ON/OFF
1
3
+ INPUT
CURRENT
MODE
PWM
THERMAL LIMIT
LOW
NOISE
FILTER
50
0
5
10
15
20
60
70
80
90
100
OUTPUT POWER DERATING
AMBIENT TEMPERATURE
POWER
OUTPUT
4
+OUT
7
TRIM
10K
LOAD
USING TRIMPOT
6
-OUT
4
+OUT
7
TRIM
DOWN
TRIM
UP
LOAD
USING FIXED RESISTORS
6
-OUT
Figure 1.
DFA20 Dual-Output DC-DC Series Data Sheet
MCD10174 Rev. 1.0, 15-Jun-10
Page 3 of 4
www.power-one.com
相关PDF资料 |
PDF描述 |
|---|---|
| DFC15U48S15 | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| DFC21R89P020LHCA | 1890 MHz, CERAMIC BPF |
| DFC21R89P020LHC | 1890 MHz, CERAMIC BPF |
| DFC22R45P100LHA | 2450 MHz, CERAMIC BPF |
| DFC2R886P002HHA | 886 MHz, CERAMIC BPF |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DFA20E48D15 | 功能描述:CONVERTER DC-DC 20W 48V/15V DUAL RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:DFA20 设计资源:Maxi/Mini/Micro Design Guide, Appl Manual 标准包装:1 系列:Maxi 类型:隔离 输出数:1 电压 - 输入（最小）:36V 电压 - 输入（最大）:75V Voltage - Output 1:28V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:500W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:模块 尺寸/尺寸:4.60" L x 2.20" W x 0.62" H（116.8mm x 55.9mm x 15.7mm） 包装:散装 工作温度:-55°C ~ 100°C 效率:* 电源（瓦特）- 最大:* |
| DFA20E48D5 | 功能描述:CONVERTER DC-DC 20W 48V/5V DUAL RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:DFA20 设计资源:Maxi/Mini/Micro Design Guide, Appl Manual 标准包装:1 系列:Maxi 类型:隔离 输出数:1 电压 - 输入（最小）:36V 电压 - 输入（最大）:75V Voltage - Output 1:28V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:500W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:模块 尺寸/尺寸:4.60" L x 2.20" W x 0.62" H（116.8mm x 55.9mm x 15.7mm） 包装:散装 工作温度:-55°C ~ 100°C 效率:* 电源（瓦特）- 最大:* |
| DFA20E48S12 | 功能描述:CONVERTER DC-DC 20W 48V/12V SGL RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:DFA20 设计资源:Maxi/Mini/Micro Design Guide, Appl Manual 标准包装:1 系列:Maxi 类型:隔离 输出数:1 电压 - 输入（最小）:36V 电压 - 输入（最大）:75V Voltage - Output 1:28V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:500W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:模块 尺寸/尺寸:4.60" L x 2.20" W x 0.62" H（116.8mm x 55.9mm x 15.7mm） 包装:散装 工作温度:-55°C ~ 100°C 效率:* 电源（瓦特）- 最大:* |
| DFA20E48S15 | 功能描述:CONVERTER DC-DC 20W 48V/15V SGL RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:DFA20 设计资源:Maxi/Mini/Micro Design Guide, Appl Manual 标准包装:1 系列:Maxi 类型:隔离 输出数:1 电压 - 输入（最小）:36V 电压 - 输入（最大）:75V Voltage - Output 1:28V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:500W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:模块 尺寸/尺寸:4.60" L x 2.20" W x 0.62" H（116.8mm x 55.9mm x 15.7mm） 包装:散装 工作温度:-55°C ~ 100°C 效率:* 电源（瓦特）- 最大:* |
发布紧急采购，3分钟左右您将得到回复。