- 您现在的位置：买卖IC网 > PDF目录18721 > DR-TRC105-315-DK (RFM)DEV KIT TRC105 PDF资料下载
参数资料
| 型号： | DR-TRC105-315-DK |
| 厂商： | RFM |
| 文件页数： | 6/22页 |
| 文件大小： | 0K |
| 描述： | DEV KIT TRC105 |
| 标准包装： | 1 |
| 类型： | 收发器 |
| 频率： | 310MHz ~ 319.5MHz |
| 适用于相关产品： | TRC105 |
| 已供物品： | 2 个板，天线，电池，线缆，CD，电源适配器 |
| 产品目录页面： | 583 (CN2011-ZH PDF) |
| 其它名称： | 583-1152 |
Figure 5 - USB and RS232 Serial Connection Options
Initial Kit Testing Using the Range Test Function
1. Install the antennas and then the 9 volt batteries in both board sets. No PC
connection is required for the range test function.
2. Turn on the board sets by sliding the Power switch on the interface board to the
ON position. All LED ’ s on the radio board will flash and the MODE LED will be
green.
3. See Figure 6 below. On one board, briefly press and release the RANGE button.
The RANGE LED will illuminate continuously. This is the “ receiving ” board.
4. On the other board, press and hold the RANGE button until the LED ’ s begin
flashing. This board is the “ transmitting ” board.
5. If the radios are receiving good packets, then the green Good Packet LEDs will
be flashing alternately on each board (plus various yellow LEDs). Figure 10
details the locations of the LEDs.
6. To verify that the radio boards are operating properly, disable the receiving board
by pressing and releasing the RANGE button twice. The RANGE LED will turn
off. On the transmitting board, you should observe the red Packet Error LED
flashing. This indicates that the transmitter sent a packet but did not receive an
acknowledgment back from the “ receiving ” radio board.
Frequency Hopping Spread Spectrum Range Test Function
The 902-928 MHz kit can also be range tested in frequency hopping spread spectrum
(FHSS) mode. On each board, press the MODE button four times. After the forth press,
the MODE LED will illuminate green-yellow. Then on one board, briefly press and
release the RANGE button. The RANGE LED will illuminate continuously. This is the
“ receiving ” board. On the other board, press and hold the RANGE button until the LED ’ s
begin flashing. This board is the “ transmitting ” board.
www.RFM.com
?2009-2010 by RF Monolithics, Inc.
Technical support +1.800.704.6079
E-mail: info@rfm.com
Page 6 of 22
DR-TRC103-DK - 04/05/10
相关PDF资料 |
PDF描述 |
|---|---|
| TC25N6C32K7680 | OSCILLATOR 32.7680 KHZ 2.5V SMD |
| 82-2 BRN | CLAMP WIRE INSUL PIERCING BRN |
| DR-TRC105-304-DK | DEV KIT TRC105 |
| DR-TRC105-390-DK | DEV KIT TRC105 |
| PM113-622.08M | OSC 622.0800 MHZ 3.3V LVPECL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DR-TRC105-315-EV | 功能描述:射频开发工具 TRC105 Evaluation Board 310-319 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-345-DK | 功能描述:射频开发工具 TRC105 Development Kit 342-348 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-345-EV | 功能描述:射频开发工具 TRC105 Evaluation Board 342-348 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-372-DK | 功能描述:射频开发工具 TRC105 Development Kit 365-381 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| DR-TRC105-372-EV | 功能描述:射频开发工具 TRC105 Evaluation Board 365-381 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
发布紧急采购，3分钟左右您将得到回复。