参数资料
型号: DS1338U-3+T&R
厂商: Maxim Integrated Products
文件页数: 11/16页
文件大小: 0K
描述: IC RTC 56BYTE NV RAM 3V 8-USOP
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 3,000
类型: 时钟/日历
特点: 闰年,NVSRAM,方波输出
存储容量: 56B
时间格式: HH:MM:SS(12/24 小时)
数据格式: YY-MM-DD-dd
接口: I²C,2 线串口
电源电压: 2.7 V ~ 5.5 V
电压 - 电源,电池: 1.3 V ~ 3.7 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
供应商设备封装: 8-uMAX
包装: 带卷 (TR)
DS1338 I2C RTC with 56-Byte NV RAM
4 of 16
POWER-UP/POWER-DOWN CHARACTERISTICS
(TA = -40°C to +85°C) (Note 1, Figure 1)
PARAMETER
SYMBOL
MIN
TYP
MAX
UNITS
Recovery at Power-Up (Note 15)
tREC
2
ms
VCC Fall Time; VPF(MAX) to VPF(MIN)
tVCCF
300
s
VCC Rise Time; VPF(MIN) to VPF(MAX)
tVCCR
0
s
Warning: Negative undershoots below -0.3V while the part is in battery-backed mode may cause
loss of data.
Note 1:
Limits at -40°C are guaranteed by design and not production tested.
Note 2:
All voltages are referenced to ground.
Note 3:
SCL only.
Note 4:
SDA and SQW/OUT.
Note 5:
ICCA—SCL clocking at max frequency = 400kHz.
Note 6:
Specified with the I2C bus inactive.
Note 7:
Measured with a 32.768kHz crystal attached to X1 and X2.
Note 8:
After this period, the first clock pulse is generated.
Note 9:
A device must internally provide a hold time of at least 300ns for the SDA signal (referred to the VIH(MIN) of the SCL signal) to
bridge the undefined region of the falling edge of SCL.
Note 10:
The maximum tHD:DAT need only be met if the device does not stretch the LOW period (tLOW) of the SCL signal.
Note 11:
A fast-mode device can be used in a standard-mode system, but the requirement tSU:DAT ≥ to 250ns must then be met. This is
automatically the case if the device does not stretch the LOW period of the SCL signal. If such a device does stretch the LOW
period of the SCL signal, it must output the next data bit to the SDA line tR(MAX) + tSU:DAT = 1000 + 250 = 1250ns before the SCL line
is released.
Note 12:
CB—total capacitance of one bus line in pF.
Note 13:
Guaranteed by design. Not production tested.
Note 14:
The parameter tOSF is the time period the oscillator must be stopped for the OSF flag to be set over the voltage range of
0.0V ≤ VCC ≤ VCC(MAX) and 1.3V ≤ VBAT ≤ 3.7V.
Note 15:
This delay applies only if the oscillator is enabled and running. If the oscillator is disabled or stopped, no power-up delay occurs.
Figure 1. Power-Up/Power-Down Timing
OUTPUTS
VCC
VPF(MAX)
VPF(MIN)
INPUTS
HIGH-Z
DON'T CARE
VALID
RECOGNIZED
VALID
tVCCF
tVCCR
tREC
相关PDF资料
PDF描述
VI-J6T-MZ CONVERTER MOD DC/DC 6.5V 25W
VI-J6N-MZ CONVERTER MOD DC/DC 18.5V 25W
VE-26B-MW CONVERTER MOD DC/DC 95V 100W
DS1338U-33+T&R IC RTC 56BYTE NV RAM 3.3V 8-USOP
DS1340U-33+T&R IC RTC I2C W/CHARGER 3.3V 8-USOP
相关代理商/技术参数
参数描述
DS1338UA-33+ 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1338UA-33+T&R 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1338Z-18 功能描述:实时时钟 I2C Serial RTC w/56 Byte NV RAM RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1338Z-18+ 功能描述:实时时钟 I2C Serial RTC w/56 Byte NV RAM RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1338Z-18+T&R 制造商:Maxim Integrated Products 功能描述:SERIAL RTC 1.8 VOLT 8P SOIC T&R LFR - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC RTC 56BYTE NV RAM 1.8V 8-SOIC 制造商:Maxim Integrated Products 功能描述:Real Time Clock 1.8V Serial RTC