- 您现在的位置：买卖IC网 > PDF目录1993 > DS1371U+C01 (Maxim Integrated Products)IC BINARY COUNTER 32-BIT 8-USOP PDF资料下载
参数资料
| 型号： | DS1371U+C01 |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 3/15页 |
| 文件大小： | 0K |
| 描述： | IC BINARY COUNTER 32-BIT 8-USOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| 类型： | 二进制计数器 |
| 特点： | 警报器，方波输出，监视计时器 |
| 时间格式： | 二进制 |
| 数据格式： | 二进制 |
| 接口： | I²C，2 线串口 |
| 电源电压： | 1.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-uMAX |
| 包装： | 管件 |
DS1371
11 of 15
Status Register (08h)
Bit #
7
6
5
4
3
2
1
0
Name
OSF
0
AF
Default
1
0
—
Bit 7: Oscillator Stop Flag (OSF). A logic 1 in this bit indicates that the oscillator either is stopped or
was stopped for some period and can be used to judge the validity of the timekeeping data. This bit is set
to logic 1 any time that the oscillator stops. The following are examples of conditions that can cause the
OSF bit to be set:
The first time power is applied.
The voltage present on VCC is insufficient to support oscillation.
The EOSC bit is turned off.
External influences on the crystal (e.g., noise, leakage, etc.)
This bit remains at logic 1 until written to logic 0.
Bit 0: Alarm Flag (AF). A logic 1 in the AF bit indicates that the WD/
ALM counter reached 0. If
INTCN is set to a 1, and WD/
ALM is set to 0 and AIE is set to 1, the SQW/INT pin goes low and stays
low until AF is cleared. AF is cleared when written to logic 0. This bit can only be written to logic 0.
Attempting to write logic 1 leaves the value unchanged. If INTCN and WD/
ALM are set to 1 and the AIE
is set to 1, the SQW/
INT pin pulses low for 250ms when the WD/ALM counter reaches 0 and sets AF =
1. At the completion of the 250ms pulse, the DS1371 clears the AF bit to a 0. If the 250ms pulse is active,
writing AF to a 0 does not truncate the pulse.
I
2C Serial Interface
The DS1371 supports a bidirectional I2C bus and data transmission protocol. A device that sends data
onto the bus is defined as a transmitter and a device receiving data as a receiver. The device that controls
the message is called a “master.” The devices that are controlled by the master are “slaves.” The bus must
be controlled by a master device that generates the serial clock (SCL), controls the bus access, and
generates the START and STOP conditions. The DS1371 operates as a slave on the I2C bus. Within the
I2C bus specifications a standard mode (100kHz clock rate) and a fast mode (400kHz clock rate) are
defined. The DS1371 works in both modes. Connections to the bus are made through the open-drain I/O
lines SDA and SCL.
The following bus protocol has been defined (Figure 4):
Data transfer can be initiated only when the bus is not busy.
During data transfer, the data line must remain stable whenever the clock line is HIGH. Changes in
the data line while the clock line is high are interpreted as control signals.
Accordingly, the following bus conditions have been defined:
Bus not busy: Both data and clock lines remain HIGH.
Start data transfer: A change in the state of the data line from high to low, while the clock line is
high, defines a START condition.
Stop data transfer: A change in the state of the data line from low to high, while the clock line is
high, defines a STOP condition.
相关PDF资料 |
PDF描述 |
|---|---|
| DS1372U+T&R | IC BINARY COUNTER 32-BIT 8-USOP |
| DS1374C-3# | IC RTC I2C W/CHARGER 16-SOIC |
| DS1375T+ | IC RTC SERIAL W/ALARM 6-TDFN |
| DS1384FP-12+ | IC CTRLR RTC WDOG 120NS 44-MQFP |
| DS1386P-8-120+ | IC TIMEKEEPER RAM 64K 34-PCM |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS1372 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:I2C, 32-Bit, Binary Counter Clock with 64-Bit ID |
| DS1372U+ | 功能描述:实时时钟 I2C 32 bit Binary Counter w/64 Bit ID RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS1372U+T&R | 制造商:Maxim Integrated Products 功能描述:RTC W/SERIAL NUMBER - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC BINARY COUNTER 32-BIT 8-USOP |
| DS1372U+T&R | 功能描述:实时时钟 I2C 32 bit Binary Counter w/64 Bit ID RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS1374 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:I2C, 32-Bit Binary Counter Watchdog RTC with Trickle Charger and Reset Input/Output |
发布紧急采购，3分钟左右您将得到回复。