- 您现在的位置：买卖IC网 > PDF目录9059 > DS1669-50 (Maxim Integrated Products)IC RHEOSTAT DALLASTAT 50K 8-DIP PDF资料下载
参数资料
| 型号： | DS1669-50 |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 2/11页 |
| 文件大小： | 0K |
| 描述： | IC RHEOSTAT DALLASTAT 50K 8-DIP |
| 标准包装： | 50 |
| 系列： | Dallastat™ |
| 接片： | 64 |
| 电阻（欧姆）： | 50k |
| 电路数： | 1 |
| 温度系数： | 标准值 750 ppm/°C |
| 存储器类型： | 非易失 |
| 接口： | 上/下 |
| 电源电压： | ±4.5 V ~ 8 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
DS1669
10 of 10
NOTES:
1. All inputs; UV, DC, and D are internally pulled up with a resistance of 100k.
2. Input logic levels are referenced to -V.
3. ICC is the internal current that flows between -V and +V.
4. Input leakage applies to contact inputs UC and DC and digital input (D).
5. Wiper current and rheostat currents are the maximum currents which can flow in the resistive
elements.
6. Capacitance values apply at 25°C.
7. Input pulse width is the minimum time required for an input to cause an increment or decrement. If
the UC, DC or D input is held active for longer than 1 second, subsequent increments or decrements
will occur on 100 ms intervals until the inputs UC, DC, and/or D is released to VIH.
8. Repetitive pulsed inputs on UC, DC, or D will be recognized as long as the pulse repetition occurs
within 1 second of each other. Pulses occurring faster than 1 ms apart may not be recognized as
individual inputs but can be interpreted a constant input.
9. Idle state supply current is measured with no pushbutton depressed and with the wiper. RW tied to a
CMOS load.
10. Maximum time required for the Dallastat to determine single or dual pushbutton operation after input
supply has reached 10% of recommended supply operating conditions.
11. Absolute linearity is used to determine wiper voltage versus expected voltage as determined by wiper
position.
12. Relative linearity is used to determine the change in voltage between successive tap positions.
13. -3 dB cutoff frequency characteristics for the DS1669 depend on potentiometer total resistance:
DS1669-010; 1 MHz, DS1669-050; 200 kHz, DS1669-100; 100 kHz.
14. Valid at 25
°C only.
相关PDF资料 |
PDF描述 |
|---|---|
| DS1802 | IC POT DL AUDIO TAP W/PB 20-DIP |
| DS1669S-100 | IC RHEOSTAT DALLASTAT 100K 8SOIC |
| DS1807E | IC POT ADDRESS 2X AUDIO 14-TSSOP |
| M83723/87R2461N | CONN PLUG 61POS STRAIGHT W/PINS |
| GTC00CF-20-19S | CONN RCPT 3POS WALL MNT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS1669-50+ | 功能描述:数字电位计 IC Dallastat 50K Rheostat RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| DS1669E-50/T&R/ | 功能描述:数字电位计 IC RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| DS1669N-10 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Digital Potentiometer |
| DS1669N-100 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Digital Potentiometer |
| DS1669N-50 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Digital Potentiometer |
发布紧急采购，3分钟左右您将得到回复。