- 您现在的位置：买卖IC网 > PDF目录9173 > DS1801E-014+T&R (Maxim Integrated Products)IC POT DUAL AUDIO TAPER 14-TSSOP PDF资料下载
参数资料
| 型号： | DS1801E-014+T&R |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 6/10页 |
| 文件大小： | 0K |
| 描述： | IC POT DUAL AUDIO TAPER 14-TSSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1,000 |
| 接片： | 64 |
| 电阻（欧姆）： | 45k |
| 电路数： | 2 |
| 温度系数： | 标准值 750 ppm/°C |
| 存储器类型： | 易失 |
| 接口： | 3 线串口 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 14-TSSOP |
| 包装： | 带卷 (TR) |
DS1801
5 of 10
CASCADE OPERATION
A feature of the DS1801 is the ability to control multiple devices from a single processor. Multiple
DS1801s can be linked or daisy-chained as shown in Figure 4. As a data bit is entered into the I/O shift
register of the DS1801, bit 0 of the I/O shift register will appear at the COUT output after a maximum delay
of 50 nanoseconds.
The COUT output of the DS1801 can be used to drive the D input of another DS1801. When connecting
multiple devices, the total number of bits sent is always 16 times the number of DS1801s in the daisy
chain.
An optional feedback resistor can be placed between the C OUT terminal of the last device and the D input
of the first DS1801 thus allowing the controlling processor to read as well as write data or circularly
clock data through the daisy chain. The value of the feedback or isolation resistor should be in the range
from 2 to 10 kohms.
When reading data via the COUTpin and isolation resistor, the D line is left floating by the reading device.
When RST is driven high, bit 0 is present on the COUT pin, which is fed back to the input D pin through
the isolation resistor. When the CLK input transitions low to high, bit 0 is loaded into the first position of
the I/O shift register and bit 1 becomes present on COUT and D of the next device. After 16 bits (or 16
times the number of DS1801s in the daisy chain), the data has shifted completely around and back to its
original position. When RST transitions to the low state to end data transfer, the value (the same as before
the read occurred) is loaded into wiper-0 and wiper-1.
CASCADING MULTIPLE DEVICES Figure 4
Zero-Crossing Detection
The DS1801 provides a zero-crossing detection capability that minimizes any audible noise that may
result from sizable discrete wiper transitions when using the part in audio applications. The zero-crossing
detect feature allows independent wiper changes only when the two terminals of the potentiometer have
equal potentials and are within a 50 ms time window from the fall of the RST signal. If at 50 ms the
DS1801 has not detected a zero-crossing, the wiper position of the potentiometer(s) will change
regardless of the state of the input signal. Zero-crossing detection is activated when the ZCEN input level
is in a low-state. When high, the ZCEN input deactivates both the 50 ms time requirement and zero
detection crossing.
相关PDF资料 |
PDF描述 |
|---|---|
| 7WBD3306AMUTCG | TRANSLATOR 2BIT FST BUS SW 8UDFN |
| 7WBD3305USG | TRANSLATOR 2BIT FST BUS SW US8 |
| 7WBD3126USG | TRANSLATOR 2BIT BUS SW US8 |
| 7WBD3126AMUTCG | TRANSLATOR 2BIT BUS SW 8UDFN |
| GTC00A-20-7S | CONN RCPT 8POS WALL MNT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS1801EN | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Interface IC |
| DS1801N | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Interface IC |
| DS1801S | 功能描述:数字电位计 IC Dual Audio Taper Potentiometer RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| DS1801S/T&R | 制造商:Maxim Integrated Products 功能描述:DUAL AUDIO POT SOIC 16 T/R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC POT DUAL AUDIO TAPER 16-SOIC |
| DS1801S/T&R | 功能描述:数字电位计 IC RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。