- 您现在的位置：买卖IC网 > PDF目录97867 > DS2180AN (MAXIM INTEGRATED PRODUCTS INC) DATACOM, FRAMER, PDIP40 PDF资料下载
参数资料
| 型号： | DS2180AN |
| 厂商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分类： | Digital Transmission Controller |
| 英文描述： | DATACOM, FRAMER, PDIP40 |
| 封装： | 0.600 INCH, DIP-40 |
| 文件页数： | 23/35页 |
| 文件大小： | 481K |
| 代理商： | DS2180AN |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页当前第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页
DS2180A
3 of 35
TRANSMIT PIN DESCRIPTION (40-PIN DIP ONLY) Table 1
PIN
SYMBOL
TYPE
DESCRIPTION
1
TMSYNC
I
Transmit Multiframe Sync. May be pulsed high at multiframe boundaries to
reinforce multiframe alignment or tied low, which allows internal multiframe
counter to free run.
2
TFSYNC
I
Transmit Frame Sync. Rising edge identifies frame boundary; may be pulsed
every frame to reinforce internal frame counter or tied low (allowing TMSYNC to
establish frame and multiframe alignment).
3TCLK
I
Transmit Clock. 1.544 MHz primary clock.
4
TCHCLK
O
Transmit Channel Clock. 192 kHz clock which identifies time slot (channel)
boundaries. Useful for parallel-to-serial conversion of channel data.
5TSER
I
Transmit Serial Data. NRZ data input, sample on falling edge of TCLK.
6TMO
O
Transmit Multiframe Out. Output of internal multiframe counter indicates
multiframe boundaries. 50% duty cycle.
7TSIGSEL
O
Transmit Signaling Select. .667 kHz clock which identifies signaling frame A and
C in 193E framing. 1.33 kHz clock in 193S.
8TSIGFR
O
Transmit Signaling Frame. High during signaling frames, low otherwise.
9TABCD
I
Transmit ABCD Signaling. When enabled via TCR.4, sampled during channel
LSB time in signaling frames on falling edge of TCLK.
10
TLINK
I
Transmit Link Data. Sampled during the F-bit time (falling edge of TCLK) of odd
frames for insertion into the outgoing data stream (193E-FDL insertion). Sampled
during the F-bit time of even frames for insertion into the outgoing data (193S-
External S-Bit insertion).
11
TLCLK
O
Transmit Link Clock. 4 kHz demand clock for TLINK input.
12
13
TPOS
TNEG
O
Transmit Bipolar Data Outputs. Updated on rising edge of TCLK.
PORT PIN DESCRIPTION (40-PIN DIP ONLY) Table 2
PIN
SYMBOL
TYPE
DESCRIPTION
14
INT
1
O
Receive Alarm Interrupt.
Flags host controller during alarm conditions. Active
low, open drain output.
15
SDI
1
I
Serial Data In.
Data for onboard registers. Sampled on rising edge of SCLK.
16
SDO
1
O
Serial Data Out.
Control and status information from onboard registers. Updated
on falling edge of SCLK, tri-stated during serial port write or when CS is high.
17
CS
1
I
Chip Select.
Must be low to write or read the serial port registers.
18
SCLK
1
I
Serial Data Clock.
Used to write or read the serial port registers.
19
SPS
I
Serial Port Select.
Tie to VDD to select serial port. Tie to VSS to select hardware
mode.
NOTE:
1. Multifunction pins. See “Hardware Mode Description."
相关PDF资料 |
PDF描述 |
|---|---|
| DS2181AN | DATACOM, FRAMER, PDIP40 |
| DS2181AQN | DATACOM, FRAMER, PQCC44 |
| DS2181A | DATACOM, FRAMER, PDIP40 |
| DS2181AQ | DATACOM, FRAMER, PQCC44 |
| DS2182A | DATACOM, FRAMER, PDIP28 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2180AQ | 功能描述:网络控制器与处理器 IC RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| DS2180AQ/T&R | 制造商:Maxim Integrated Products 功能描述:T1 TRANSCEIVER-PLCC-TRL - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC TRANSCEIVER T1 44-PLCC 制造商:Maxim Integrated Products 功能描述:Network Controller & Processor ICs T1 Transceiver |
| DS2180AQ/T&R+ | 制造商:Maxim Integrated Products 功能描述:T1 TRANSCEIVER PLCC TRL LF - Tape and Reel |
| DS2180AQ/T&R | 功能描述:网络控制器与处理器 IC T1 Transceiver RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| DS2180AQ+ | 功能描述:网络控制器与处理器 IC T1 Transceiver RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。