- 您现在的位置：买卖IC网 > PDF目录378591 > DS2480S Serial 1.Wire Line Driver PDF资料下载
参数资料
| 型号： | DS2480S |
| 英文描述： | Serial 1.Wire Line Driver |
| 中文描述： | 串行1.Wire线驱动器 |
| 文件页数： | 2/26页 |
| 文件大小： | 185K |
| 代理商： | DS2480S |
DS2480
042498 2/26
DETAILED PIN DESCRIPTION
PIN
SYMBOL
DESCRIPTION
1
GND
Ground Pin:
common ground reference and ground return for 1–Wire bus
2
1–W
1–Wire Input/Output Pin:
1–Wire bus with slew–rate–controlled pull–down,
active pull–up, ability to switch in V
PP
to program EPROM, and ability to switch
in V
through a low–impedance path to program EEPROM, perform a temper-
ature conversion or operate the Crypto iButton.
3
NC
No Connection Pin.
Power Input Pin:
power supply for the chip and 1–Wire pull–up voltage. 5V
±
10%; may be derived from 12V V
PP
with an external voltage regulator.
4
V
DD
5
V
PP
EPROM Programming Voltage:
12V supply input for EPROM programming;
if EPROM programming is not required, this pin must be tied to V
DD
. V
PP
must
come up before V
DD
.
RXD/TXD Polarity Select:
RXD/TXD polarity select; tied to GND for RS232
(12V or 5V) connection, tied to V
DD
for direct connection to UART chip.
Serial Data from UART:
data input from host (inverted or true); maximum volt-
age swing –0.3V to V
DD
+ 0.3V; for logic thresholds see DC specifications.
Serial Data to UART:
signal output to host; push–pull driver with CMOS com-
patible levels; for true
±
12V RS232 systems an external level–translator must
be provided.
6
POL
7
TXD
8
RXD
OVERVIEW
The DS2480 directly interfaces a 5V serial communica-
tion port with its lines TXD (transmit) and RXD (receive)
to a 1–Wire bus. In addition the device performs a speed
conversion allowing the data rate at the communication
port to be different from the 1–Wire date rate. Several
parameters relating to the 1–Wire port and its timing as
well as the communication speed at both the port and
the 1–Wire bus are configurable. The circuit to achieve
these functions is outlined in Figure 1, Block Diagram.
The device gets its input data from the serial commu-
nication port of the host computer through pin TXD. For
compatibility with active–high as well as active–low sys-
tems, the incoming signal can be inverted by means of
the polarity input POL. The polarity chosen by hard–wir-
ing the logic level of this pin is also valid for the output pin
RXD. If for minimizing the interface hardware an asym-
metry between RXD and TXD is desired, this can be
achieved by setting the most significant bit of the Speed
Control parameter to a 1 (see Configuration Parameter
Value Codes). With the MS bit of the speed control set to
1, the polarity at TXD is still selected by the logic level at
POL, but the polarity at RXD will be the opposite of what
the logic level at POL specifies.
As data enters the core of the DS2480’s logic circuitry, it
is analyzed to separate data and command bytes and to
calibrate the device’s timing generator. The timing gen-
erator controls all speed relations of the communication
interface and the 1–Wire bus as well as the wave forms
on the 1–Wire bus.
Command bytes either affect the configuration setting
or generate certain wave forms on the 1–Wire bus. Data
bytes are simply translated by the protocol converter
into the appropriate 1–Wire activities. Each data byte
generates a return byte from the 1–Wire bus, that is
communicated back to the host through the RXD pin as
soon as the activity on the 1–Wire bus is completed.
The 1–Wire driver shapes the slopes of the 1–Wire
wave forms, applies programming pulses or strong
pull–up to 5 volts and reads the 1–Wire bus using a non–
TTL threshold to maximize the noise margin for best
performance on large 1–Wire MicroLAN networks.
相关PDF资料 |
PDF描述 |
|---|---|
| DS2490 | USB to 1-Wire Bridge Chip |
| DS2490S | USB to 1-Wire Bridge Chip |
| DS2502-E64 | IEEE EUI-64 Node Address Chip |
| DS26334 | 3.3V, 16-Channel, E1/T1/J1 Short and Long-Haul Line Interface Unit |
| DS26334G | 3.3V, 16-Channel, E1/T1/J1 Short and Long-Haul Line Interface Unit |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2482-100 | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:Single-Channel 1-Wire Master |
| DS2482-100_12 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Single-Channel 1-Wire Master |
| DS2482-101 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Single-Channel 1-Wire Master with Sleep Mode |
| DS2482-101_12 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Single-Channel 1-Wire Master with Sleep Mode |
| DS2482-800 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:8-Channel 1-Wire Master |
发布紧急采购，3分钟左右您将得到回复。