- 您现在的位置：买卖IC网 > PDF目录16211 > DS2777G+ (Maxim Integrated Products)IC FUEL GAUGE LI+ 2CELL 14-TDFN PDF资料下载
参数资料
| 型号： | DS2777G+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 17/46页 |
| 文件大小： | 0K |
| 描述： | IC FUEL GAUGE LI+ 2CELL 14-TDFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 60 |
| 功能： | 燃料，电量检测计/监控器 |
| 电池化学： | 锂离子（Li-Ion）、锂聚合物（Li-Pol） |
| 电源电压： | 4 V ~ 9.2 V |
| 工作温度： | -20°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-WFDFN 裸露焊盘 |
| 供应商设备封装： | 14-TDFN-EP（3x5） |
| 包装： | 管件 |
| 产品目录页面： | 1436 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页
2-Cell, Stand-Alone, Li+ Fuel-Gauge IC with
Protector and Optional SHA-1 Authentication
FRSGAIN value is provided to preserve the factory cali-
bration value only and is not used to calibrate the current
measurement. The 16-bit FRSGAIN value is readable
from addresses B0h and B1h.
Sense-Resistor Temperature
Compensation
The DS2775–DS2778 can temperature compensate the
current-sense resistor to correct for variation in a sense
resistor’s value over temperature. The DS2775–DS2778
are factory programmed with the sense-resistor temper-
ature coefficient, RSTC, set to zero, which turns off the
temperature compensation function. RSTC is user
accessible and can be reprogrammed after module or
pack manufacture to improve the current accuracy
when using a high-temperature coefficient current-
sense resistor. RSTC is an 8-bit value stored in the
parameter EEPROM memory block. The RSTC value
sets the temperature coefficient from 0 to +7782ppm/°C
in steps of 30.5ppm/°C. The user must program RSTC
cautiously to ensure accurate current measurement.
Temperature compensation adjustments are made when
the Temperature register crosses 0.5°C boundaries. The
temperature compensation is most effective with the
resistor placed as close as possible to the V SS terminal
to optimize thermal coupling of the resistor to the on-chip
temperature sensor. If the current shunt is constructed
with a copper PCB trace, run the trace under the
DS2775–DS2778 package whenever possible.
Current Accumulation
Current measurements are internally summed, or accu-
mulated, at the completion of each conversion period
MSB—ADDRESS 10h
with the results displayed in the Accumulated Current
register (ACR). The accuracy of the ACR is dependent
on both the current measurement and the conversion
time base. The ACR has a range of 0 to +409.6mVh
with an LSb of 6.25μVh. Additional registers hold frac-
tional results of each accumulation to avoid truncation
errors. The fractional result bits are not user accessible.
Accumulation of charge current above the maximum
register value is reported at the maximum value; con-
versely, accumulation of discharge current below the
minimum register value is reported at the minimum
value.
Charge currents (positive Current register values) less
than 100μV are not accumulated in order to mask the
effect of accumulating small positive offset errors over
long periods. This effect limits the minimum charge cur-
rent, for coulomb counting purposes, to 5mA for R SNS
= 0.020 Ω and 20mA for R SNS = 0.005 Ω (see Table 2 for
more details).
Read and write access is allowed to the ACR. The
ACR must be written most significant byte (MSB) first,
then LSB. Whenever the ACR is written, the fractional
accumulation result bits are cleared. The write must
be completed in 3.5s. A write to the ACR forces the
ADC to perform an offset correction conversion and
update the internal offset correction factor. The cur-
rent measurement and accumulation begin with the
second conversion following a write to the ACR. To
preserve the ACR value in case of power loss, the
ACR value is backed up to EEPROM. The ACR value
is recovered from EEPROM on power-up. See the
Memory Map for specific address location and back-
up frequency.
LSB—ADDRESS 11h
2 15
2 14
2 13
2 12
2 11
2 10
2 9
2 8
2 7
2 6
2 5
2 4
2 3
2 2
2 1
2 0
MSb
LSb
MSb
LSb
UNITS: 6.25 μV/R SNS
Figure 10. Accumulated Current Register Format
Table 2. Resolution and Range vs. Sense Resistor
TYPE OF RESOLUTION/RANGE
Current Resolution
Current Range
ACR Resolution
ACR Range
V SS - V SNS
1.5625μV
±51.2mV
6.25 μVh
±409.6mVh
20m
78.13 μA
±2.56A
312.5 μAh
±20.48Ah
15m
104.2 μA
±3.41A
416.7 μAh
±27.30Ah
R SNS
10m
156.3 μA
±5.12A
625 μAh
±40.96Ah
5m
312.5 μA
±10.2A
1.250mAh
±81.92Ah
______________________________________________________________________________________
17
相关PDF资料 |
PDF描述 |
|---|---|
| NR3010T6R8M | INDUCTOR WOUND 6.8UH .61A SMD |
| EEM43DRSH | CONN EDGECARD 86POS DIP .156 SLD |
| M3UYK-2020K | IDC CABLE - MKS20K/MC20F/MPD20K |
| MAX1757EAI+ | IC BATTERY CHRG LI+ 28-SSOP |
| A3DKB-4006M | IDC CABLE - AKR40B/AE40M/APK40B |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2777G+ | 功能描述:电池管理 2-Cell Stand-Alone Li+ Fuel-Gauge RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| DS2777G+T&R | 制造商:Maxim Integrated Products 功能描述: 制造商:Maxim Integrated Products 功能描述:2S FG PROT 2W 14L 3X5 TDFN T&R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC FUEL GAUGE LI+ 2CELL 14-TDFN 制造商:Maxim Integrated Products 功能描述:Battery Management 2-Cell Stand-Alone Li+ Fuel-Gauge |
| DS2777G+T&R | 功能描述:电池管理 2-Cell Stand-Alone Li+ Fuel-Gauge RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel |
| DS2777G+TR | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:2-Cell, Stand-Alone, Li+ Fuel-Gauge IC with Protector and Optional SHA-1 Authentication |
| DS2777GR | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:2-Cell, Stand-Alone, Li+ Fuel-Gauge IC with Protector and Optional SHA-1 Authentication |
发布紧急采购，3分钟左右您将得到回复。