- 您现在的位置：买卖IC网 > PDF目录16240 > DS2780E+ (Maxim Integrated Products)IC FUEL GAUGE BATT 8TSSOP PDF资料下载
参数资料
| 型号： | DS2780E+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 23/31页 |
| 文件大小： | 0K |
| 描述： | IC FUEL GAUGE BATT 8TSSOP |
| 产品培训模块： | 1-Wire Communications Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 100 |
| 功能： | 燃料，电量检测计/监控器 |
| 电池化学： | 锂离子（Li-Ion）、锂聚合物（Li-Pol） |
| 电源电压： | 2.5 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 管件 |
| 产品目录页面： | 1436 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页当前第23页第24页第25页第26页第27页第28页第29页第30页第31页
DS2780 Standalone Fuel Gauge IC
Application Note 27, Understanding and Using Cyclic Redundancy Checks with Dallas Semiconductor Touch
Memory Products . (This application note can be found on the Maxim/Dallas Semiconductor website at
www.maxim-ic.com.)
In the circuit in Figure 19, the shift register bits are initialized to 0. Then, starting with the least significant bit of the
family code, one bit at a time is shifted in. After the 8th bit of the family code has been entered, then the serial
number is entered. After the 48th bit of the serial number has been entered, the shift register contains the CRC
value.
Figure 19. 1-Wire CRC Generation Block Diagram
INPUT
MSb
XOR
XOR
LSb
XOR
HARDWARE CONFIGURATION
Because the 1-Wire bus has only a single line, it is important that each device on the bus be able to drive it at the
appropriate time. To facilitate this, each device attached to the 1-Wire bus must connect to the bus with open-drain
or tri-state output drivers. The DS2780 uses an open-drain output driver as part of the bidirectional interface
circuitry shown in Figure 20. If a bidirectional pin is not available on the bus master, separate output and input pins
can be connected together.
The 1-Wire bus must have a pullup resistor at the bus-master end of the bus. For short line lengths, the value of
this resistor should be approximately 5k ? . The idle state for the 1-Wire bus is high. If, for any reason, a bus
transaction must be suspended, the bus must be left in the idle state to properly resume the transaction later. If the
bus is left low for more than 120 ? s (16 ? s for overdrive speed), slave devices on the bus begin to interpret the low
period as a reset pulse, effectively terminating the transaction.
The DS2780 can operate in two communication speed modes, standard and overdrive. The speed mode is
determined by the input logic level of the OVD pin; a logic 0 selects standard speed and a logic 1 selects overdrive
speed. The OVD pin must be at a stable logic level of 0 or 1 before initializing a transaction with a reset pulse. All
1-Wire devices on a multinode bus must operate at the same communication speed for proper operation. 1-Wire
timing for both standard and overdrive speeds are listed in the Electrical Characteristics: 1-Wire Interface tables.
Figure 20. 1-Wire Bus Interface Circuitry
BUS MASTER
Rx
Vpullup
(2.0V to 5.5V)
4.7k ?
DS2780 1-WIRE PORT
RX
Tx
RX = RECEIVE
TX = TRANSMIT
23 of 31
0.2 ? A
(typ)
100 ?
MOSFET
TX
相关PDF资料 |
PDF描述 |
|---|---|
| M1KXK-3036R | IDC CABLE - MPK30K/MC34M/X |
| RBM08DSEF-S13 | CONN EDGECARD 16POS .156 EXTEND |
| RCM22DCBS | CONN EDGECARD 44POS R/A .156 SLD |
| RCA18DTMS | CONN EDGECARD 36POS R/A .125 SLD |
| RSA10DTKS | CONN EDGECARD 20POS DIP .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2780E/R | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Stand-Alone Fuel Gauge IC |
| DS2780E/T | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Stand-Alone Fuel Gauge IC |
| DS2780E/T&R | 制造商:Maxim Integrated Products 功能描述:STANDALONG FUELD CAUGE TSSOP T&R - Tape and Reel |
| DS2780E/T&R | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Stand-Alone Fuel Gauge IC |
| DS2780E/TR | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Standalone Fuel Gauge IC |
发布紧急采购，3分钟左右您将得到回复。