- 您现在的位置：买卖IC网 > PDF目录1915 > DS2890P-000+T&R (Maxim Integrated Products)IC POT DIGITAL 1-WIRE 100K 6TSOC PDF资料下载
参数资料
| 型号： | DS2890P-000+T&R |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 5/27页 |
| 文件大小： | 0K |
| 描述： | IC POT DIGITAL 1-WIRE 100K 6TSOC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 4,000 |
| 接片： | 256 |
| 电阻（欧姆）： | 100k |
| 电路数： | 1 |
| 温度系数： | 标准值 800 ppm/°C |
| 存储器类型： | 易失 |
| 接口： | 1 线 串行 |
| 电源电压： | 2.8 V ~ 6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-LSOJ |
| 供应商设备封装： | 6-TSOC |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
DS2890
13 of 27
1-WIRE BUS SYSTEM
The 1-Wire bus is a system, which has a single bus master and one or more slaves. In all instances the
DS2890 is a slave device. The bus master is typically a microcontroller. The discussion of this bus system
is broken down into three topics: hardware configuration, transaction sequence, and 1-Wire signaling
(signal types and timing). The 1-Wire protocol defines bus transactions in terms of the bus state during
specific time slots that are initiated on the falling edge of sync pulses from the bus master.
HARDWARE CONFIGURATION
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain or 3-state outputs. The 1-Wire port of the DS2890 is open drain with an internal circuit equivalent
to that shown in Figure 9. A multi-drop bus consists of a 1-Wire bus with multiple slaves attached. At
regular speed the 1-Wire bus has a maximum data rate of 16.3 kbits per second. The speed can be boosted
to 142 kbits per second by activating the Overdrive Mode. For a discrete bus master interface as in
Figure 14, the 1-Wire bus requires a pull-up resistor with a minimum value of 2.2 k
Ω. Depending on
1-Wire communication speed, regular or overdrive, and bus load characteristics, the optimal pull-up
resistor value will be in the 1.5 k
Ω to 5 kΩ range. Figure 15 shows a DS2480B bus master configuration
with an interface to the host CPU serial port. Among many features, the DS2480B simplifies the 1-Wire
interface design, generates slew-rate controlled 1-Wire waveforms, and off-loads 1-Wire timing
generation overhead required in a discrete solution.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
MUST be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 16 s (Overdrive Speed) or more than 120 s (regular speed), one or more devices on the
bus may be reset.
FIGURE 14. HARDWARE CONFIGURATION
RX
TX
Open Drain
Port Pin
5 A
Typ.
DS2890 1-WIRE PORT
RX = RECEIVE
TX = TRANSMIT
BUS MASTER
VPUP
DATA
RX
TX
MOSFET
100
Ω
See
Text
NOTE:
Depending on 1-Wire communication speed, regular or overdrive, and bus load characteristics, the
optimal pull-up resistor value will be in the 1.5 k
Ω to 5 kΩ range.
相关PDF资料 |
PDF描述 |
|---|---|
| DS28CM00R-A00+T | IC SILICON SERIAL NUMBER SOT23-5 |
| DS30EA101SQE/NOPB | IC CABLE EQUALIZER 16LLP |
| DS3120N | IC FRAMER T1 28-CHANNEL IND |
| DS31256+ | IC CTRLR HDLC 256-CHANNEL 256BGA |
| DS3141+ | IC FRAMER DS3/E3 SNGL 144CSBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2890T | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:1-Wire Digital Potentiometer |
| DS2890T-000 | 功能描述:数字电位计 IC RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| DS2890V | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:1-Wire Digital Potentiometer |
| DS2890V-000 | 功能描述:数字电位计 IC RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| DS2890X | 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:1-Wire Digital Potentiometer |
发布紧急采购，3分钟左右您将得到回复。