- 您现在的位置：买卖IC网 > PDF目录97870 > DS80CH11 (DALLAS SEMICONDUCTOR) 8-BIT, MICROCONTROLLER, PQFP128 PDF资料下载
参数资料
| 型号： | DS80CH11 |
| 厂商： | DALLAS SEMICONDUCTOR |
| 元件分类： | Microcontroller |
| 英文描述： | 8-BIT, MICROCONTROLLER, PQFP128 |
| 封装： | TQFP-128 |
| 文件页数： | 66/88页 |
| 文件大小： | 598K |
| 代理商： | DS80CH11 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页当前第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页
DS80CH11
011200 69/88
amplifier by setting the XTOFF bit (PMR.3) to a 1. This
can only be done when XT/RG = 0.
When changing the clock source, the selection will take
effect after a one instruction cycle delay. This applies to
changes from crystal to ring and vise versa. However,
this assumes that the crystal amplifier is running. In
most cases, when the ring is active, software previously
disabled the crystal to save power. If ring operation is
being used and the system must switch to crystal opera-
tion, the crystal must first be enabled. Set the XTOFF bit
to a 0. At this time, the crystal oscillation will begin. The
SEM then provides a warm–up delay to make certain
that the frequency is stable. Hardware will set the
XTUP bit (STATUS.4) to a 1 when the crystal is ready for
use. Then software should write XT/RG to a 1 to begin
operating from the crystal. Hardware prevents writing
XT/RG to a 1 before XTUP = 1. The delay between
XTOFF = 0 and XTUP = 1 will be 65,536 crystal clocks.
Switchback has no effect on the clock source. If soft-
ware selects a reduced clock divider and enables the
ring, a Switchback will only restore the divider speed.
The ring will remain as the time base until altered by soft-
ware.
If there is serial activity, Switchback usually
occurs with enough time to create proper baud rates.
This is not true if the crystal is off and the CPU is running
from the ring. If sending a serial character that wakes
the system from crystaless Slow Clock Mode, then it
should be a dummy character of no importance with a
subsequent delay for crystal startup.
The flow chart in Figure 12–1 illustrates a typical deci-
sion set associated with Slow Clock Mode.
相关PDF资料 |
PDF描述 |
|---|---|
| DS83C530-ENL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQFP52 |
| DS87C530-ECL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQFP52 |
| DS87C520-MCL | 8-BIT, OTPROM, MICROCONTROLLER, PDIP40 |
| DS87C520-QNL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQCC44 |
| DS87C520-QCL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQCC44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS80CH11+E02 | 制造商:Maxim from Components Direct 功能描述:MAXIM DS80CH11+E02 SYSTEM ENERGY MANAGERS - Trays 制造商:Maxim 功能描述:Maxim DS80CH11+E02 System Energy Managers |
| DS80CH11-E02 | 制造商:Maxim from Components Direct 功能描述:MAXIM DS80CH11-E02 SYSTEM ENERGY MANAGERS - Trays 制造商:Maxim 功能描述:Maxim DS80CH11-E02 System Energy Managers |
| DS80E100 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:5 to 12.5 Gbps, Power-Saver Equalizer for Backplanes and Cables |
| DS80EP100 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:5 to 12.5 Gbps, Power-Saver Equalizer for Backplanes and Cables |
| DS80EP100_08 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:5 to 12.5 Gbps, Power-Saver Equalizer for Backplanes and Cables |
发布紧急采购，3分钟左右您将得到回复。