参数资料
型号: DS87C520-ECL
厂商: MAXIM INTEGRATED PRODUCTS INC
元件分类: Microcontroller
英文描述: 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQFP44
封装: 10 X 10 MM, 1 MM HEIGHT, TQFP-44
文件页数: 17/43页
文件大小: 709K
代理商: DS87C520-ECL
DS87C520/DS83C520 EPROM/ROM High-Speed Microcontrollers
24 of 43
will set an interrupt flag. Regardless of whether the user enables this interrupt, there are then 512 clocks
left until the reset flag is set. Software can enable the interrupt and reset individually. Note that the
Watchdog is a free running timer and does not require an enable.
There are 5 control bits in special function registers that affect the Watchdog Timer and two status flags
that report to the user. WDIF (WDCON.3) is the interrupt flag that is set at timer termination when there
are 512 clocks remaining until the reset flag is set. WTRF (WDCON.2) is the flag that is set when the
timer has completely timed out. This flag is normally associated with a CPU reset and allows software to
determine the reset source.
EWT (WDCON.1) is the enable for the Watchdog timer reset function. RWT (WDCON.0) is the bit that
software uses to restart the Watchdog Timer. Setting this bit restarts the timer for another full interval.
Application software must set this bit before the timeout. Both of these bits are protected by Timed
Access. As mentioned previously, WD1 and 0 (CKCON .7 and 6) select the timeout. The Reset
Watchdog Timer bit (WDCON.0) should be asserted prior to modifying the Watchdog Timer Mode
Select bits (WD1, WD0) to avoid corruption of the watchdog count. Finally, the user can enable the
Watchdog Interrupt using EWDI (EIE.4). The Special Function Register map is shown above.
INTERRUPTS
The DS87C520/DS83C520 provide 13 interrupt sources with three priority levels. The Power-Fail
Interrupt (PFI) has the highest priority. Software can assign high or low priority to other sources. All
interrupts that are new to the 8051 family, except for the PFI, have a lower natural priority than the
originals.
Table 8. Interrupt Sources and Priorities
NAME
FUNCTION
VECTOR
NATURAL
PRIORITY
8051/DALLAS
PFI
Power-Fail Interrupt
33h
1
DALLAS
INT0
External Interrupt 0
03h
2
8051
TF0
Timer 0
0Bh
3
8051
INT1
External Interrupt 1
13h
4
8051
TF1
Timer 1
1Bh
5
8051
SCON0
TI0 or RI0 from serial port 0
23h
6
8051
TF2
Timer 2
2Bh
7
8051
SCON1
TI1 or RI1 from serial port 1
3Bh
8
DALLAS
INT2
External Interrupt 2
43h
9
DALLAS
INT3
External Interrupt 3
4Bh
10
DALLAS
INT4
External Interrupt 4
53h
11
DALLAS
INT5
External Interrupt 5
5Bh
12
DALLAS
WDTI
Watchdog Timeout Interrupt
63h
13
DALLAS
相关PDF资料
PDF描述
DS87C520-MNL 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PDIP40
DS87C520-ENL 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQFP44
DS87C520-WCL 8-BIT, UVPROM, 33 MHz, MICROCONTROLLER, CDIP40
DS87C530-ENL 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQFP52
DS87C530-QCL 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQCC52
相关代理商/技术参数
参数描述
DS87C520-ECL+ 功能描述:8位微控制器 -MCU EPROM/ROM High-Speed RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
DS87C520-ENL 功能描述:8位微控制器 -MCU EPROM/ROM High-Speed RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
DS87C520-ENL+ 功能描述:8位微控制器 -MCU EPROM/ROM High-Speed RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
DS87C520-FCL 制造商:未知厂家 制造商全称:未知厂家 功能描述:8-Bit Microcontroller
DS87C520MCL 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:EPROM/ROM High-Speed Microcontrollers