参数资料
型号: DSP56857BUE
厂商: Freescale Semiconductor
文件页数: 44/53页
文件大小: 0K
描述: IC DSP 16BIT 120MHZ 100-LQFP
标准包装: 90
系列: 568xx
核心处理器: 56800E
芯体尺寸: 16-位
速度: 120MHz
连通性: SCI,SPI,SSI
外围设备: DMA,POR,WDT
输入/输出数: 47
程序存储器容量: 80KB(40K x 16)
程序存储器类型: SRAM
RAM 容量: 24K x 16
电压 - 电源 (Vcc/Vdd): 1.62 V ~ 1.98 V
振荡器型: 外部
工作温度: -40°C ~ 85°C
封装/外壳: 100-LQFP
包装: 托盘
Electrical Design Considerations
56857 Technical Data, Rev. 6
Freescale Semiconductor
49
As noted above, the junction-to-case thermal resistances quoted in this data sheet are determined using the
first definition. From a practical standpoint, that value is also suitable for determining the junction
temperature from a case thermocouple reading in forced convection environments. In natural convection,
using the junction-to-case thermal resistance to estimate junction temperature from a thermocouple
reading on the case of the package will estimate a junction temperature slightly hotter than actual. Hence,
the new thermal metric, Thermal Characterization Parameter, or
ΨJT, has been defined to be (TJ – TT)/PD.
This value gives a better estimate of the junction temperature in natural convection when using the surface
temperature of the package. Remember that surface temperature readings of packages are subject to
significant errors caused by inadequate attachment of the sensor to the surface and to errors caused by heat
loss to the sensor. The recommended technique is to attach a 40-gauge thermocouple wire and bead to the
top center of the package with thermally conductive epoxy.
6.2 Electrical Design Considerations
Use the following list of considerations to assure correct operation:
Provide a low-impedance path from the board power supply to each VDD pin on the controller, and from the
board ground to each VSS (GND) pin.
The minimum bypass requirement is to place six 0.01–0.1
μF capacitors positioned as close as possible to
the package supply pins. The recommended bypass configuration is to place one bypass capacitor on each
of the ten VDD/VSS pairs, including VDDA/VSSA.
Ensure that capacitor leads and associated printed circuit traces that connect to the chip VDD and VSS (GND)
pins are less than 0.5 inch per capacitor lead.
Use at least a four-layer Printed Circuit Board (PCB) with two inner layers for VDD and GND.
Bypass the VDD and GND layers of the PCB with approximately 100 μF, preferably with a high-grade
capacitor such as a tantalum capacitor.
Because the device’s output signals have fast rise and fall times, PCB trace lengths should be minimal.
Consider all device loads as well as parasitic capacitance due to PCB traces when calculating capacitance.
This is especially critical in systems with higher capacitive loads that could create higher transient currents
in the VDD and GND circuits.
All inputs must be terminated (i.e., not allowed to float) using CMOS levels.
CAUTION
This device contains protective circuitry to guard against
damage due to high static voltage or electrical fields.
However, normal precautions are advised to avoid
application of any voltages higher than maximum rated
voltages to this high-impedance circuit. Reliability of
operation is enhanced if unused inputs are tied to an
appropriate voltage level.
相关PDF资料
PDF描述
DSP56858FVE IC DSP 16BIT 120MHZ 144-LQFP
DSP56F801FA80E IC DSP 60MHZ 16KB FLASH 48-LQFP
DSP56F802TA80E IC DSP 60MHZ 16KB FLASH 32-LQFP
DSP56F803BU80E IC DSP 80MHZ 64KB FLASH 100LQFP
DSP56F805FV80E IC DSP 80MHZ 64KB FLASH 144LQFP
相关代理商/技术参数
参数描述
DSP56857E 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers
DSP56857PB 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:120 MIPS Hybrid Processor
DSP56858 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers
DSP56858E 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers
DSP56858EVM 制造商:Freescale Semiconductor 功能描述:Microprocessor Support IC For Use With:D