参数资料
型号: EE-SPX743
元件分类: 开关
英文描述: 3.6 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH LOGIC OUTPUT
文件页数: 6/6页
文件大小: 281K
代理商: EE-SPX743
EE-SPX74/84
EE-SPX74/84
J MOUNTING
Be sure to mount the Sensor securely to flat plates. The
characteristics of the Through-beam Sensor change if the slot is
deformed.
Use M3.0 screws when mounting the EE-SPX. Be sure to use
spring washers with the screws so that the screws will not
loosen. The tightening torque applied to each screw must be no
more than 0.59 N
S m (6 kgf S cm).
Make sure that nothing will come into contact with the sensing
element of the Sensor. If the sensing element has scratch
damage, the characteristics of the Sensor will decrease.
Make sure that the EE-SPX is securely mounted and not
loosened by vibration or shock.
J WIRING
Countermeasures Against Surge
If the power supply has surge voltage, connect a Zener diode
withstanding 30 to 35 V or 0.1 to 1-
F capacitor in parallel to the
power supply to absorb the surge voltage.
ZD: Zener diode
0.1 to 1
F
If the load is a relay or other small inductive load, connect the
load to the EE-SPX as shown below. Be sure to connect a diode
for counter-voltage absorption.
Relay
+V
0 V
Do not wire power lines or high-tension lines alongside the lines
of the EE-SPX in the same conduit, otherwise the EE-SPX may
be damaged or malfunction due to induction. Be sure to wire the
lines of the EE-SPX separately from power lines or high-tension
lines or lay them in an exclusive, shielded conduit.
J ENVIRONMENT
Do not wire the EE-SPX while power is applied, or the EE-SPX
may be damaged.
To avoid damage or malfunction, do not install the EE-SPX in the
following locations:
Locations with excessive dust
Locations with corrosive gas
Locations where water, oil, or chemical is directly sprayed
Outdoors or locations exposed to direct sunlight
Make sure that the ambient operating temperature is within the
rated range.
The Sensor may be soluble in organic solvent, acid, and alkaline,
aromatic hydrocarbon, and chlorinated aliphatic hydrocarbon
solvents. The characteristics of the Sensor may decrease as a
result, so make sure that the Sensor is free from these solutions.
Cat. No. E309–E3–1
7/00/2.5M
Specifications subject to change without notice.
Printed in U.S.A.
OMRON ELECTRONICS, INC.
One East Commerce Drive
Schaumburg, IL 60173
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
1-800-55-OMRON
OMRON CANADA, INC.
885 Milner Avenue
Scarborough, Ontario M1B 5V8
416-286-6465
R
相关PDF资料
PDF描述
EE-SV3-CS 3.4 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH TRANSISTOR OUTPUT
EE-SV3-D 3.4 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH TRANSISTOR OUTPUT
EE-SX2088-W1 3.4 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH DARLINGTON OUTPUT
EE-SX672R 5 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH LOGIC OUTPUT
EE-SX673A 5 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH LOGIC OUTPUT
相关代理商/技术参数
参数描述
EESPX840 制造商:OMRON AUTOMATION AND SAFETY 功能描述:OPTO SENSOR SLOT TYPE NPN LT-ON 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:3.6mmSLOT PMS NPN L-ON CONNCTR
EE-SPX840 功能描述:光学开关(透射型,光电晶体管输出) 3.6MM SLOT PMS NPN L-ON RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装:
EESPX841 制造商:OMRON AUTOMATION AND SAFETY 功能描述:OPTO SENSOR SLOT TYPE NPN LT-ON 制造商:Omron Electronic Components LLC 功能描述:Photointerrupter Transmissive 5mm Photologic, Open Collector 3-Pin 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:5mmSLOT PMS NPN L-ON CONNECTOR
EE-SPX841 功能描述:光学开关(透射型,光电晶体管输出) 5MM SLOT PMS NPN L-ON RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装:
EESPX842 制造商:OMRON AUTOMATION AND SAFETY 功能描述:OPTO SENSOR SLOT TYPE NPN LT-ON 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:3.6mmSLOT PMS NPN L-ON CONNCTR