参数资料
| 型号： | EHE004 |
| 厂商： | Mide Technology Corporation |
| 文件页数： | 14/24页 |
| 文件大小： | 0K |
| 描述： | BOARD ENERGY HARVESTING |
| 产品培训模块： | EHE004 Piezoelectric Energy Harvesting Conditioning Circuit |
| 特色产品： | Energy Harvesting Power Products |
| 标准包装： | 1 |
| 系列： | Volture™ |
| 主要目的： | 电源管理，能量收集 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | LTC3588 |
| 主要属性： | 用户可选择的输出电压 |
| 次要属性： | 最多 100mA 输出 |
| 已供物品： | 板 |
APPLICATIONS INFORMATION - SWITCHED CAPACITOR BOOST CIRCUIT
Switched Capacitor Boost Circuit for One-
Shot Sensors and Low Vibration Levels
It is often difficult to make use of low-voltage energy
scavenging sources, such as piezo energy harvesters
at low vibration amplitudes, solar cells in overcast or
indoor environments, or Seebeck devices, etc., as
most microcontrollers and sensors require minimum
voltages of 1.8V or greater to operate. Using these
sources requires a voltage boost converter with a
minimum start-up voltage, low start-up current
requirement, and graceful handling of undervoltage and
slow input voltage rise times.
The circuit shown, based on the Seiko Epson S-882Z
series charge pump IC, provides bursts of power
starting at approximately 2.4VDC (ending at 1.6-2
VDC) from input voltages as low as approximately
380mV. This IC provides boosting using small on-chip
switched (“flying”) capacitors, rather than inductive
boost conversion. Thus the initial input current
requirements are reduced compared to a typical boost
conver ter, requiring only a small power-supply
bypass capacitance to reliably start up. The circuit
can begin operating almost immediately when power
becomes available. This circuit is ideal for directly
powering small sensors that can perform their
function (e.g. record or transmit a measurement) in a
known amount of time and power. It could also be
used to extend battery life, or as a trigger source for
devices with their own battery/supercap power
source.
When the voltage at VIN exceeds the minimum start-up
voltage, the IC begins pumping charge to a storage
capacitor connected across the CPOUT pin. When the
capacitor voltage reaches 2.4V, the output is enabled
and this voltage is applied to the load. The load is
automatically disconnected when the storage capacitor
voltage drops below approx. 1.8V (see Figure 6). This
behavior allows the circuit to directly power most 3.3V
microcontroller circuits, with a typical operating voltage
range of 1.8V ~ 3.6V, without exposing the circuit to
significant undervoltage or unfavorable voltage rise-
time conditions.
S-882Z
Piezo Bimorph
J3
D1
VH
4
5
VIN
CPOUT
VM
GND
VOUT
3
2
1
X1
X2
1
BAT54STA
C1
10uF
U1
VCC
QPXX_RA
GND
D2
GND
C3
100uF
GND
REVISION N0. 002
REVISION DATE: 01-23-2013
14
相关PDF资料 |
PDF描述 |
|---|---|
| EHFW2BPKG | CONN EEE1394 FMALE T/H BLK 4-40 |
| EHFWX2X | CONN FIREWIRE FEEDTHROUGH |
| EHHD15FF | CONN DSUB 15PIN FMAL-FMAL NICKEL |
| EHLC2M | CONN FIBER OPTIC LC/LC MULT MODE |
| EHSC2M | CONN FIBER OPTIC ST2 DUAL MODE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EHEA 1PR | 制造商:Nexans 功能描述:CABLE SCRN 1CORE 7/0.2MM 100M 制造商:NEXANS 功能描述:CABLE, SCRN, 1CORE, 7/0.2MM, 100M 制造商:Nexans 功能描述:SHLD MULTICOND CABLE, 1COND, 24AWG, 328FT, 250V; Reel Length (Imperial):328ft; Reel Length (Metric):100m; No. of Conductors:1; Conductor Size AWG:24AWG; Voltage Rating:250V; No. of Strands x Strand Size:7 x 0.2mm; Cable Type:Shielded;RoHS Compliant: Yes |
| EHEA 2PR BLACK | 制造商:Nexans 功能描述: |
| EHEALTH-GW-SDK | 制造商:Bluegiga Technologies Inc 功能描述:EHEALTH SOFTWARE DEVELOPMENT KIT (SDK) LICENSE* |
| EHF-103-01-F-D | 制造商:Samtec Inc 功能描述:.050 EJECTOR HEADER ASSEMBLY - Bulk |
| EHF-10301-F-D-RA | 制造商:SAMTEC 制造商全称:Samtec, Inc 功能描述:.050 EJECTOR HEADER ASSEMBLY |
发布紧急采购，3分钟左右您将得到回复。