参数资料
型号: EK-V6-ML605-G-J
厂商: Xilinx Inc
文件页数: 8/11页
文件大小: 0K
描述: VIRTEX-6 FAGAN ML605 EVAL KIT
产品培训模块: Virtex-6 FPGA Overview
标准包装: 1
系列: Virtex® 6
类型: FPGA
适用于相关产品: Virtex? 6 LXT,XC6VLX240T
所含物品: 板,适配器,线缆,文档,软件 - 不包括电源 -
Virtex-6 Family Overview
DS150 (v2.4) January 19, 2012
Product Specification
6
Block RAM
Every Virtex-6 FPGA has between 156 and 1064 dual-port block RAMs, each storing 36 Kbits. Each block RAM has two
completely independent ports that share nothing but the stored data.
Synchronous Operation
Each memory access, read and write, is controlled by the clock. All inputs, data, address, clock enables, and write enables
are registered. Nothing happens without a clock. The input address is always clocked, retaining data until the next operation.
An optional output data pipeline register allows higher clock rates at the cost of an extra cycle of latency.
During a write operation, the data output can reflect either the previously stored data, the newly written data, or remain
unchanged.
Programmable Data Width
Each port can be configured as 32K × 1, 16K × 2, 8K × 4, 4K × 9 (or 8), 2K × 18 (or 16), 1K × 36 (or 32), or 512 x 72
(or 64). The two ports can have different aspect ratios, without any constraints.
Each block RAM can be divided into two completely independent 18 Kb block RAMs that can each be configured to any
aspect ratio from 16K x 1 to 512 x 36. Everything described previously for the full 36 Kb block RAM also applies to each
of the smaller 18 Kb block RAMs.
In 18 Kb block RAMs, only simple dual-port mode can provide data width of >36 bits. In this mode, one port is
dedicated to read and the other port is dedicated to write operation. In SDP mode one side (read or write) can be
variable while the other is fixed to 32/36 or 64/72. There is no read output during write. The dual-port 36 Kb RAM both
sides can be of variable width.
Two adjacent 36 Kb block RAMs can be configured as one cascaded 64K × 1 dual-port RAM without any additional
logic.
Error Detection and Correction
Each 64 bit-wide block RAM can generate, store, and utilize eight additional Hamming-code bits, and perform single-bit error
correction and double-bit error detection (ECC) during the read process. The ECC logic can also be used when writing to,
or reading from external 64/72-wide memories. This works in simple dual-port mode and does not support read-during-write.
FIFO Controller
The built-in FIFO controller for single-clock (synchronous) or dual-clock (asynchronous or multirate) operation increments
the internal addresses and provides four handshaking flags: full, empty, almost full, and almost empty. The almost full and
almost empty flags are freely programmable. Similar to the block RAM, the FIFO width and depth are programmable, but the
write and read ports always have identical width. First-word fall-through mode presents the first-written word on the data
output even before the first read operation. After the first word has been read, there is no difference between this mode and
the standard mode.
Digital Signal Processing—DSP48E1 Slice
DSP applications use many binary multipliers and accumulators, best implemented in dedicated DSP slices. All Virtex-6
FPGAs have many dedicated, full-custom, low-power DSP slices combining high speed with small size, while retaining
system design flexibility.
Each DSP48E1 slice fundamentally consists of a dedicated 25 × 18 bit two's complement multiplier and a 48-bit
accumulator, both capable of operating at 600 MHz. The multiplier can be dynamically bypassed, and two 48-bit inputs can
feed a single-instruction-multiple-data (SIMD) arithmetic unit (dual 24-bit add/subtract/accumulate or quad 12-bit
add/subtract/accumulate), or a logic unit that can generate any one of 10 different logic functions of the two operands.
The DSP48E1 includes an additional pre-adder, typically used in symmetrical filters. This new pre-adder improves
performance in densely packed designs and reduces the logic slice count by up to 50%.
The DSP48E1 slice provides extensive pipelining and extension capabilities that enhance speed and efficiency of many
applications, even beyond digital signal processing, such as wide dynamic bus shifters, memory address generators, wide
bus multiplexers, and memory-mapped I/O register files. The accumulator can also be used as a synchronous up/down
counter. The multiplier can perform logic functions (AND, OR) and barrel shifting.
相关PDF资料
PDF描述
VE-J60-EZ CONVERTER MOD DC/DC 5V 25W
FPF2300MX IC LOAD SW 2CH RESTART 8-SOP
SDR-A SCOTCH CODE REFILL A
RCC25DCMN CONN EDGECARD 50POS .100 WW
AP2171FMG-7 IC PWR SW USB 1CH 1.0A LOW 6DFN
相关代理商/技术参数
参数描述
EK-V6-ML630-G 功能描述:VIRTEX-6 HXT FPGA ML630 EVAL KIT RoHS:是 类别:编程器,开发系统 >> 通用嵌入式开发板和套件(MCU、DSP、FPGA、CPLD等) 系列:Virtex® 6 HXT 标准包装:1 系列:PICDEM™ 类型:MCU 适用于相关产品:PIC10F206,PIC16F690,PIC16F819 所含物品:板,线缆,元件,CD,PICkit 编程器 产品目录页面:659 (CN2011-ZH PDF)
EK-V6-ML630-G-J 功能描述:VIRTEX-6 HXT FPGA ML630 EVAL KIT RoHS:是 类别:编程器,开发系统 >> 通用嵌入式开发板和套件(MCU、DSP、FPGA、CPLD等) 系列:Virtex® 6 HXT 标准包装:1 系列:PICDEM™ 类型:MCU 适用于相关产品:PIC10F206,PIC16F690,PIC16F819 所含物品:板,线缆,元件,CD,PICkit 编程器 产品目录页面:659 (CN2011-ZH PDF)
EK-V6-ML631-G 功能描述:VIRTEX-6 HXT FPGA ML631 EVAL KIT RoHS:是 类别:编程器,开发系统 >> 通用嵌入式开发板和套件(MCU、DSP、FPGA、CPLD等) 系列:Virtex® 6 HXT 标准包装:1 系列:PICDEM™ 类型:MCU 适用于相关产品:PIC10F206,PIC16F690,PIC16F819 所含物品:板,线缆,元件,CD,PICkit 编程器 产品目录页面:659 (CN2011-ZH PDF)
EK-V6-ML631-G-J 功能描述:VIRTEX-6 HXT FPGA ML631 EVAL KIT RoHS:是 类别:编程器,开发系统 >> 通用嵌入式开发板和套件(MCU、DSP、FPGA、CPLD等) 系列:Virtex® 6 HXT 标准包装:1 系列:PICDEM™ 类型:MCU 适用于相关产品:PIC10F206,PIC16F690,PIC16F819 所含物品:板,线缆,元件,CD,PICkit 编程器 产品目录页面:659 (CN2011-ZH PDF)
EK-V7-VC707-CES-G 功能描述:VIRTEX-7 VC707 EVAL KIT RoHS:是 类别:编程器,开发系统 >> 通用嵌入式开发板和套件(MCU、DSP、FPGA、CPLD等) 系列:Virtex®-7 标准包装:1 系列:PICDEM™ 类型:MCU 适用于相关产品:PIC10F206,PIC16F690,PIC16F819 所含物品:板,线缆,元件,CD,PICkit 编程器 产品目录页面:659 (CN2011-ZH PDF)