参数资料
| 型号： | EL5177IY |
| 厂商： | Intersil |
| 文件页数： | 12/12页 |
| 文件大小： | 0K |
| 描述： | IC DRVR DIFF 550MHZ TP 10-MSOP |
| 标准包装： | 50 |
| 放大器类型： | 差分 |
| 电路数： | 1 |
| 输出类型： | 差分 |
| 转换速率： | 1100 V/µs |
| 增益带宽积： | 200MHz |
| -3db带宽： | 550MHz |
| 电流 - 输入偏压： | 14µA |
| 电压 - 输入偏移： | 1400µV |
| 电流 - 电源： | 12.5mA |
| 电流 - 输出 / 通道： | 50mA |
| 电压 - 电源，单路/双路(±)： | 4.75 V ~ 11 V，±2.38 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-MSOP |
| 包装： | 管件 |
EL5177
9
FN7344.6
August 28, 2012
Simplified Schematic
Description of Operation and
Application Information
Product Description
The EL5177 is a wide bandwidth, low power and
single/differential ended to differential output amplifier. It can
be used as single/differential ended to differential converter.
The EL5177 is internally compensated for closed loop gain of
+1 or greater. Connected in gain of 1 and driving a 1k
Ω
differential load, the EL5177 has a -3dB bandwidth of
550MHz. Driving a 200
Ω differential load at gain of 2, the
bandwidth is about 130MHz. The EL5177 is available with a
power-down feature to reduce the power while the amplifier is
disabled.
Input, Output, and Supply Voltage Range
The EL5177 has been designed to operate with a single supply
voltage of 5V to 10V or a split supplies with its total voltage
from 5V to 10V. The amplifiers have an input common mode
voltage range from -4.3V to 3.4V for ±5V supply. The
differential mode input range (DMIR) between the two inputs
is from -2.3V to +2.3V. The input voltage range at the REF pin is
from -3.3V to 3.7V. If the input common mode or differential
mode signal is outside the above-specified ranges, it will cause
the output signal to become distorted.
The output of the EL5177 can swing from -3.8V to +3.8V at a
1k
Ω differential load at ±5V supply. As the load resistance
becomes lower, the output swing is reduced.
Differential and Common Mode Gain
Settings
The voltage applied at REF pin can set the output common
mode voltage and the gain is one. The differential gain is set
by the RF and RG network.
The gain setting for EL5177 is expressed in Equation 1:
Where:
RF1 = RF2 = RF
FIGURE 23.
Choice of Feedback Resistor and Gain
Bandwidth Product
For applications that require a gain of +1, no feedback resistor is
required. Just short the OUT+ pin to FBP pin and OUT- pin to FBN
pin. For gains greater than +1, the feedback resistor forms a pole
with the parasitic capacitance at the inverting input. As this pole
becomes smaller, the amplifier's phase margin is reduced. This
causes ringing in the time domain and peaking in the frequency
domain. Therefore, RF has some maximum value that should not
be exceeded for optimum performance. If a large value of RF
must be used, a small capacitor in the few Pico farad range in
parallel with RF can help to reduce the ringing and peaking at the
expense of reducing the bandwidth.
REF
R10
R9
RCD
OUT+
OUT-
CC
R6
R5
CC
R4
R3
R7
R8
R2
R1
VB1
FBN
FBP
IN-
IN+
VB2
VS+
VS-
V
ODM
V
IN
(
+V
IN- )
1
R
F1
R
F2
+
R
G
----------------------------
+
×
–
=
V
ODM
V
IN
(
+V
IN- )
1
2R
F
R
G
-----------
+
×
–
=
V
OCM
V
REF
=
(EQ. 1)
VO+
FBP
RG
RF2
IN+
IN-
REF
FBN
VIN+
VIN-
VREF
RF1
VO-
相关PDF资料 |
PDF描述 |
|---|---|
| BA2-B2-24-620-211-D | CIRCUIT BREAKER MAGNETIC 20A |
| EL5176IY | IC DRVR DIFF 250MHZ TP 10-MSOP |
| AD8039AR-REEL7 | IC OPAMP VF DUAL LP LN 8SOIC |
| EL5175IY | IC LINE RCVR 550MHZ SGL 8-MSOP |
| EL5175IS | IC LINE RCVR 550MHZ SGL 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EL5177IY-T13 | 功能描述:IC DRIVER TWISTED 550MHZ 10-MSOP RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:1.8 V/µs 增益带宽积:6.5MHz -3db带宽:4.5MHz 电流 - 输入偏压:5nA 电压 - 输入偏移:100µV 电流 - 电源:65µA 电流 - 输出 / 通道:35mA 电压 - 电源，单路/双路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-MSOP 包装:管件 |
| EL5177IY-T7 | 功能描述:IC DRIVER DIFF 550MHZ TP 10-MSOP RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1,000 系列:- 放大器类型:电压反馈 电路数:4 输出类型:满摆幅 转换速率:33 V/µs 增益带宽积:20MHz -3db带宽:30MHz 电流 - 输入偏压:2nA 电压 - 输入偏移:3000µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:带卷 (TR) |
| EL5177IYZ | 功能描述:差分放大器 EL5177IYZ 200MHZ DIF DRVR EXTRA CONNEC RoHS:否 制造商:Texas Instruments 通道数量:1 Channel 带宽:2.4 GHz 可用增益调整:6 dB to 26 dB 输入补偿电压: 共模抑制比（最小值）:- 40 dB 工作电源电压:4.75 V to 5.25 V 电源电流:100 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:WQFN-24 封装:Reel |
| EL5177IYZ-T13 | 功能描述:差分放大器 EL5177IYZ 200MHZ DIF FRNTL DRVR XTRA CONT RoHS:否 制造商:Texas Instruments 通道数量:1 Channel 带宽:2.4 GHz 可用增益调整:6 dB to 26 dB 输入补偿电压: 共模抑制比（最小值）:- 40 dB 工作电源电压:4.75 V to 5.25 V 电源电流:100 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:WQFN-24 封装:Reel |
| EL5177IYZ-T7 | 功能描述:差分放大器 EL5177IYZ 200MHZ DIF FRNTL DRVR XTRA CONT RoHS:否 制造商:Texas Instruments 通道数量:1 Channel 带宽:2.4 GHz 可用增益调整:6 dB to 26 dB 输入补偿电压: 共模抑制比（最小值）:- 40 dB 工作电源电压:4.75 V to 5.25 V 电源电流:100 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:WQFN-24 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。