- 您现在的位置：买卖IC网 > PDF目录10840 > EL5724IREZ-T7 (Intersil)IC BUFFER 8XGAMMA 8.3MA 24HTSSOP PDF资料下载
参数资料
| 型号： | EL5724IREZ-T7 |
| 厂商： | Intersil |
| 文件页数： | 11/11页 |
| 文件大小： | 0K |
| 描述： | IC BUFFER 8XGAMMA 8.3MA 24HTSSOP |
| 标准包装： | 1,000 |
| 应用： | TFT-LCD 面板：伽玛缓冲器，VCOM 驱动器 |
| 输出类型： | 满摆幅 |
| 电路数： | 8 |
| -3db带宽： | 12MHz |
| 转换速率： | 15 V/µs |
| 电流 - 电源： | 8.3mA |
| 电流 - 输出 / 通道： | 140mA |
| 电压 - 电源，单路/双路(±)： | 4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 供应商设备封装： | 24-TSSOP 裸露焊盘 |
| 包装： | 带卷 (TR) |
9
Description of Operation and Application
Information
Product Description
The EL5524, EL5624, EL5724, and EL5824 are fabricated
using a high voltage CMOS process. They exhibit rail to rail
input and output capability and have very low power
consumption. When driving a load of 10K and 12pF, the
buffers have a -3dB bandwidth of 12MHz and exhibit 18V/s
slew rate. The VCOM amplifier has a -3dB bandwidth of
35MHz and exhibit 80V/s slew rate.
Input, Output, and Supply Voltage Range
The EL5524, EL5624, EL5724, and EL5824 are specified
with a single nominal supply voltage from 5V to 15V or a split
supply with its total range from 5V to 15V. Correct operation
is guaranteed for a supply range from 4.5V to 16.5V.
The input common-mode voltage range of the EL5524,
EL5624, EL5724, and EL5824 extends 500mV beyond the
supply rails. The output swings of the buffers and VCOM
amplifier typically extend to within 100mV of the positive and
negative supply rails with load currents of 5mA. Decreasing
load currents will extend the output voltage even closer to
each supply rails.
Output Phase Reversal
The EL5524, EL5624, EL5724, and EL5824 are immune to
phase reversal as long as the input voltage is limited from
VS- -0.5V to VS+ +0.5V. Although the device's output will not
change phase, the input's overvoltage should be avoided. If
an input voltage exceeds supply voltage by more than 0.6V,
electrostatic protection diode placed in the input stage of the
device begin to conduct and overvoltage damage could
occur.
Choice of Feedback Resistor and Gain Bandwidth
Product for VCOM Amplifier
For applications that require a gain of +1, no feedback
resistor is required. Just short the output pin to the inverting
input pin. For gains greater than +1, the feedback resistor
forms a pole with the parasitic capacitance at the inverting
input. As this pole becomes smaller, the amplifier's phase
margin is reduced. This causes ringing in the time domain
and peaking in the frequency domain. Therefore, RF has
some maximum value that should not be exceeded for
optimum performance. If a large value of RF must be used, a
small capacitor in the few Pico farad range in parallel with RF
can help to reduce the ringing and peaking at the expense of
reducing the bandwidth.
As far as the output stage of the amplifier is concerned, the
output stage is also a gain stage with the load. RF and RG
appear in parallel with RL for gains other than +1. As this
combination gets smaller, the bandwidth falls off.
Consequently, RF also has a minimum value that should not
be exceeded for optimum performance. For gain of +1, RF =
0 is optimum. For the gains other than +1, optimum
response is obtained with RF between 1k to 5k.
The VCOM amplifier has a gain bandwidth product of
20MHz. For gains
≥5, its bandwidth can be predicted by the
following equation:
Output Drive Capability
The EL5524, EL5624, EL5724, and EL5824 do not have
internal short-circuit protection circuitry. The buffers will limit
the short circuit current to ±120mA and the VCOM amplifier
FIGURE 19. PACKAGE POWER DISSIPATION vs AMBIENT
TEMPERATURE
FIGURE 20. PACKAGE POWER DISSIPATION vs AMBIENT
TEMPERATURE
Typical Performance Curves (Continued)
JEDEC JESD51-3 LOW EFFECTIVE THERMAL
CONDUCTIVITY TEST BOARD
1
0.9
0.6
0.4
0.3
0.2
0.1
0
255075
100
150
AMBIENT TEMPERATURE (°C)
POWER
DISS
IP
A
T
ION
(W)
85
0.8
0.5
0.7
125
909mW
800mW
694mW
833mW
θJA=110°C/W
HTSSOP28
θJA=120°C/W
HTSSOP24
θJA=125°C/W
HTSSOP20
θJA=144°C/W
HTSSOP14
JEDEC JESD51-7 HIGH EFFECTIVE THERMAL
CONDUCTIVITY TEST BOARD -
HTSSOP EXPOSED DIEPAD SOLDERED TO
PCB PER JESD51-5
3.5
3
2.5
1.5
1
0.5
0
255075
100
150
AMBIENT TEMPERATURE (°C)
P
O
WER
DIS
S
IP
A
T
ION
(W
)
125
85
2
2.632W
3.333W
3.030W
2.857W
θJA=35°C/W
HTSSOP20
θJA=38°C/W
HTSSOP14
θJA=30°C/W
HTSSOP28
θJA=33°C/W
HTSSOP24
Gain
BW
20MHz
=
×
EL5524, EL5624, EL5724, EL5824
相关PDF资料 |
PDF描述 |
|---|---|
| LF10WBRB-12P | CONN RCPT WATERPROOF 12POS MALE |
| EL5724IREZ-T13 | IC BUFFER 8XGAMMA 8.3MA 24HTSSOP |
| LF10WBJ-4P | CONN JACK WATERPROOF 4POS MALE |
| VI-B3T-MX-F2 | CONVERTER MOD DC/DC 6.5V 75W |
| VI-B3T-MW | CONVERTER MOD DC/DC 6.5V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EL5811IREZ | 功能描述:IC AMP 60MHZ R-R 8-CHAN 28HTSSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:1.8 V/µs 增益带宽积:6.5MHz -3db带宽:4.5MHz 电流 - 输入偏压:5nA 电压 - 输入偏移:100µV 电流 - 电源:65µA 电流 - 输出 / 通道:35mA 电压 - 电源，单路/双路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-MSOP 包装:管件 |
| EL5811IREZ-T13 | 功能描述:IC AMP 8-CHAN R-R 60MHZ 28HTSSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:LinCMOS™ 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.05 V/µs 增益带宽积:110kHz -3db带宽:- 电流 - 输入偏压:0.7pA 电压 - 输入偏移:210µV 电流 - 电源:57µA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):3 V ~ 16 V，±1.5 V ~ 8 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:管件 产品目录页面:865 (CN2011-ZH PDF) 其它名称:296-1834296-1834-5 |
| EL5811IREZ-T7 | 功能描述:IC AMP 8-CHAN R-R 60MHZ 28HTSSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:LinCMOS™ 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.05 V/µs 增益带宽积:110kHz -3db带宽:- 电流 - 输入偏压:0.7pA 电压 - 输入偏移:210µV 电流 - 电源:57µA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):3 V ~ 16 V，±1.5 V ~ 8 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:管件 产品目录页面:865 (CN2011-ZH PDF) 其它名称:296-1834296-1834-5 |
| EL5824 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Integrated Buffers with VCOM |
| EL5824IRE | 功能描述:IC BUFFER 10XGAMMA 9.5MA 28HTSSO RoHS:否 类别:集成电路 (IC) >> 线性 - 放大器 - 视频放大器和频缓冲器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 应用:TFT-LCD 面板：VCOM 驱动器 输出类型:满摆幅 电路数:1 -3db带宽:35MHz 转换速率:40 V/µs 电流 - 电源:3.7mA 电流 - 输出 / 通道:1.3A 电压 - 电源，单路/双路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽）裸露焊盘 供应商设备封装:8-uMax-EP 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。