- 您现在的位置：买卖IC网 > PDF目录20679 > EL7513IYZ-T13 (Intersil)IC LED DRIVR WHITE BCKLGT 8-MSOP PDF资料下载
参数资料
| 型号： | EL7513IYZ-T13 |
| 厂商： | Intersil |
| 文件页数： | 9/12页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVR WHITE BCKLGT 8-MSOP |
| 标准包装： | 2,500 |
| 恒定电流： | 是 |
| 拓扑： | PWM，升压（升压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 800kHz ~ 1.2MHz |
| 电源电压： | 2.6 V ~ 13.2 V |
| 输出电压： | 18V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
EL7513
Waveforms (Continued)
All performance curves and waveforms are taken with C 1 = 4.7μF, C 2 = 1μF, C 3 = 0.1μF, L = 33μF, V IN = 3.3V, V CNTL = 1V, R 1 = 5 Ω , 4 LEDs in a
series; unless otherwise specified.
V CTRL = 0.34V, I LED = 5mA
Δ V IN
I L
10mV/DIV
100mA/DIV
V O (5V/DIV)
V LX
Δ V O
1μs/DIV
10V/DIV
50mV/DIV
V COMP (1V/DIV)
FIGURE 18. DISCONTINUOUS CONDUCTION MODE
Detailed Description
The EL7513 is a constant current boost regulator specially
FIGURE 19. OVER VOLTAGE PROTECTION (LED
DISCONNECTED)
The relationship between the LED current and CNTL voltage
level is as follows:
13.33 × R 1
designed for driving white LEDs. It can drive up to 4 LEDs in
series or 12 LEDs in parallel/series configuration and
achieves efficiency up to 91%.
V CNTL
I LED = ----------------------------
(EQ. 1)
The brightness of the LEDs is adjusted through a voltage
level on the CNTL pin. When the level falls below 0.1V, the
chip goes into shut-down mode and consumes less than
1μA of current for V IN less than 5.5V.
Steady-State Operation
EL7513 is operated in constant frequency PWM. The
switching is around 1MHz. Depending on the input voltage,
the inductance, the type of LEDs driven, and the LED’s
current, the converter operates at either continuous
conduction mode or discontinuous conduction mode (see
waveforms). Both are normal.
Brightness Control
LED’s current is controlled by the voltage level on CNTL pin
(V CNTL ). This voltage can be either a DC or a PWM signal
with frequency less than 200Hz (for C 3 = 4700pF). When a
higher frequency PWM is used, an RC filter is recommended
before the CNTL pin (see Figure 20).
When R 1 is 5 Ω , 1V of V CNTL conveniently sets I LED to
15mA. The range of V CNTL is 250mV to 5.5V.
Shut-Down
When V CNTL is less than 100mV, the converter is in shut-
down mode. The max current consumed by the chip is less
than 1μA for V IN less than 5.5V.
Over-Voltage Protection
When an LED string is disconnected from the output, V O will
continue to rise because of no current feedback. When V O
reaches 18V (nominal), the chip will shut down. The output
voltage will drop. When V O drops below 16V (nominal), the
chip will boost output voltage again until it reaches 18V. This
hiccough continues until LED is applied or converter is shut
down.
When designing the converter, caution should be taken to
ensure the highest operating LED voltage does not exceed
17V, the minimum shut-down voltage. There is no external
component required for this function.
Component Selection
The input and output capacitors are not very important for
the converter to operate normally. The input capacitance
PWM
SIGNAL
100k
0.1μF
CNTL
COMP
is normally 0.22μF - 4.7μF and output capacitance
0.22μF - 1μF. Higher capacitance is allowed to reduce the
voltage/current ripple, but at added cost. Use X5R or X7R
type (for its good temperature characteristics) of ceramic
capacitors with correct voltage rating and maximum height.
FIGURE 20. PWM BRIGHTNESS CONTROL
9
FN7112.5
December 22, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| R0.25D-1524/P-R | CONV DC/DC 0.25W 15VIN +/-24VOUT |
| EBA18DTKD-S288 | CONN EDGECARD 36POS .125 EXTEND |
| RYM36DRMT-S273 | CONN EDGECARD 72POS .156 SQ WW |
| GMC05DREI | CONN EDGECARD 10POS .100 EYELET |
| GSM08DRKI | CONN EDGECARD 16POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EL7513IYZ-T7 | 功能描述:IC LED DRIVR WHITE BCKLGT 8-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:1 系列:- 恒定电流:- 恒定电压:- 拓扑:PWM，切换式电容器（充电泵） 输出数:1 内部驱动器:是 类型 - 主要:背光 类型 - 次要:白色 LED 频率:642kHz 电源电压:2.7 V ~ 5.5 V 输出电压:5V 安装类型:表面贴装 封装/外壳:10-VFDFN 裸露焊盘 供应商设备封装:10-VSON 包装:剪切带 (CT) 工作温度:-30°C ~ 85°C 产品目录页面:1371 (CN2011-ZH PDF) 其它名称:BD1603NUV-E2CT |
| EL7515 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High Frequency PWM Step-Up Regulator |
| EL7515_07 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High Frequency PWM Step-Up Regulator |
| EL7515IY | 功能描述:IC REG BOOST ADJ 0.6A 10MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR |
| EL7515IY-T13 | 功能描述:IC REG BOOST ADJ 0.6A 10MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR |
发布紧急采购，3分钟左右您将得到回复。