参数资料
| 型号： | EL7520ILZ |
| 厂商： | Intersil |
| 文件页数： | 17/18页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR DC/DC 4-CHAN 20-QFN |
| 标准包装： | 90 |
| 应用： | 控制器，TFT LCD |
| 输入电压： | 3 V ~ 5.5 V |
| 输出数： | 4 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-VFQFN 裸露焊盘 |
| 供应商设备封装： | 20-QFN 裸露焊盘（4x4） |
| 包装： | 管件 |
EL7520, EL7520A
Over-Temperature Protection
An internal temperature sensor continuously monitor the die
temperature. In the event that the die temperature exceeds
the thermal trip point, the device will shut down. The upper
and lower trigger points are typically set to 130°C and -90°C
respectively.
Layout Recommendation
The device's performance including efficiency, output noise,
transient response and control loop stability is dramatically
affected by the PCB layout. PCB layout is critical, especially
at high switching frequency.
There are some general guidelines for layout:
1. Place the external power components (the input
capacitors, output capacitors, boost inductor and output
diodes, etc.) in close proximity to the device. Traces to
these components should be kept as short and wide as
possible to minimize parasitic inductance and resistance.
2. Place V REF and V DD bypass capacitors close to the pins.
3. Reduce the loop with large AC amplitudes and fast slew
rate.
4. The feedback network should sense the output voltage
directly from the point of load, and be as far away from LX
node as possible.
5. The power ground (PGND) and signal ground (SGND)
pins should be connected at only one point.
A demo board is available to illustrate the proper layout
implementation.
17
FN7318.0
July 12, 2005
相关PDF资料 |
PDF描述 |
|---|---|
| EL7530IY-T7 | IC REG BUCK SYNC ADJ 0.6A 10MSOP |
| EL7531IY-T7 | IC REG BUCK SYNC ADJ 1A 10MSOP |
| EL7532IY-T7 | IC REG BUCK SYNC ADJ 2A 10MSOP |
| EL7534IY-T7 | IC REG BUCK SYNC ADJ 0.6A 10MSOP |
| EL7535IY | IC REG BUCK SYNC ADJ .35A 10MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EL7520ILZ-T13 | 功能描述:电流型 PWM 控制器 EL7520ILZ 4-CH DC-DC CNTRLR RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| EL7520ILZ-T7 | 功能描述:电流型 PWM 控制器 EL7520ILZ 4-CH DC-DC CNTRLR RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| EL7530 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Monolithic 600mA Step-Down Regulator with Low Quiescent Current |
| EL7530_06 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Monolithic 600mA Step-Down Regulator with Low Quiescent Current |
| EL7530EVAL1 | 功能描述:EVALUATION BOARD FOR EL7530 RoHS:否 类别:编程器，开发系统 >> 过时/停产零件编号 系列:- 标准包装:1 系列:- 传感器类型:CMOS 成像，彩色（RGB） 传感范围:WVGA 接口:I²C 灵敏度:60 fps 电源电压:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相关产品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
发布紧急采购，3分钟左右您将得到回复。