- 您现在的位置：买卖IC网 > PDF目录14585 > EL7566DREZ (Intersil)IC REG BUCK SYNC ADJ 6A 28HTSSOP PDF资料下载
参数资料
| 型号： | EL7566DREZ |
| 厂商： | Intersil |
| 文件页数： | 9/14页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 6A 28HTSSOP |
| 标准包装： | 50 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 6 V |
| 输入电压： | 3 V ~ 6 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 370kHz |
| 电流 - 输出： | 6A |
| 同步整流器： | 是 |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 28-TSSOP 裸露焊盘 |
| 产品目录页面： | 1242 (CN2011-ZH PDF) |
EL7566
Waveforms
V IN = V D = 5V, V O = 2.5V, I O = 6A, f S = 500kHz, L = 2.7μH, C IN = 100μF, C OUT = 150μF, T A = 25°C unless otherwise noted. (Continued)
V IN (5V/DIV)
I IN (2A/DIV)
V O (2V/DIV)
V IN (5V/DIV)
V O1 =2.5V
V O2 =1.8V
PG
T D = C EN × --------------------
I
5ms/DIV
FIGURE 18. ADJUSTABLE START-UP
Detailed Description
The EL7566 is a 6A capable buck regulator operating from
an input voltage range of 3V to 6V. The duty cycle can be
adjusted from 0% to 100% allowing for a wide range of
programmable output voltages. Patented on-chip
resistorless current-sensing enables current mode control
for excellent step load response. Overcurrent, Overvoltage,
input Undervoltage, and thermal protection is integrated
along with soft-start and power-up sequencing features to
produce an overall robust power solution for general
purpose applications.
EL7566DRE vs. EL7566AIRE
The EL7566AIRE includes the following feature changes
from the EL7566DRE:
? Up to 6A Current Sinking Capability
? Expanded Temperature Range: -40 o C to 85 o C
? No Overvoltage Protection
Start-Up
The EL7566 employs a digital soft-start feature to suppress
the in-rush current needed to charge the output capacitance
and smoothly ramp the output voltage to regulation (See
Figure 12). The normal start-up process begins when the
input voltage reaches the rising POR threshold (~2.8V) and
EN pin is transitioned HIGH by an internal 2.5μA current
source. The output voltage is then digitally ramped to
regulation over a 2ms period. The 2ms soft start-up time can
be extended if needed by configuring the STP and STN pins.
(refer to Full Start-Up Control section).
If the input voltage is ramped slowly, soft-start may be
initiated before the input supply has reached regulation. The
lower input voltage will have increased current demand
during start-up and may risk an overcurrent event. To
prevent such an event from occurring, a capacitor can be
9
5ms/DIV
FIGURE 19. TRACKING START-UP
placed from the EN pin to GND to program a delay between
when the rising POR threshold for VIN is met and when soft-
start begins. The programmable delay time, T D , is governed
by Equation 1.
V EN_HI
EN
where:
? C EN is the capacitance at EN pin
? V EN_HI is the EN input high level (function of V DD voltage,
see Figure 5)
? I EN is the EN pin pull-up current, nominal 2.5μA
Steady-State Operation
Under all steady-state conditions the converter will operate
in fixed frequency continuous-conduction mode. For fast
transient response and ease of controllability, a peak
current-mode control method is employed. The inductor
current is sensed from the upper PMOS. This current signal
serves as the ramp to the PWM comparator and is compared
against the difference signal generated by the
transconductance error amplifier. Slope compensation for
the ramp is used to allow for 100% duty cycle operation (see
Figure 20). The pulse-width modulated square wave output
of the PWM comparator is amplified and serves as the gate
drive signals for the switching power FETs.
100% DUTY RATIO
EL7566 uses CMOS as internal synchronous power
switches. The upper and lower switches are PMOS and
NMOS respectively. The upper PMOS saves the need for a
boot capacitor normally seen in NMOS/NMOS half-bridges.
FN7102.7
May 8, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6468US23D3+T | IC MPU/RESET CIRC 2.313V SOT143 |
| VE-JV0-CY | CONVERTER MOD DC/DC 5V 50W |
| MAX6467XS18D7+T | IC MPU/RESET CIRC 1.800V SC70-4 |
| EBA36DRMH | CONN EDGECARD 72POS .125 SQ WW |
| MAX6467XS17D3+T | IC MPU/RESET CIRC 1.665V SC70-4 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EL7566DREZ-T13 | 功能描述:直流/直流开关调节器 EL7566DREZ 6 AMP DC: DC STP DWNG RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| EL7566DREZ-T7 | 功能描述:直流/直流开关调节器 EL7566DREZ 6 AMP DC: DC STP DWNG RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| EL7571 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Programmable PWM Controller |
| EL7571C | 制造商:ELANTEC 制造商全称:ELANTEC 功能描述:Programmable PWM Controller |
| EL7571CM | 功能描述:IC CTRLR PWM PROGRAMMABLE 20SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。