参数资料
| 型号： | EL7640AILTZ-T7 |
| 厂商： | Intersil |
| 文件页数： | 14/19页 |
| 文件大小： | 0K |
| 描述： | IC CONV DC/DC TFT-LCD 32-QFN |
| 标准包装： | 1,000 |
| 应用： | 转换器，TFT，LCD |
| 输入电压： | 2.6 V ~ 5.5 V |
| 输出数： | 3 |
| 输出电压： | 5.5 V ~ 20 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 供应商设备封装： | 32-TQFN-EP（5x5） |
| 包装： | 带卷 (TR) |
EL7640A, EL7641A, EL7642A
LX
0.1μF
0.1μF
700 ?
V BOOST
DRVP
EL7642A
FBP
0.47μF
Q11
0.1μF
0.1μF
0.1μF
V ON
(>36V)
0.22μF
FIGURE 22. THE LINEAR REGULATOR CONTROLS ONE STAGE OF CHARGE PUMP
N POSITIVE ≥ --------------------------------------------------------------
N NEGATIVE ≥ -------------------------------------------------
C OUT ≥ ------------------------------------------------------
Calculation of the Linear Regulator Base-emitter
Resistors (RBP and RBN)
For the pass transistor of the linear regulator, low frequency
gain (Hfe) and unity gain frequency (f T ) are usually specified
in the datasheet. The pass transistor adds a pole to the loop
transfer function at fp = f T /Hfe. Therefore, in order to
maintain phase margin at low frequency, the best choice for
a pass device is often a high frequency low gain switching
transistor. Further improvement can be obtained by adding a
base-emitter resistor R BE (R BP , R BL , R BN in the Functional
Block Diagram), which increases the pole frequency to:
fp = fT*(1+ Hfe *re/R BE )/Hfe, where re = KT/qIc. So choose
the lowest value R BE in the design as long as there is still
enough base current (I B ) to support the maximum output
current (I C ).
We will take as an example the V ON linear regulator. If a
Fairchild MMBT3906 PNP transistor is used as the external
pass transistor, Q11 in the application diagram, then for a
maximum V ON operating requirement of 50mA the data
sheet indicates Hfe_min = 60. The base-emitter saturation
voltage is: Vbe_max = 0.7V.
For the EL7640A, EL7641A and EL7642A, the minimum
drive current is:
I_DRVP_min = 2mA
The minimum base-emitter resistor, RBP, can now be
calculated as:
RBP_min = VBE_max/(I_DRVP_min - Ic/Hfe_min) =
0.7V/(2mA - 50mA/60) = 600 ?
This is the minimum value that can be used – so, we now
choose a convenient value greater than this minimum value;
say 700 ? . Larger values may be used to reduce quiescent
current, however, regulation may be adversely affected by
supply noise if R BP is made too high in value.
14
Charge Pump
To generate an output voltage higher than V BOOST , single or
multiple stages of charge pumps are needed. The number of
stage is determined by the input and output voltage. For
positive charge pump stages:
V OUT + V CE – V INPUT
V INPUT – 2 × V F
where V CE is the dropout voltage of the pass component of
the linear regulator. It ranges from 0.3V to 1V depending on
the transistor selected. V F is the forward-voltage of the
charge-pump rectifier diode.
The number of negative charge-pump stages is given by:
V OUTPUT + V CE
V INPUT – 2 × V F
To achieve high efficiency and low material cost, the lowest
number of charge-pump stages, which can meet the above
requirements, is always preferred.
Charge Pump Output Capacitors
Ceramic capacitor with low ESR is recommended. With
ceramic capacitors, the output ripple voltage is dominated by
the capacitance value. The capacitance value can be
chosen by the following equation:
I OUT
2 × V RIPPLE × f OSC
where f OSC is the switching frequency.
Discontinuous/Continuous Boost Operation and
its Effect on the Charge Pumps
The EL7640A, EL7641A and EL7642A V ON and V OFF
architecture uses LX switching edges to drive diode charge
pumps from which LDO regulators generate the V ON and
FN6270.0
May 15, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| 2510-66K | INDUCTOR RF 56UH UNSHIELDED SMD |
| EL7641AILTZ-T7 | IC CONV DC/DC TFT-LCD 32-QFN |
| LT3010MPMS8E-5#PBF | IC REG LDO 5V 50MA 8-MSOP |
| 2510-64K | INDUCTOR RF 47UH UNSHIELDED SMD |
| GMM40DRMI | CONN EDGECARD 80POS .156 SQ WW |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EL7640ILTZ | 功能描述:直流/直流开关调节器 EL7640ILTZ TFT-LCD D DC-DC W/INTEGRTD AMP RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| EL7640ILTZ-T13 | 功能描述:直流/直流开关调节器 EL7640ILTZ TFT-LCD DC-DC W/INTEGRTD AMP RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| EL7640ILTZ-T7 | 功能描述:直流/直流开关调节器 EL7640ILTZ-T7 TFT-LC DC-DC W/INTEGRTD AMP RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| EL7641 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:TFT-LCD DC/DC with Integrated Amplifiers |
| EL7641AILTZ | 功能描述:LCD 驱动器 EL7641AILTZ TFT-LCD DC-DC W/INTEGRTD AMP RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。