- 您现在的位置：买卖IC网 > PDF目录97907 > ELANSC410 Single Synchronous Buck Pulse-Width Modulation (PWM) Controller; Temperature Range: 0°C to 70°C; Package: 16-QFN PDF资料下载
参数资料
| 型号： | ELANSC410 |
| 英文描述： | Single Synchronous Buck Pulse-Width Modulation (PWM) Controller; Temperature Range: 0°C to 70°C; Package: 16-QFN |
| 中文描述： | ElanSC410 - ElanSC410框图 |
| 文件页数： | 59/119页 |
| 文件大小： | 1167K |
| 代理商： | ELANSC410 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页当前第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页
44
lanSC310 Microcontroller Data Sheet
PREL IMINARY
In the PLL Block Diagram, the INT_PLL is the Interme-
diate PLL, and is used to multiply the 32.768-kHz input
frequency by 45 to produce a 1.4746-MHz input for use
by the LS_PLL and the VID_PLL. The LS_PLL, or Low-
Speed PLL, is used to again multiply the 1.4746-MHz
input by 25 to produce a 36.864-MHz output. This out-
put of the LS_PLL is then divided down to provide the
frequencies shown in Table 20.
The LS_PLL also generates a 2.048-MHz signal used
by the VID_PLL or Video PLL to generate the 14.336-
MHz clock. This frequency is also available on the
X1OUT pin for use by an external video controller if se-
lected. This frequency should only be used to drive an
LCD panel.
The HS_PLL can be programmed to provide one of the
high-speed CPU clock frequencies shown in Table 19.
lanSC310 Microcontroller
Power Management
Dynamic CPU clock switching is the primary form of
power management in the lanSC310 microcontroller.
When the system is in the High-Speed PLL mode, the
lanSC310 microcontroller can be configured to use
the High-Speed clock output of the PLL for main mem-
ory, local bus accesses, CPU idle cycles, and ROM
accesses configured to use the High-Speed clock. Dur-
ing cycles to I/O devices, ROM and other external ISA
devices, the CPU clock is dynamically switched to the
output of the Low-Speed PLL.
During operation in Low-Speed PLL mode, the CPU
clock is driven from Low-Speed clock output of the
Low-Speed PLL divide chain. The CPU clock fre-
quency used during Low Speed mode is programma-
ble to the following frequencies: 4.608 MHz, 2.304
MHz, 1.152 MHz, and 0.567 MHz. During Doze, Sleep,
and Suspend modes of operation, the CPU clock is
normally stopped. This clock operates at 9.216 MHz
when it is running.
Slow-refresh and self-refresh DRAMs are supported by
the lanSC310 microcontroller. The refresh timer
source and the refresh rate are selectable. When the
CPU clock is stopped, the only clock source for refresh
is the 32-kHz clock. CAS-before-RAS DRAM refresh is
performed.
When the DMA subsystem is idle, the DMA clock con-
trol logic stops the clock input to the DMA controllers.
The DMA clock is started whenever any of the DREQ
inputs go High. When the DMA cycle is in progress, the
DMA clock remains active as long as a DREQ input is
High or the internal AEN signal is active.
To reduce power consumption in Doze, Sleep, and
Suspend modes, the CPU clock is turned off. To further
reduce the power consumption in these three modes,
the High-Speed PLL is shut off. The Low-Speed PLL is
left on by default, but can be programmed to turn off in
all three modes.
For information about the signals associated with
power management (ACIN, BL4–BL1, EXTSMI, LPH,
PGP3–PGP0, PMC4–PMC0, and SUS/RES), see
information, see Chapter 1 of the
lanTMSC310 Micro-
controller Programmer’s Reference Manual, order
#20665.
Table 19.
High-Speed CPU Clock Frequencies
2 x CPU Frequency
HS_PLL Output Frequency
40 MHz
39.496 MHz
50 MHz
50.023 MHz
66 MHz
65.829 MHz
Table 20.
PLL Output
Phase-Locked Loops
Frequency
Where Used
INT_PLL
1.4746 MHz
LS_PLL and VID_PLL
LS_PLL
36.864 MHz
Divide by 2
1.8432 MHz
16450 UART clock
1.1892 MHz
8254 Timer clock
HS_PLL
39.496 MHz, 50.023 MHz,
or 65.829 MHz
Input to high speed/low speed MUX
VID_PLL
14.336 MHz
External video controller, if using an LCD panel
相关PDF资料 |
PDF描述 |
|---|---|
| ELH0032G | Fast Operational Amplifier |
| ELH0033G | Fast Buffer Amplifier |
| ELH0101CK | Dual Regulator-Standard Buck PWM and Linear Power Controller; Temperature Range: 0°C to 70°C; Package: 8-SOIC T&R |
| ELH0101ACK | Single Synchronous Buck Pulse-Width Modulation (PWM) Controller; Temperature Range: -40°C to 85°C; Package: 16-QFN |
| ELH0101 | Power Operational Amplifier |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ELANSC410-100AC | 制造商:Advanced Micro Devices 功能描述:MCU 16-Bit/32-Bit Elan CISC ROMLess 3.3V 292-Pin BGA |
| ELANSC410-100ACAD | 制造商:Advanced Micro Devices 功能描述: |
| ELANSC410-100AI | 制造商:AMD 制造商全称:Advanced Micro Devices 功能描述:Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC410-33AC | 制造商:Advanced Micro Devices 功能描述:MCU 16-Bit/32-Bit Elan CISC 3.3V 292-Pin BGA |
| ELANSC410-33AI | 制造商:AMD 制造商全称:Advanced Micro Devices 功能描述:Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
发布紧急采购，3分钟左右您将得到回复。