参数资料
型号: EM6617TP28A
英文描述: Advanced Synchronous Rectified Buck MOSFET Drivers with Pre-POR OVP; Temperature Range: 0&degC to 70°C; Package: 8-EPSOIC T&R
中文描述: 微控制器
文件页数: 22/67页
文件大小: 824K
代理商: EM6617TP28A
EM6617
03/02 REV. C/442
Copyright
2002, EM Microelectronic-Marin SA
29
www.emmicroelectronic.com
9. Serial (Output) Write Buffer - SWB
The EM6617 has simple Serial Write Buffer which outputs serial data and serial clock.
Serial Write Buffer clock frequency is selected by bits SWBFSel0 and SWBFSel1 in RegSWBCntl register. The
possible values are 1kHz (default), 2kHz, 8kHz or 16kHz.
The signal TestVar[3], which is used by the processor to make conditional jumps, indicates "Transmission
finished" in automatic send mode or "SWBbuffer empty" in interactive send mode. In interactive mode,
TestVar[3] is equivalent to the interrupt request flags stored in RegIRQ[i] registers : it permits to recognize the
interrupt source. (See also the interrupt handling section 13 for further information). To serve the "SWBbuffer
empty " interrupt request, one only has to make a conditional jump on TestVar[3].
The SWB data is output on the rising edge of the clock. Consequently, on the receiver side the serial data can
be evaluated on falling edge of the serial clock edge.
Normally the Clock and the Data output terminals are always driven to ‘0’ outside a SWB data transfer. With a
metal option one can put the Data output, the Clock output or both into a high impedance state outside of a SWB
transfer. Refer to 19.1.4 for the mask settings. The timing going into high impedance state into SWB transfer
and back into high impedance is depending on the selected mode, interactive or automatic.
Figure 22. Serial Write Buffer Architecture
Size[5:0]
Addr. Counter
RAM
SW B buffer
SW Bauto
SW BStart
SW BFSel0,1
Control
Logic
Shift register
DB[3:0]
Clk
Mux
SW B clock
SW B data
TestVar3
SW B buffer
register
IRQ (only in
interactive
SWB has two operational modes, automatic mode and interactive mode.
9.1 SWB Automatic send mode
Automatic mode enables a buffer on a predefined length to be sent at high transmission speeds up to ck[15]
(16kHz). In this mode user prepares all the data to be sent (minimum 8 bits, maximum 256 bits) in the RAM.
The user then selects the clock speed, sets the number of data nibbles to be sent, selects automatic
transmission mode (SWBAuto bit set to 1) and enters STANDBY mode by executing a HALT instruction. Once
the HALT instruction is activated the SWB peripheral module sends the data in register RegSWBuff followed by
the data in the RAM starting at address 00 up to the address specified by the bits size[5:0] located in the
RegSWBSizeL, RegSWBSizeH
registers.
相关PDF资料
PDF描述
EM6617TP28B Advanced Synchronous Rectified Buck MOSFET Drivers with Pre-POR OVP; Temperature Range: -40°C to 85°C; Package: 8-EPSOIC T&R
EM6640SO18A Advanced Synchronous Rectified Buck MOSFET Drivers with Pre-POR OVP; Temperature Range: -40°C to 85°C; Package: 8-SOIC
EM6640SO18B Advanced Synchronous Rectified Buck MOSFET Drivers with Pre-POR OVP; Temperature Range: -40°C to 85°C; Package: 10-DFN
EM6640TP16A Advanced Synchronous Rectified Buck MOSFET Drivers with Pre-POR OVP; Temperature Range: -40°C to 85°C; Package: 10-DFN
EM6640TP16B Advanced Synchronous Rectified Buck MOSFET Drivers with Pre-POR OVP; Temperature Range: 0&degC to 70°C; Package: 8-SOIC
相关代理商/技术参数
参数描述
EM6617TP28B 制造商:未知厂家 制造商全称:未知厂家 功能描述:Microcontroller
EM6617WP11 制造商:EMMICRO 制造商全称:EM Microelectronic - MARIN SA 功能描述:Ultra Low Power Microcontroller with ADC AND EEPROM
EM6617WP27 制造商:EMMICRO 制造商全称:EM Microelectronic - MARIN SA 功能描述:Ultra Low Power Microcontroller with ADC AND EEPROM
EM6617WS11 制造商:EMMICRO 制造商全称:EM Microelectronic - MARIN SA 功能描述:Ultra Low Power Microcontroller with ADC AND EEPROM
EM6617WS27 制造商:EMMICRO 制造商全称:EM Microelectronic - MARIN SA 功能描述:Ultra Low Power Microcontroller with ADC AND EEPROM