- 您现在的位置：买卖IC网 > Datasheet目录324 > EVAL-ADUM3070EBZ (Analog Devices Inc)BOARD EVAL FOR ADUM3070 Datasheet资料下载
参数资料
| 型号： | EVAL-ADUM3070EBZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 3/12页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL FOR ADUM3070 |
| 标准包装： | 1 |
| 系列： | iCoupler® |
| 主要目的： | 板，隔离式电源 |
| 输出及类型： | 3，隔离 |
| 输出电压： | 5V，7.5V，15V |
| 输入电压： | 5V |
| 频率 - 开关： | 500kHz |
| 板类型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | ADuM3070 |
Evaluation Board User Guide
SINGLE SUPPLY
Two independent and isolated circuits comprise the ADuM3070
evaluation board. The lower half of the board, shown in Figure 2,
is for a single power supply configuration (see the ADuM3070
data sheet for applications information about the ADuM3070 in
this configuration).
Figure 2. Single Supply Configuration
The single supply is configured as a 5 V secondary isolated
supply with a 5 V primary input supply, which can provide up
to 2.5 W of regulated, isolated power. It can be reconfigured for
a 3.3 V secondary isolated supply with a 5 V or 3.3 V primary
input supply (see the Other Input and Isolated Output Supply
Options section). Figure 9 shows the single supply schematic.
TERMINALS
The single supply has terminal blocks on Side 1 (the primary/
power supply input side) and Side 2 (the secondary/power supply
UG-402
V DD1 supplies the voltage to the transformer primary and to the
ADuM3070 supply voltage, V DDA (see the ADuM3070 data sheet
for additional information about the V DDA pin function). V DD1
and V DDA are bypassed by a 47 μF ceramic capacitor (C1) and a
0.1 μF local bypass capacitor (C2) located close to the ADuM3070 .
R7, R8, C5, and C6 are provided for an optional and unpopulated
snubber, which can be used to reduce radiated emissions.
Power is transferred to Side 2 by a regulated push-pull converter
comprising the ADuM3070 (U1), an external transformer (T1
or T2), and other components (see the ADuM3070 data sheet
for an explanation of this circuit functionality).
Output Power Connections
An output load can be connected to P3 (labeled +5V/3.3V on the
silkscreen and not labeled on the schematic), which is the iso-
lated, regulated 5 V output supply. Connect the return of the
load to P4, which is the Side 2 ground reference. P4 is labeled
GND ISO on the silkscreen and GND2 on the schematic. This
supply can provide up to 500 mA in the default 5 V primary
input supply, 5 V secondary isolated supply configuration.
Figure 5 through Figure 8 in this user guide show how the
power supply’s efficiency varies with load current, switching
frequency, and temperature.
Table 1. Single Supply Terminal Function Descriptions
output side). A 4.3 mm isolation barrier separates Side 1 and
Side 2. Figure 3 shows these terminal locations.
Table 1 summarizes the functions of the terminal connections.
They are described in detail in the Input Power Connections
and Output Power Connections sections.
Terminal
P1
P2
P3
P4
Pin
1
1
1
1
Label
+5V IN
GND
+5V/3.3V
GND ISO
Description
Side 1 5 V primary input supply
Side 1 ground reference
Side 2 5 V secondary isolated supply
Side 2 ground reference
Care must be taken to avoid driving the V DD2 output with an
external voltage because this can result in permanent damage to
the ADuM3070 .
TRANSFORMER SELECTION
The EVAL-ADuM3070EBZ supports multiple transformer
options. The single supply is equipped with a Halo TGSAD-
260V6LF (T1) or a Coilcraft JA4631-BL (T2) 1:2 turns ratio
Figure 3. Single Supply Terminals
Input Power Connections
Connect 5 V to P1, labeled +5V IN (or +3.3 V for a
3.3 V primary input supply with a 3.3 V secondary isolated
supply). Connect the negative supply to P2, labeled GND
(GND1 on the schematic). These are the only off-board
connections required for the single supply to function.
transformer. The Coilcraft footprint is offset to the left of the
Halo footprint. Figure 5 and Figure 7 show the efficiency curves
for the single supply operating with a Coilcraft and a Halo
transformer, respectively.
SWITCHING FREQUENCY OPTIONS
The resistor connected from the ADuM3070 oscillator control
pin (OC) to ground sets the single supply switching frequency.
Figure 4 shows the relationship between this resistance and the
converter switching frequency. The EVAL-ADuM3070EBZ can
be configured with 0 ?, 0805 resistors to four different preset
switching frequencies. Short-circuiting R10 sets R1 (300 k?)
and R2 (150 k?) in parallel, and short-circuiting R11 sets R1 and
R3 (100 k?) in parallel. Table 2 lists the switching frequencies
that can be selected by short- or open-circuiting R10 and R11.
Rev. 0 | Page 3 of 12
相关PDF资料 |
PDF描述 |
|---|---|
| EVAL-SDP-CB1Z | BOARD EVALUATION FOR SDP-CB1 |
| EVB51JM128 | BOARD EVAL FOR MCF51JM128 MCU |
| EVBQE128 | BOARD EVAL FLEXIS QE128 FAMILY |
| F2068 | PNL FIBERGLASS 18.44X14.44" WHT |
| FAN3100CMPX | IC GATE DRVR SGL CMOS 2A 6MLP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EVAL-ADUM3190EBZ | 功能描述:界面开发工具 RoHS:否 制造商:Bourns 产品:Evaluation Boards 类型:RS-485 工具用于评估:ADM3485E 接口类型:RS-485 工作电源电压:3.3 V |
| EVAL-ADUM3221AEBZ | 功能描述:BOARD EVAL FOR ADUM3220/ADUM3221 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:iCoupler® 标准包装:1 系列:- 主要目的:数字电位器 嵌入式:- 已用 IC / 零件:AD5258 主要属性:- 次要属性:- 已供物品:板 相关产品:AD5258BRMZ1-ND - IC POT DGTL I2C1K 64P 10MSOPAD5258BRMZ10-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ100-ND - IC POT DGTL I2C 100K 64P 10MSOPAD5258BRMZ50-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ1-R7-ND - IC POT DGTL I2C 1K 64P 10MSOPAD5258BRMZ10-R7-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ50-R7-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ100-R7-ND - IC POT DGTL I2C 100K 64P 10MSOP |
| EVAL-ADUM3223AEBZ | 功能描述:BOARD EVAL FOR ADUM3223 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:iCoupler® 标准包装:1 系列:- 主要目的:数字电位器 嵌入式:- 已用 IC / 零件:AD5258 主要属性:- 次要属性:- 已供物品:板 相关产品:AD5258BRMZ1-ND - IC POT DGTL I2C1K 64P 10MSOPAD5258BRMZ10-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ100-ND - IC POT DGTL I2C 100K 64P 10MSOPAD5258BRMZ50-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ1-R7-ND - IC POT DGTL I2C 1K 64P 10MSOPAD5258BRMZ10-R7-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ50-R7-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ100-R7-ND - IC POT DGTL I2C 100K 64P 10MSOP |
| EVAL-ADUM330X | 制造商:AD 制造商全称:Analog Devices 功能描述:Quad Isolators with isoPower Evaluation Board |
| EVAL-ADUM340X | 制造商:AD 制造商全称:Analog Devices 功能描述:Quad Isolators with isoPower Evaluation Board |
发布紧急采购，3分钟左右您将得到回复。