- 您现在的位置：买卖IC网 > PDF目录17996 > F1780AA20 (Curtis Industries)FILTER HI PERFORM 20A FASTON PDF资料下载
参数资料
| 型号： | F1780AA20 |
| 厂商： | Curtis Industries |
| 文件页数： | 89/92页 |
| 文件大小： | 0K |
| 描述： | FILTER HI PERFORM 20A FASTON |
| 标准包装： | 10 |
| 系列： | F1780 |
| 滤波器类型： | 电源线 |
| 电压 - 额定： | 250V |
| 电流： | 20A |
| 安装类型： | 底座安装 |
| 端接类型： | 快速连接 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页当前第89页第90页第91页第92页
Undoubtedly the two-pole filter would be a more
economical choice with probably equal performance in
this application. Since the equipment is not likely to be
equivalent to either one of these simple cases, the only
way to find the best cost-effective solution is to test the
filters in your equipment and base your judgement on
these test results.
Figure 1b.
The same circuit as in Figure 1a, with the addition of
a 2-pole low pass filter. Notice filter capacitor C1 is in
parallel with the capacitive load.
Figure 1c.
Combining capacitor
C1 in Figure 1b,
with the load
results in this circuit
configuration.
The filter has been reduced to one inductive element, L1.
Obviously a three-pole filter would be preferred for
maximum performance. Likewise, if the equipment
looked strictly inductive, the performance of a three-
pole network would be reduced to that of a two-pole
network.
Figure 2a.
A signal source
with its internal
impedance driving
an inductive load.
Leakage Current
The maximum leakage current that a device is allowed
depends on the requirements of the particular safety
agency involved. Here, selection of the filter is quite
easy since either the filter is designed to meet a given
level or it is not. Although there is no compromise
when it comes to safety specifications, it should be
understood that for a given level of performance, as
the leakage current is reduced, the physical size of the
package will increase. Curtis medical filters have a very
low leakage current.
Insertion Loss
DO NOT use the insertion loss specifications to make
your final decision. Power line filters are two-terminal
pair passive networks whose attenuation characteristics
can be defined by a complex transfer function. How
that transfer function will react in a particular system
and at specific frequencies will depend on the complex
impedances connected to each side of the filter. The
equipment impedance and the impedance of the
power line, even if a 50 ohm LISN (Line Impedance
Stabilization Network) is being used during emission
testing, will not generally be equal to the resistive
50 ohms used during insertion loss measurements.
Therefore, the performance of the filter in the
equipment cannot be related to the published insertion
loss data.
Figure 2b.
The same circuit as in Figure 2a, with the addition of a
3-pole low pass filter. Notice filter inductance L2 is in
series with the inductive load.
Figure 2c.
Combining inductor L2 in Figure 2b, with the load
results in this circuit configuration, the filter has been
reduced to two effective elements, L1 & C1.
Minimum Insertion Loss
Do not be alarmed that the insertion loss figures we
have published may be of lower value than those of
our competition. You will only find guaranteed minimum
insertion loss figures in this catalog, without any
mention of typical values.
Insertion loss test data measured in a 50 ohm
system is a valuable incoming inspection tool to assure
you that consistent product is being shipped. The only
figures of any importance are those that specify the
criteria for acceptance or rejection of that product, and
those figures are the minimum values.
Curtis Industries
A Division of Powers Holdings, Inc.
1-800-657-0853
87
相关PDF资料 |
PDF描述 |
|---|---|
| MMZ0603D330C | FERRITE CHIP BEAD 33 OHM SMD |
| PVG5A102C03R00 | TRIMMER 1K OHM 0.25W SMD |
| CD15FD201FO3F | CAP MICA 200PF 500V 1% RADIAL |
| D6R90 F1 LFS | SWITCH PUSH SPST-NO 0.1A 32V |
| HSM536-32.0000 | OSCILLATOR 32MHZ HCMOS SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| F1780DD20 | 功能描述:FILTER HI PERFORM 20A SCREW RoHS:是 类别:滤波器 >> 线路滤波器 系列:F1780 RoHS指令信息:RoHS Material 标准包装:1 系列:RSEN 滤波器类型:电源线 电压 - 额定:250V 电流:150A 电感:- 安装类型:底座安装 端接类型:端接块 其它名称:RSEN2150 |
| F17831-000 | 制造商:TE Connectivity 功能描述:VARISTOR 560V 5MM RADIAL 制造商:TE Connectivity 功能描述:VARISTOR 560V 400A DISC 5MM 制造商:TE CONNECTIVITY RAYCHEM-POLYSWITCH 功能描述:Var MOV 350VAC 460VDC 400A 560V Thru-Hole Bulk |
| F17833BR | 制造商:Thomas & Betts 功能描述:PARTS - 10 |
| F17834A | 制造商:Thomas & Betts 功能描述:REPL GASKET,30A,MG,REC/NLT/CON |
| F17839A | 制造商:Thomas & Betts 功能描述:REPL GASKET,60A,MG,REC/NLT/CON |
发布紧急采购，3分钟左右您将得到回复。