- 您现在的位置：买卖IC网 > PDF目录67428 > F2410-R (POWER-ONE INC) 1 FUNCTIONS, 45 V, 10 A, DATA LINE FILTER MODULE PDF资料下载
参数资料
| 型号： | F2410-R |
| 厂商： | POWER-ONE INC |
| 元件分类： | 数据传输滤波器 |
| 英文描述： | 1 FUNCTIONS, 45 V, 10 A, DATA LINE FILTER MODULE |
| 文件页数： | 8/41页 |
| 文件大小： | 1387K |
| 代理商： | F2410-R |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页
MCD10059 Rev. 1.0
Page 16 of 41
www.power-one.com
F & FC Series DC-DC Converter Input Filters
FC Series, 0-100V, 5/10/20 Amps, TH Mount
Design Considerations
Switching Power Converter modules, because they are essentially constant efficiency over the input voltage range, must be
connected to a low AC impedance source of DC voltage.
A constant efficiency power module exhibits an input voltage versus current characteristic which electrically resembles a
negative resistor in the normal operating range of the module. Constant efficiency means that if the output power is held
constant, the input power will remain constant across the operating input voltage range. If the source voltage rises, the
current drawn from the source will fall, to maintain a constant product of voltage and current, hence, constant input power.
This characteristic is that of a negative resistor. When a negative resistance is fed from a positive source impedance which
has a greater magnitude than that of the negative resistance, either the system crashes or it becomes unstable. A good
general rule is that the magnitude of the source impedance must be lower than the magnitude of the input impedance of the
module, at all frequencies up to the switching frequency of the module. (The classic reference is Middlebrook and Cuk, “Input
Filter Considerations in Design and Application of Switching Regulators,” Advances in Switched-Mode Power Conversion, pp
91-107, TeslaCo, 1981.) This rule is especially important, and harder to follow, with higher power modules because the
magnitude of the negative input impedance is lower.
The normal solution is to place a low impedance capacitor directly across the input terminals of the module. 100 to 220 F is
usually recommended for output power levels up to 300 Watts. This capacitor insures that the magnitude of the source
impedance is lower than that of the module input impedance. Note: this assumes that the DC source resistance is sufficiently
low; nothing can correct this problem. Too high a DC source resistance means that the necessary energy required by the
input of the module is not available, and this system will not work.
Use of the capacitor complicates the system design. There must be some consideration of the surge current required to
charge the capacitor when power is first applied. A surge limiting mechanism may be required. The capacitor may form a
resonant circuit with the inductance of an EMI filter. If this happens, the resonance will require damping. The capacitor must
be rated to handle all of the reflected ripple current of the module. Adding damping in the form of a resistor in series with the
capacitor may reduce the ripple current in the capacitor. A small value, high ripple current capacitor may then be required in
parallel with the damped electrolytic in order to meet the EMI requirements. The system designer must evaluate all of these
requirements and make the correct choices for the application.
Figure 1. Application of Input Filters
相关PDF资料 |
PDF描述 |
|---|---|
| F2410-S | 1 FUNCTIONS, 45 V, 10 A, DATA LINE FILTER MODULE |
| F2410 | 1 FUNCTIONS, 45 V, 10 A, DATA LINE FILTER MODULE |
| F4810-R | 1 FUNCTIONS, 80 V, 10 A, DATA LINE FILTER MODULE |
| F4810-S | 1 FUNCTIONS, 80 V, 10 A, DATA LINE FILTER MODULE |
| F4810 | 1 FUNCTIONS, 80 V, 10 A, DATA LINE FILTER MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| F2410-RG | 制造商:Power-One 功能描述:Electromechanical Filter 50Ohm 4.5uH 10ADC 制造商:Power-One 功能描述:EM FLTR 50OHM - Bulk |
| F24-12-A | 功能描述:线性和开关式电源 24V 12A RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压（通道 1）:20 V 输出电流（通道 1）:40 A 商用/医用: 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:Rack 长度: 宽度: 高度: |
| F24-12-A+ | 功能描述:线性和开关式电源 24V 12A RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压（通道 1）:20 V 输出电流（通道 1）:40 A 商用/医用: 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:Rack 长度: 宽度: 高度: |
| F24-12-A+G | 功能描述:线性和开关式电源 24V 12A RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压（通道 1）:20 V 输出电流（通道 1）:40 A 商用/医用: 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:Rack 长度: 宽度: 高度: |
| F24-12-AG | 功能描述:线性和开关式电源 24V 12A RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压（通道 1）:20 V 输出电流（通道 1）:40 A 商用/医用: 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:Rack 长度: 宽度: 高度: |
发布紧急采购，3分钟左右您将得到回复。