- 您现在的位置：买卖IC网 > PDF目录67411 > FA5305AS 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | FA5305AS |
| 元件分类： | 稳压器 |
| 英文描述： | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | SOP-8 |
| 文件页数： | 2/17页 |
| 文件大小： | 280K |
| 代理商： | FA5305AS |
FA5304AP(S)/FA5305AP(S)
10
s Design advice
1. Startup circuit
It is necessary to start-up IC that the voltage inclination of VCC
terminal “dVcc/dt” satisfies the following equation(4).
dVcc/dt(V/s)>1.8/(Cs(
F)).................................(4)
Cs : capacitor connected between CS terminal and GND
Note that equation (4) must be satisfied in any condition. Also,
it is necessary to keep “latch mode” for overload protection or
overvoltage protection that the current supplied to VCC
terminal through startup resistor satisfies the following
equation(5).
Icc(Lat)>0.4mA for Vcc
9.2V.......................(5)
Icc(Lat): Cutoff-state(=Latch mode) supply current
The detail is explained as follows.
(1) Startup circuit connected to AC line directly
Fig. 20 shows a typical startup circuit that a startup resistor Rc
is connected to AC line directly. The period from power-on to
startup is determined by Rc, RD and CA. Rc, RD and CA must
be designed to satisfy the following equations.
dVcc/dt(V/s)=
(1/CA) {(VAVE–Vccon )/RC–Vccon/RD–Iccst} >
1.8/(Cs(
F)).....................................................(6)
Rc(k
)< (VAVE–9.2(V))/{0.4 (mA) + (9.2(V)/RD(k) } ...........(7)
VAVE = Vac
2/
π: Average voltage applied to AC line side of Rc
Vac:
AC input effective voltage
Vccon: ON threshold of UVLO, 16.5V(max.)
Iccst:
Standby current, 0.15 mA(max.)
In this method, Vcc voltage includes ripple voltage influenced
by AC voltage. Therefore, enough dVcc/dt required by
equation (6) tend to be achieved easily when Vcc reaches to
Vccon even if Vcc goes up very slowly.
After power-off, Vcc does not rise up because a voltage
applied from bias winding to VCC terminal decreases and the
current flowing RC becomes zero, therefore, re-startup does
not occur after Vcc falls down below OFF threshold of UVLO
until next power-on.
Fig. 20 Startup circuit example(1)
相关PDF资料 |
PDF描述 |
|---|---|
| FA5304AS | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5305AP | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDIP8 |
| FA5304AP | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDIP8 |
| FA5314S | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5310BP | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDIP8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FA531 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:FA531硅NPN型超高频大功率晶体管 |
| FA5310 | 制造商:FUJI 制造商全称:Fuji Electric 功能描述:Bipolar IC For Switching Power Supply Control |
| FA5310BP | 制造商:FUJI 制造商全称:Fuji Electric 功能描述:Bipolar IC For Switching Power Supply Control |
| FA5310BP(S) | 制造商:未知厂家 制造商全称:未知厂家 功能描述: |
| FA5310BPS | 制造商:FUJI 制造商全称:Fuji Electric 功能描述:Bipolar IC For Switching Power Supply Control |
发布紧急采购，3分钟左右您将得到回复。