- 您现在的位置：买卖IC网 > PDF目录68993 > FA5310BS (FUJI ELECTRIC CO LTD) 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | FA5310BS |
| 厂商： | FUJI ELECTRIC CO LTD |
| 元件分类： | 稳压器 |
| 英文描述： | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | SOP-8 |
| 文件页数： | 19/19页 |
| 文件大小： | 2198K |
| 代理商： | FA5310BS |
DIS
CO
NT
INU
ED
Se
pte
mb
er
200
2
33
FA531X series
s Design advice
1. Startup circuit
It is necessary to start-up IC that the voltage inclination of
VCC terminal “dVcc/dt” satisfies the following equation(4).
dVcc/dt(V/s)>1.8/Cs(
F)...............................(4)
Cs : Capacitor connected between CS terminal and GND
Note that equation (4) must be satisfied in any condition. Also,
it is necessary to keep “latch mode” for overload protection or
overvoltage protection that the current supplied to VCC
terminal through startup resistor satisfies the following
equation(5).
Icc(Lat)> 0.4mA for Vcc
9.2V ..................(5)
Icc(Lat) : Cutoff-state( = Latch mode ) supply current
The detail is explained as follows.
(1) Startup circuit connected to AC line directly
Fig. 20 shows a typical startup circuit that a startup
resistor Rc is connected to AC line directly. The period from
power-on to startup is determined by Rc, RD and CA. Rc, RD
and CA must be designed to satisfy the following equations.
dVcc/dt(V/s)=
(1/CA) {(VAVE–Vccon )/RC–Vccon/RD–Iccst} >
1.8/(Cs(
F))................................................(6)
Rc(k
)< (VAVE–9.2(V))/{0.4 (mA) + (9.2(V)/RD(k) } ...........(7)
VAVE = Vac 2/
π : Average voltage applied to AC line side of Rc
Vac:
AC input effective voltage
Vccon: ON threshold of UVLO, 16.5V(max.) or 16.2V(max.)
Iccst:
Standby current, 0.15 mA(max.)
In this method, Vcc voltage includes ripple voltage influenced
by AC voltage. Therefore, enough dVcc/dt required by
equation (6) tend to be achieved easily when Vcc reaches to
Vccon even if Vcc goes up very slowly. After power-off, Vcc
does not rise up because a voltage applied from bias winding
to VCC terminal decreases and the current flowing RC be-
comes zero, therefore, re-startup does not occur after Vcc falls
down below OFF threshold of UVLO until next power-on.
Fig. 20 Startup circuit example(1)
相关PDF资料 |
PDF描述 |
|---|---|
| FA5311BS | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5315S | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5501N | 1 A SWITCHING CONTROLLER, PDSO8 |
| FA5501P | 1 A SWITCHING CONTROLLER, PDIP8 |
| FA5500N | 1 A SWITCHING CONTROLLER, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FA5310P | 制造商:未知厂家 制造商全称:未知厂家 功能描述: |
| FA5311 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| FA5311BP | 制造商:FUJI 制造商全称:Fuji Electric 功能描述:Bipolar IC For Switching Power Supply Control |
| FA5311BP(S) | 制造商:未知厂家 制造商全称:未知厂家 功能描述: |
| FA5311BPS | 制造商:FUJI 制造商全称:Fuji Electric 功能描述:Bipolar IC For Switching Power Supply Control |
发布紧急采购，3分钟左右您将得到回复。