- 您现在的位置：买卖IC网 > PDF目录14403 > FAN2002MPX (Fairchild Semiconductor)IC REG BUCK SYNC ADJ 1A 6MLP PDF资料下载
参数资料
| 型号： | FAN2002MPX |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 8/11页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 1A 6MLP |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 5.5 V |
| 输入电压： | 2.5 V ~ 5.5 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 1.3MHz |
| 电流 - 输出： | 1A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-MLP |
| 包装： | 标准包装 |
| 供应商设备封装： | 6-MLP（3x3） |
| 产品目录页面： | 1214 (CN2011-ZH PDF) |
| 其它名称： | FAN2002MPXDKR |
? I L = V OUT × -----------------------------------------
UVLO and Soft Start
The reference and the circuit remain reset until the V IN crosses
its UVLO threshold.
The FAN2001/FAN2002 has an internal soft-start circuit that
limits the in-rush current during start-up. This prevents possible
voltage drops of the input voltage and eliminates the output volt-
age overshoot. The soft-start is implemented as a digital circuit
increasing the switch current in four steps to the P-channel cur-
rent limit (1500mA). Typical start-up time for a 20μF output
capacitor and a load current of 1000mA is 800μs.
This is calculated as follows:
1 – ( V OUT ? V IN )
L × f
where:
? I L = Inductor Ripple Current
f = Switching Frequency
L = Inductor Value
Some recommended inductors are suggested in the table
below:
Short Circuit Protection
The switch peak current is limited cycle-by-cycle to a typical
value of 1500mA. In the event of an output voltage short circuit,
the device operates with a frequency of 400kHz and minimum
Inductor Value
3.3μH
3.3μH
Vendor
Panasonic
Murata
Part Number
ELL6PM3R3N
LQS66C3R3M04
duty cycle, therefore the average input current is typically
200mA.
Thermal Shutdown
When the die temperature exceeds 150°C, a reset occurs and
will remain in effect until the die cools to 130°C, at that time the
circuit will be allowed to restart.
Applications Information
Table 1: Recommended Inductors
Capacitors Selection
For best performances, a low ESR input capacitor is required. A
ceramic capacitor of at least 10μF, placed as close to the V IN
and AGND pins of the device is recommended. The output
capacitor determines the output ripple and the transient
response.
Setting the Output Voltage
The internal reference is 0.8V (Typical). The output voltage is
divided by a resistor divider, R1 and R2 to the FB pin. The out-
put voltage is given by:
Capacitor
Value
10μF
Vendor
Taiyo Yuden
Part Number
JMK212BJ106MG
JMK316BJ106KL
V OUT = V REF ? 1 + ------- ?
R 1
? R 2 ?
Where R 1 + R 2 < 800K ? .
According to this equation, and assuming desired output volt-
TDK
Murata
C2012X5ROJ106K
C3216X5ROJ106M
GRM32ER61C106K
age of 1.5096V, and given R2 = 10K ? , the calculated value of
R1 is 8.87K ? . If quiescent current is a key design parameter a
higher value feedback resistor can be used (e.g. R2 = 100K ? )
and a small bypass capacitor of 10pF is required in parallel with
the upper resistor as shown in Figure 4.
Table 2: Recommended Capacitors
PCB Layout Recommendations
The recommended PCB layout is shown in Figures 5 and 6. The
inherently high peak currents and switching frequency of power
supplies require a careful PCB layout design.
C IN
10 μ F
V IN
PGND
EN
1
2
3
P1
(AGND)
6
5
4
SW
3.3 μ H
NC R1
FB
C f
50K ?
V OUT
1.2V (1A)
C OUT
2 x 10 μ F
R2
100K ?
Figure 4. Setting the Output Voltage
Inductor Selection
The inductor parameters directly related to the device’s perfor-
mances are saturation current and dc resistance. The FAN2001/
FAN2002 operates with a typical inductor value of 3.3μH. The
lower the dc resistance, the higher the ef?ciency. For saturation
current, the inductor should be rated higher than the maximum
load current plus half of the inductor ripple current.
Figure 5. Recommended PCB Layout (FAN2001)
FAN2001/FAN2002 Rev. 1.0.2
8
www.fairchildsemi.com
相关PDF资料 |
PDF描述 |
|---|---|
| LQW15AN3N9D00D | INDUCTOR |
| LQW15AN36NJ00D | INDUCTOR |
| RCM30DCMH-S288 | CONN EDGECARD 60POS .156 EXTEND |
| RCM30DCMD-S288 | CONN EDGECARD 60POS .156 EXTEND |
| LQW15AN30NJ00D | INDUCTOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FAN2011 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:1.5A Low Voltage Current Mode Synchronous PWM Buck Regulator |
| FAN2011_06 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:1.5A Low Voltage Current Mode Synchronous PWM Buck Regulator |
| FAN2011_ACA3086B WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| FAN2011EMPX | 功能描述:直流/直流开关转换器 ANG FG 1.5a Syncr. Switcher RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| FAN2011I | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:1.5A Low Voltage Current Mode Synchronous PWM Buck Regulator |
发布紧急采购，3分钟左右您将得到回复。