- 您现在的位置：买卖IC网 > PDF目录17276 > FAN3122TMX (Fairchild Semiconductor)IC GATE DVR SGL 9A TTL 8-SOIC PDF资料下载
参数资料
| 型号： | FAN3122TMX |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 16/21页 |
| 文件大小： | 0K |
| 描述： | IC GATE DVR SGL 9A TTL 8-SOIC |
| 特色产品： | FAN3111/FAN3121/FAN3122 Single 1A & 9A High Speed, Low-Side Gate Drivers |
| 标准包装： | 2,500 |
| 配置： | 低端 |
| 输入类型： | 非反相 |
| 延迟时间： | 23ns |
| 电流 - 峰： | 11.4A |
| 配置数： | 1 |
| 输出数： | 1 |
| 电源电压： | 4.5 V ~ 18 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOICN |
| 包装： | 带卷 (TR) |
| 其它名称： | FAN3122TMX-ND FAN3122TMXTR |
Thermal Guidelines
Gate drivers used to switch MOSFETs and IGBTs at
high frequencies can dissipate significant amounts of
power. It is important to determine the driver power
dissipation and the resulting junction temperature in the
application to ensure that the part is operating within
acceptable temperature limits.
The total power dissipation in a gate driver is the sum of
two components, P GATE and P DYNAMIC :
T B = board temperature in location as defined in
the Thermal Characteristics table.
In a full-bridge synchronous rectifier application, shown
in Figure 53, each FAN3122 drives a parallel
combination of two high-current MOSFETs, (such as
FDMS8660S). The typical gate charge for each SR
MOSFET is 70 nC with V GS = V DD = 9V. At a switching
frequency of 300 kHz, the total power dissipation is:
P TOTAL = P GATE + P DYNAMIC
(1)
P GATE = 2 ? 70 nC ? 9V ? 300 kHz = 0.378 W
(5)
Gate Driving Loss: The most significant power loss
results from supplying gate current (charge per unit
time) to switch the load MOSFET on and off at the
P DYNAMIC = 2 mA ? 9 V = 18 mW
P TOTAL = 0.396 W
(6)
(7)
switching frequency. The power dissipation that
results from driving a MOSFET at a specified gate-
source voltage, V GS , with gate charge, Q G , at
switching frequency, f SW , is determined by:
P GATE = Q G ? V GS ? f SW (2)
Dynamic Pre-drive / Shoot-through Current: A
power loss resulting from internal current
consumption under dynamic operating conditions,
including pin pull-up / pull-down resistors, can be
obtained using the “IDD (No-Load) vs. Frequency”
graphs in Typical Performance Characteristics to
determine the current I DYNAMIC drawn from V DD
under actual operating conditions:
The SOIC-8 has a junction-to-board thermal
characterization parameter of ψ JB = 42°C/W. In a system
application, the localized temperature around the device
is a function of the layout and construction of the PCB
along with airflow across the surfaces. To ensure
reliable operation, the maximum junction temperature of
the device must be prevented from exceeding the
maximum rating of 150°C; with 80% derating, T J would
be limited to 120°C. Rearranging Equation 4 determines
the board temperature required to maintain the junction
temperature below 120°C:
T B,MAX = T J - P TOTAL ? ψ JB (8)
T B,MAX = 120°C – 0.396 W ? 42°C/W = 104°C (9)
P DYNAMIC = I DYNAMIC ? V DD
(3)
For comparison, replace the SOIC-8 used in the
Once the power dissipated in the driver is determined,
the driver junction rise with respect to circuit board can
be evaluated using the following thermal equation,
assuming ψ JB was determined for a similar thermal
design (heat sinking and air flow):
T J = P TOTAL ? ψ JB + T B (4)
where:
T J = driver junction temperature;
ψ JB = (psi) thermal characterization parameter relating
temperature rise to total power dissipation; and
? 2008 Fairchild Semiconductor Corporation
FAN3121 / FAN3122 ? Rev. 1.0.3
previous example with the 3x3 mm MLP package with
ψ JB = 2.8°C/W. The 3x3 mm MLP package can operate
at a PCB temperature of 118°C, while maintaining the
junction temperature below 120°C. This illustrates that
the physically smaller MLP package with thermal pad
offers a more conductive path to remove the heat from
the driver. Consider tradeoffs between reducing overall
circuit size with junction temperature reduction for
increased reliability.
www.fairchildsemi.com
16
相关PDF资料 |
PDF描述 |
|---|---|
| 695D105X9020A4T | CAP TANT 1UF 20V 10% 1305 |
| ASPI-0403S-222M-T | INDUCTOR POWER 2200UH 20% SMD |
| MCZ33879AEK | IC SERIAL SWITCH OCTAL 32-SOIC |
| ESM10DSEI-S13 | CONN EDGECARD 20POS .156 EXTEND |
| 695D105X0020A4T | CAP TANT 1UF 20V 20% 1305 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FAN3122TMX_F085 | 功能描述:功率驱动器IC Single 9A L-Side Drv RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| FAN3122TMX_F085_12 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:Single 9A High-Speed, Low-Side Gate Driver |
| FAN3180TSX | 功能描述:功率驱动器IC Single 2 A Low-Side Driver w/ 3.3V LDO RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| FAN3182AMX | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| FAN3213 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:Dual-4A, High-Speed, Low-Side Gate Drivers |
发布紧急采购，3分钟左右您将得到回复。