参数资料
| 型号： | FAN4931IP5X |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 10/11页 |
| 文件大小： | 0K |
| 描述： | IC AMP VFA RRIO CMOS SC70-5 |
| 标准包装： | 1 |
| 放大器类型： | 电压反馈 |
| 电路数： | 1 |
| 输出类型： | 满摆幅 |
| 转换速率： | 3 V/µs |
| 增益带宽积： | 3.7MHz |
| -3db带宽： | 3.7MHz |
| 电流 - 输入偏压： | 5pA |
| 电流 - 电源： | 200µA |
| 电流 - 输出 / 通道： | 33mA |
| 电压 - 电源，单路/双路(±)： | 2.3 V ~ 5.25 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-TSSOP（5 引线），SC-88A，SOT-353 |
| 供应商设备封装： | SC-70-5 |
| 包装： | 标准包装 |
| 其它名称： | FAN4931IP5XFSDKR |
2008 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FAN4931 Rev. 1.0.2
8
FAN4931
—
Ultra-Lo
w
Cost,
Ra
il-
to-Rail
I/O,
CM
OS
Amplifier
Application Information
General Description
The FAN4931 amplifier is a single-supply, general-
purpose, voltage-feedback amplifier, fabricated on a bi-
CMOS process. It features a rail-to-rail input and output
and is unity gain stable. The typical non-inverting circuit
schematic is shown in Figure 20.
Figure 20. Typical Non-Inverting Configuration
Input Common-Mode Voltage
The common-mode input range extends to 300 mV below
ground and to 100 mV above VS in single-supply
operation. Exceeding these values does not cause phase
reversal; however, if the input voltage exceeds the rails
by more than 0.5 V, the input ESD devices begin to
conduct. The output stays at the rail during this overdrive
condition. If the absolute maximum input VIN (700 mV
beyond either rail) is exceeded, externally limit the input
current to ±5 mA, as shown in Figure 21.
Figure 21. Circuit for Input Current Protection
Power Dissipation
The maximum internal power dissipation allowed is
directly related to the maximum junction temperature. If
the maximum junction temperature exceeds 150°C,
performance degradation occurs. If the maximum junction
temperature exceeds 150°C for an extended time, device
failure may occur.
Overdrive Recovery
Overdrive of an amplifier occurs when the output and/or
input ranges are exceeded. The recovery time varies
based on whether the input or output is overdriven and
by how much the range is exceeded. The FAN4931
typically recovers in less than 500 ns from an overdrive
condition. Figure 22 shows the FAN4931 amplifier in an
overdriven condition.
Figure 22. Overdrive Recovery
Driving Capacitive Loads
Figure 8 illustrates the response of the amplifier. A small
series resistance (RS) at the output, illustrated in Figure
23, improves stability and settling performance. RS values
in Figure 8 were chosen to achieve maximum bandwidth
with less than 2 dB of peaking. For maximum flatness,
use a larger RS. Capacitive loads larger than 500 pF
require the use of RS.
Figure 23. Typical Topology for Driving a
Capacitive Load
Driving a capacitive load introduces phase-lag into the
output signal, which reduces phase margin in the
amplifier. The unity gain follower is the most sensitive
configuration. In a unity gain follower configuration, the
amplifier requires a 300
Ωseries resistor to drive a
100 pF load.
相关PDF资料 |
PDF描述 |
|---|---|
| FBA08A12U1BS | FAN 80X25MM 12 VOLT W/LOCKED R |
| FBA09A12M1BX | FAN 12V DC 92X25.5 MM |
| FBL08A24H1A | FAN 24VDC 2.52W 80MM |
| FFB03612EHN-BGA | FAN 12VDC 36X28MM PWM/TACH |
| FFB03812VHN-R00 | FAN DC AXIAL 12V 38X28 16000RPM |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FAN5000AMX | 制造商:Fairchild Semiconductor Corporation 功能描述:LOW POWER GFI - Tape and Reel |
| FAN5009 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:Dual Bootstrapped 12V MOSFET Driver |
| FAN5009A WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| FAN5009AM | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| FAN5009AMX | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
发布紧急采购，3分钟左右您将得到回复。