- 您现在的位置：买卖IC网 > PDF目录67490 > FL7930CMX (FAIRCHILD SEMICONDUCTOR CORP) 0.5 A POWER FACTOR CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | FL7930CMX |
| 厂商： | FAIRCHILD SEMICONDUCTOR CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 0.5 A POWER FACTOR CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | MS-012AA, SOP-8 |
| 文件页数： | 6/20页 |
| 文件大小： | 1290K |
| 代理商： | FL7930CMX |
2011 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FL7930 Rev. 1.0.0
14
FL7930
—
Single-Stage
Flyback
and
Bou
ndary-Mode
PFC
Controller
for
Lighting
Because auxiliary winding voltage can swing from
negative voltage to positive voltage, the internal block in
the ZCD pin has both positive and negative voltage
clamping circuits. When the auxiliary voltage is
negative, an internal circuit clamps the negative voltage
at the ZCD pin around 0.65V by sourcing current to the
serial resistor between the ZCD pin and the auxiliary
winding. When the auxiliary voltage is higher than 6.5V,
current is sinked through a resistor from the auxiliary
winding to the ZCD pin.
Figure 32. Auxiliary Voltage Depends
on MOSFET Switching
To check the boost inductor current zero instance,
auxiliary winding voltage is used. When boost inductor
current becomes zero, there is a resonance between
boost inductor and all capacitors at MOSFET drain pin,
including COSS of the MOSFET; an external capacitor at
the D-S pin to reduce the voltage rising and falling slope
of the MOSFET; a parasitic capacitor at inductor; and so
on to improve performance. Resonated voltage is
reflected to the auxiliary winding and can be used for
detecting zero current of boost inductor and valley
position of MOSFET voltage stress. For valley detection,
a minor delay by the resistor and capacitor is needed. A
capacitor increases the noise immunity at the ZCD pin.
If ZCD voltage is higher than 1.5V, an internal ZCD
comparator output becomes HIGH and LOW when the
ZCD goes below 1.4V. At the falling edge of comparator
output, internal logic turns on the MOSFET.
Figure 33. Auxiliary Voltage Threshold
When no ZCD signal is available, the PFC controller
cannot turn on the MOSFET, so the controller checks
every switching off time and forces MOSFET turn on
when the off time is longer than 150μs. This is called
restart timer. The restart timer triggers MOSFET turn-on
at startup and may be used at the input voltage-zero
cross period.
s
150
Figure 34. Restart Timer at Startup
Because the MOSFET turn on depends on the ZCD
input, switching frequency may increase to higher than
several megahertz due to mis-triggering or noise on the
nearby ZCD pin. If the switching frequency is higher
than needed for critical conduction mode (CRM),
operation mode shifts to continuous conduction mode
(CCM). In CCM, unlike CRM where the boost inductor
current is reset to zero at the next switch on; inductor
current builds up at every switching cycle and can be
raised to high current that exceeds the current rating of
the power switch or diode. This can seriously damage
the power switch and result in burn down. To avoid this,
maximum switching frequency limitation is embedded. If
ZCD signal is applied again within 3.3μs after the
previous rising edge of the gate signal, this signal is
ignored internally and FL7930 waits for another ZCD
signal. This slightly degrades the power factor
performance at light load and high input voltage.
Figure 35. Maximum Switching Frequency
Limit Operation
7. Control
: The scaled output is compared with the
internal reference voltage and sinking or sourcing
current is generated from the COMP pin by the
transconductance amplifier. The error amplifier output is
compared with the internal sawtooth waveform to give
proper turn-on time based on the controller.
相关PDF资料 |
PDF描述 |
|---|---|
| FL7930CM | 0.5 A POWER FACTOR CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO8 |
| FL7930BMX | 0.5 A POWER FACTOR CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO8 |
| FLT007A0-SRZ | 1 FUNCTIONS, 75 V, 7 A, DATA LINE FILTER MODULE |
| FLT007A0Z | 2 FUNCTIONS, 75 V, 7 A, DATA LINE FILTER MODULE |
| FLTR100V206Z | 75 V, SINGLE PHASE EMI FILTER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FL7930CMX_G | 制造商:Fairchild Semiconductor Corporation 功能描述:IC PFC CTLR FLYBACK/BOUND 8SOIC |
| FL793-F8 | 制造商:BACO Controls Inc 功能描述: |
| FL7B5BH | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Ball-Grid-Array Thin Film Low-Pass Filter |
| FL7KM12A | 制造商:未知厂家 制造商全称:未知厂家 功能描述:TRANSISTOR | MOSFET | N-CHANNEL | 600V V(BR)DSS | 7A I(D) | TO-220FN |
| FL7KM-12A | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:MITSUBISHI Nch POWER MOSFET HIGH-SPEED SWITCHING USE |
发布紧急采购，3分钟左右您将得到回复。