- 您现在的位置：买卖IC网 > Datasheet目录622 > FNB41560B2 (Fairchild Semiconductor)MODULE SPM ADV 600V 15A SPM26 Datasheet资料下载
参数资料
| 型号： | FNB41560B2 |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 13/16页 |
| 文件大小： | 0K |
| 描述： | MODULE SPM ADV 600V 15A SPM26 |
| 标准包装： | 12 |
| 系列： | SPM™ |
| 类型： | IGBT |
| 配置： | 三相反相器 |
| 电流： | 15A |
| 电压： | 600V |
| 电压 - 隔离： | 2000Vrms |
| 封装/外壳： | 模块 |
(26) V B(U)
HVIC
VB(U)
P (3)
Gating UH
R S
C BS
C BSC
(25) V S(U)
(20) IN (UH)
VS(U)
IN(UH)
OUT(UH)
VS(U)
U (4)
(24) V B(V)
VB(V)
C BS
C BSC
(23) V S(V)
Gating VH
R S
(19) IN (VH)
VS(V)
IN(VH)
OUT(VH)
C BS
C BSC
(22) V B(W)
(21) V S(W)
VB(W)
VS(W)
VS(V)
V (5)
M
M
C
Gating WH
R S
C PS
C PS
C PS
+15 V
C SP15
C SPC15
(18) IN (WH)
(17) V CC(H)
(15) COM
IN(WH)
VCC
COM
OUT(WH)
VS(W)
W (6)
C DCS
V DC
U
+5 V
(16) V CC(L)
LVIC
VCC
Fault
Gating UL
Gating VL
C BPF
R S
R PF
C PF
R S
R S
C SPC05 C SP05
(11) V FO
(14) IN (UL)
(13) IN (VL)
VFO
IN(UL)
IN(VL)
OUT(UL)
OUT(VL)
N U (7)
N V (8)
R SU
R SV
Gating WL
R S
C PS C PS C PS
C SC
R F
(12) IN (WL)
(10) C SC
(1) V TH
IN(WL)
COM
CSC
OUT(WL)
N W (9)
R SW
R TH
(2) R TH
THERMISTOR
Input Signal for
Short-Circuit Protection
Temp. Monitoring
U-Phase Current
V-Phase Current
W-Phase Current
Figure 15. Typical Application Circuit
3rd Notes:
1) To avoid malfunction, the wiring of each input should be as short as possible (less than 2 - 3 cm).
2) By virtue of integrating an application-specific type of HVIC inside the Motion SPM ? 45 product, direct coupling to MCU terminals without any optocoupler or transformer isola-
tion is possible.
3) V FO output is open-drain type. This signal line should be pulled up to the positive side of the MCU or control power supply with a resistor that makes I FO up to 1 mA (please
refer to Figure 14).
4) C SP15 of around seven times larger than bootstrap capacitor C BS is recommended.
5) Input signal is active-HIGH type. There is a 5 k ? resistor inside the IC to pull down each input signal line to GND. RC coupling circuits is recommanded for the prevention of
input signal oscillation. R S C PS time constant should be selected in the range 50 ~ 150 ns ( recommended R S = 100 ? , C PS = 1 nF).
6) To prevent errors of the protection function, the wiring around R F and C SC should be as short as possible.
7) In the short-circuit protection circuit, please select the R F C SC time constant in the range 1.5 ~ 2 ? s.
8) The connection between control GND line and power GND line which includes the N U , N V , N W must be connected to only one point. Please do not connect the control GND
to the power GND by the broad pattern. Also, the wiring distance between control GND and power GND should be as short as possible.
9) Each capacitor should be mounted as close to the pins of the Motion SPM 45 product as possible.
10) To prevent surge destruction, the wiring between the smoothing capacitor and the P & GND pins should be as short as possible. The use of a high-frequency non-inductive
capacitor of around 0.1 ~ 0.22 ? F between the P and GND pins is recommended.
11) Relays are used in almost every systems of electrical equipment in home appliances. In these cases, there should be sufficient distance between the MCU and the relays.
12) The zener diode or transient voltage suppressor should be adopted for the protection of ICs from the surge destruction between each pair of control supply terminals
(recommanded zener diode is 22 V / 1 W, which has the lower zener impedance characteristic than about 15 ? ).
13) Please choose the electrolytic capacitor with good temperature characteristic in C BS . Also, choose 0.1 ~ 0.2 ? F R-category ceramic capacitors with good temperature and
frequency characteristics in C BSC .
14) For the detailed information, please refer to the AN-9070, AN-9071, AN-9072, RD-344, and RD-345.
?2011 Fairchild Semiconductor Corporation
FNB41560 / FNB41560B2 Rev. C3
13
www.fairchildsemi.com
相关PDF资料 |
PDF描述 |
|---|---|
| FNB41560 | MOD ADV SMART POWER SPM26-AA |
| FP10-1200 | TRANSF 5VAC 2.4A FLAT PACK PWR |
| FP10-250 | TRANSF 5VAC .5A FLAT PACK PWR |
| FP10-600 | TRANSF 5VAC 1.2A FLAT PACK PWR |
| FP12-200 | TRANSF 6.3VAC .4A FLAT PACK PWR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FNC.5B.364.CLAD13 | 功能描述:环形推拉式连接器 STRAIGHT PLUG MALE CABLE COLLET RoHS:否 制造商:Hirose Connector 产品类型:Connectors 系列:HR10 触点类型:Socket (Female) 外壳类型:Receptacle 触点数量:4 外壳大小:7 安装风格:Panel 端接类型:Solder 电流额定值:2 A |
| FNC000011 | 功能描述:OSC 120MHZ 3.3V SMD RoHS:是 类别:晶体和振荡器 >> 振荡器 系列:SaRonix-eCera™ FN 标准包装:1 系列:VG-4512CA 类型:VCXO 频率:153.6MHz 功能:三态（输出启用） 输出:LVPECL 电源电压:3.3V 频率稳定性:- 工作温度:-40°C ~ 85°C 电流 - 电源（最大）:60mA 额定值:- 安装类型:表面贴装 尺寸/尺寸:0.276" L x 0.197" W（7.00mm x 5.00mm） 高度:0.071"（1.80mm） 封装/外壳:6-SMD，无引线（DFN，LCC） 包装:Digi-Reel® 电流 - 电源（禁用）（最大）:- 其它名称:SER3790DKR |
| FNC014 | 功能描述:烙铁 Fan Nozzle/Cap 0.014" Orifice RoHS:否 制造商:Weller 产品:Soldering Stations 类型:Digital, Iron, Stand, Cleaner 瓦特:50 W 最大温度:+ 850 F 电缆类型:US Cord Included |
| FNC028 | 功能描述:烙铁 Fan Nozzle/Cap 0.028" Orifice RoHS:否 制造商:Weller 产品:Soldering Stations 类型:Digital, Iron, Stand, Cleaner 瓦特:50 W 最大温度:+ 850 F 电缆类型:US Cord Included |
| FNC046 | 功能描述:烙铁 Fan Nozzle/Cap 0.046" Orifice RoHS:否 制造商:Weller 产品:Soldering Stations 类型:Digital, Iron, Stand, Cleaner 瓦特:50 W 最大温度:+ 850 F 电缆类型:US Cord Included |
发布紧急采购，3分钟左右您将得到回复。