- 您现在的位置：买卖IC网 > PDF目录67506 > FNP600-12G (POWER-ONE INC) 1-OUTPUT 600 W AC-DC PWR FACTOR CORR MODULE PDF资料下载
参数资料
| 型号： | FNP600-12G |
| 厂商： | POWER-ONE INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 600 W AC-DC PWR FACTOR CORR MODULE |
| 封装： | ROHS COMPLIANT |
| 文件页数： | 8/13页 |
| 文件大小： | 687K |
| 代理商： | FNP600-12G |
105572 Rev. AA2
Page 4 of 13
www.power-one.com
FNP600/850/1000 AC-DC Front-Ends
& FNR-5-12G/FNR-5-48G Power Shelves Data Sheet
Control and Monitoring
Parameter
Conditions/Description
Min.
Nom.
Max.
Units
DC OK
TTL open-collector signal with active
20-mA pull-down. Represents percent
of output voltage where signal is OK.
Below this voltage, a signal high
condition indicates an output which is
out of tolerance. Green DC OK LED on
front panel indicates normal operation.
1
Internally pulled up to 5V with a 5.1 k
resistor. Note.
2
90
110
%
Input Power Fail Warning
TTL open-collector signal with active
20-mA pull-down. High indicates an
input power fail. Power Fail Warning
will turn OFF green AC OK LED.
Represents the time after warning
signal before Vout drops to 95% due to
loss of input power.
1 Internally pulled
up to 5V with a 5.1 k resistor. Note.
2
5
ms
Power Supply Present
Signal
Resistance of connection to logic
ground which allows user to determine
if power supply is present.
1
10
FNP600-12:
Main output only. Difference in current
between two supplies at >10% load
value.
5
FNP850-12:
7
FNP600-48:
2
Current Share
FNP1000-48:
2
A
Remote Sense
Total voltage compensation for cable
losses with respect to the main output.
0.5
V
Output Enable
Open circuit or logic high from ENA pin
to Vo1 RTN shuts OFF Vo1; Vaux and
fan are operational. Logic low (2 mA
sink capability) or jumper will turn ON
Vo1 within 100 ms. Open circuit
voltage on enable pin is 3.3 VDC.
Externally applied voltage to the enable
pin should NOT exceed 7 VDC. Signal
is referred to as Logic Return (LRTN).
1 Also available on I2C data line.
2
A pull-up to 3.3V can be achieved by terminating the logic signal with a 10 k resistor to logic ground.
I
2C Bus Management Interface
Static
Includes static information such as: part number and revision level, output rating, serial number, date code,
and manufacturing location.
Status
(Logic 1 or 0)
Power Supply OK.
AC Input OK.
DC Output OK.
Power Supply Seated.
Overtemperature.
Overcurrent.
Fan OK.
Real-Time Monitoring
Output voltage (main output) 0.1V LSD.
Output current (main output) 0.1A LSD.
Time in service.
Control Signals
Enable for main output.
Output voltage to: (0.01V resolution on 12V supplies;
0.05V resolution on all 48V supplies).
Fan speed level.
相关PDF资料 |
PDF描述 |
|---|---|
| FOX-HC735-250 | CRYSTAL OSCILLATOR, CLOCK, 250 MHz, HCMOS OUTPUT |
| FOX-HC736-250 | CRYSTAL OSCILLATOR, CLOCK, 250 MHz, HCMOS OUTPUT |
| FOX-HC735-106.25 | CRYSTAL OSCILLATOR, CLOCK, 106.25 MHz, HCMOS OUTPUT |
| FPQR48T01214PA | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| FPQR48T01214NA | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FNP600-12RG | 功能描述:线性和开关式电源 600W 12V 51A Rear-front airflow RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压（通道 1）:20 V 输出电流（通道 1）:40 A 商用/医用: 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:Rack 长度: 宽度: 高度: |
| FNP600-48 | 制造商:Power-One 功能描述:AC/DC Power Supply Single-OUT 48V 12.6A 600W |
| FNP600-48G | 功能描述:线性和开关式电源 Front End 600W (48V) RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压（通道 1）:20 V 输出电流（通道 1）:40 A 商用/医用: 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:Rack 长度: 宽度: 高度: |
| FNP600-48R | 制造商:Power-One 功能描述:AC-DC POWER SUPPLY 600 WATT,REVERSE FAN FLOW, - Bulk |
| FNP7 | 制造商:UNBRANDED 功能描述:NAIL PULLER |
发布紧急采购，3分钟左右您将得到回复。