- 您现在的位置：买卖IC网 > PDF目录21524 > FOD260L (Fairchild Optoelectronics Group)OPTOCOUPLER 1CH LOGIC 3.3V 8DIP PDF资料下载
参数资料
| 型号： | FOD260L |
| 厂商： | Fairchild Optoelectronics Group |
| 文件页数： | 4/19页 |
| 文件大小： | 0K |
| 描述： | OPTOCOUPLER 1CH LOGIC 3.3V 8DIP |
| 标准包装： | 1,000 |
| 电压 - 隔离： | 5000Vrms |
| 通道数： | 1，单向 |
| 电流 - 输出 / 通道： | 50mA |
| 数据速率： | 10Mbps |
| 传输延迟高 - 低 @ 如果： | 75ns @ 7.5mA |
| 电流 - DC 正向(If)： | 15mA |
| 输入类型： | DC |
| 输出类型： | 开路集电极 |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-DIP |
| 包装： | 管件 |
Transfer Characteristics (T A = -40°C to +85°C Unless otherwise speci?ed. Typical value is measured at
T A = 25°C and V CC = 3.3V)
Symbol DC Characteristics
Test Conditions
Min.
Typ.
Max.
Unit
I OH
High Level Output Current
I F = 250 μA, V CC = 3.3 V, V O = 3.3 V,
0.01
50
μA
V E = 2.0 V (Note 2)
V OL
Low Level Output Voltage
V CC = 3.3 V, I F = 5 mA, I OL = 13 mA,
0.3
0.6
V
V E = 2.0 V (Note 2)
I FT
Input Threshold Current
V CC = 3.3 V, V O = 0.6 V, I OL = 13 mA,
1
5
mA
V E = 2.0 V (Note 2)
Isolation Characteristics (T A = -40°C to +85°C Unless otherwise speci?ed. Typical value is measured at
T A = 25°C and V CC = 3.3V)
Symbol
I I-O
Characteristics
Input-Output
Test Conditions
Relative humidity = 45%,
Min.
Typ.
Max.
1.0
Unit
μA
Insulation Leakage Current
T A = 25°C, t = 5 s,
V I-O = 3000 VDC (Note 12)
V ISO
Withstand Insulation Test
Voltage
FOD060L
FOD260L
I IO ≤ 2 μA, R H < 50%,
T A = 25°C, t = 1 min.(Note 12)
3750
5000
V RMS
R I-O
Resistance (Input to Output)
V I-O = 500 V (Note 12)
10 12
?
C I-O
Capacitance (Input to Output) f = 1 MHz (Note 12)
0.6
pF
Notes
1. The V CC supply to each optoisolator must be bypassed by a 0.1μF capacitor or larger. This can be either a ceramic
or solid tantalum capacitor with good high frequency characteristic and should be connected as close as possible
to the package V CC and GND pins of each device.
2. Enable Input – No pull up resistor required as the device has an internal pull up resistor.
3. t PLH – Propagation delay is measured from the 3.75 mA level on the HIGH to LOW transition of the input current
pulse to the 1.5V level on the LOW to HIGH transition of the output voltage pulse.
4. t PHL – Propagation delay is measured from the 3.75 mA level on the LOW to HIGH transition of the input current
pulse to the 1.5V level on the HIGH to LOW transition of the output voltage pulse.
5. t PSK is the worst case difference between t PHL and t PLH for any devices at the stated test conditions.
6. t r – Rise time is measured from the 90% to the 10% levels on the LOW to HIGH transition of the output pulse.
7. t f – Fall time is measured from the 10% to the 90% levels on the HIGH to LOW transition of the output pulse.
8. t ELH – Enable input propagation delay is measured from the 1.5V level on the HIGH to LOW transition of the input
voltage pulse to the 1.5V level on the LOW to HIGH transition of the output voltage pulse.
9. t EHL – Enable input propagation delay is measured from the 1.5V level on the LOW to HIGH transition of the input
voltage pulse to the 1.5V level on the HIGH to LOW transition of the output voltage pulse.
10. CM H – The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in the high
state (i.e., V OUT > 2.0 V). Measured in volts per microsecond (V/μs).
11. CM L – The maximum tolerable rate of fall of the common mode voltage to ensure the output will remain in the low
output state (i.e., V OUT < 0.8 V). Measured in volts per microsecond (V/μs).
12. Device considered a two-terminal device: Pins 1, 2, 3 and 4 shorted together, and Pins 5, 6, 7 and 8 shorted
together.
?2008 Fairchild Semiconductor Corporation
FOD060L, FOD260L Rev. 1.0.5
4
www.fairchildsemi.com
相关PDF资料 |
PDF描述 |
|---|---|
| EN4SD161210SS | BOX ST STEEL 16X12X10" NAT |
| FOD260LSDV | OPTOCCOUPLER SGL 3.3V 8-SMD |
| EN4SD16206SS | BOX ST STEEL 16X20X6" NAT |
| 8428-11B1-RK-TP | IC SOCKET 28POS PLCC THRU-HOLE |
| HCPL2611SDV | OPTOCOUPLER SGL TRANS OUT 8-SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FOD260L_11 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:3.3V/5V High Speed-10 MBit/s Logic Gate Optocouplers |
| FOD260LS | 功能描述:高速光耦合器 10 Mbit/s S-CH 3.3V LG Output Optocoup RoHS:否 制造商:Avago Technologies 电流传递比: 最大波特率: 最大正向二极管电压:1.75 V 最大反向二极管电压:5 V 最大功率耗散:40 mW 最大工作温度:+125 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-5 封装:Tube |
| FOD260LSD | 功能描述:高速光耦合器 10 Mbit/s S-CH 3.3V LG Output Optocoup RoHS:否 制造商:Avago Technologies 电流传递比: 最大波特率: 最大正向二极管电压:1.75 V 最大反向二极管电压:5 V 最大功率耗散:40 mW 最大工作温度:+125 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-5 封装:Tube |
| FOD260LSDV | 功能描述:高速光耦合器 10Mbps SingleChannel 3.3V Logic Gate Out RoHS:否 制造商:Avago Technologies 电流传递比: 最大波特率: 最大正向二极管电压:1.75 V 最大反向二极管电压:5 V 最大功率耗散:40 mW 最大工作温度:+125 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-5 封装:Tube |
| FOD260LT | 功能描述:高速光耦合器 10 Mbit/s S-CH 3.3V LG Output Optocoup RoHS:否 制造商:Avago Technologies 电流传递比: 最大波特率: 最大正向二极管电压:1.75 V 最大反向二极管电压:5 V 最大功率耗散:40 mW 最大工作温度:+125 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-5 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。