- 您现在的位置：买卖IC网 > PDF目录7194 > FOD4118SDV (Fairchild Semiconductor)TRIAC DRV ZC 300MA 800V VDE 6SMD PDF资料下载
参数资料
| 型号： | FOD4118SDV |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 4/12页 |
| 文件大小： | 0K |
| 描述： | TRIAC DRV ZC 300MA 800V VDE 6SMD |
| 标准包装： | 1,000 |
| 电压 - 隔离： | 5000Vrms |
| 通道数： | 1 |
| 电压 - 断路： | 800V |
| 输出类型： | 交流过零三端双向可控硅开关 |
| 电流 - 栅极触发电流 (Igt)（最大）： | 1.3mA |
| 电流 - 保持 (Ih)： | 200µA |
| 电流 - DC 正向(If)： | 30mA |
| 电流 - 输出 / 通道： | 300mA |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-SMD |
| 供应商设备封装： | 6-SMD |
| 包装： | 散装 |
Electrical Characteristics (T A = 25°C Unless otherwise specified) (Continued)
Zero Crossing Characteristics
Symbol
V INH
DC Characteristics
Inhibit Voltage (MT1-MT2 voltage
Test Conditions
I F = Rated I FT
Min.
Typ.*
8
Max.
25
Units
V
above which device will not trigger)
I DRM2
Leakage in Inhibited State
I F = Rated I FT ,
20
200
μA
Rated V DRM , off state
Isolation Characteristics
Symbol
V ISO
Characteristics
Input-Output Isolation
Test Conditions
(5)
f = 60Hz, t = 1 min.
Min.
5000
Typ.*
Max.
Units
Vac(rms)
Voltage
*Typical values at T A = 25°C
Notes:
2. Test voltage must be applied within dv/dt rating.
3. All devices are guaranteed to trigger at an I F value less than or equal to max I FT . Therefore, recommended operating
I F lies between max I FT (2mA for FOD410 and FOD4108 and 1.3mA for FOD4116 and FOD4118 and the absolute
max I F (60mA).
4. This is static dv/dt. See Figure 11 for test circuit. Commutating dv/dt is a function of the load-driving thyristor(s) only.
5. Isolation voltage, V ISO , is an internal device dielectric breakdown rating. For this test, Pins 1, 2 and 3 are common,
and Pins 4, 5 and 6 are common.
Typical Application
Typical circuit for use when hot line switching is required.
In this circuit the “hot” side of the line is switched and the
load connected to the cold or neutral side. The load may
be connected to either the neutral or hot line.
R in is calculated so that I F is equal to the rated I FT of the
part, 2mA for FOD410 and FOD4108, 1.3mA for
FOD4116 and FOD4118. The 39 ? resistor and 0.01μF
capacitor are for snubbing of the triac and may or may
not be necessary depending upon the particular triac
and load use.
V CC
R in
1
6
360 ?
HOT
2
FOD410
FOD4108
5
FKPF12N80
3
FOD4116
FOD4118
4
39* ?
240 VAC
330 ?
0.01 μ F
* For highly inductive loads (power factor < 0.5), change this value to 360 ohms.
Figure 1. Hot-Line Switching Application Circuit
LOAD
NEUTRAL
?2004 Fairchild Semiconductor Corporation
FOD410, FOD4108, FOD4116, FOD4118 Rev. 1.5.0
4
www.fairchildsemi.com
相关PDF资料 |
PDF描述 |
|---|---|
| OSTYK22323030 | CONN BARRIER STRIP 23CIRC 6.35MM |
| FOD4118SD | TRIAC DRV ZC 300MA 800V 6-SMD |
| CFTDW-4 | TERM BARRIER 4CIRC SGL ROW .375 |
| OSTYK61418030 | CONN BARRIER STRIP 18CIRC 10MM |
| FOD4118SV | TRIAC DRV ZC 300MA 800V VDE 6SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FOD4118SV | 功能描述:三极与 SCR 输出光电耦合器 Zero-Cross Triac Out Snubberless, 800V RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
| FOD4118T | 功能描述:三极与 SCR 输出光电耦合器 Zero-Cross Triac Out Snubberless, 800V RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
| FOD4118TV | 功能描述:三极与 SCR 输出光电耦合器 Zero-Cross Triac Out Snubberless VDE 800V RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
| FOD4118V | 功能描述:三极与 SCR 输出光电耦合器 Zero-Cross Triac Out Snubberless VDE 800V RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
| FOD420 | 功能描述:三极与 SCR 输出光电耦合器 600V RANDOM PHASE TRIAC RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。