参数资料
型号: FP38
厂商: POWER-ONE INC
元件分类: 数据传输滤波器
英文描述: 1 FUNCTIONS, 40 V, 4 A, DATA LINE FILTER
文件页数: 4/5页
文件大小: 127K
代理商: FP38
Accessories
Filter & Ring Core Chokes FP, L and LP Series
REV. SEP 29, 2003
Page 4 of 5
Input Interference Reduction
Using L- or LP-series chokes together with an additional
external capacitor a similar attenuation can be achieved as
with filter blocks. The capacitor between the choke and the
converter input is necessary in order to avoid possible oscil-
lations caused by the negative input impedance of the regu-
lator. This phenomenon could cause the input voltage to
leave the specified regulator input range. The relatively
high ripple current flowing through the capacitor must be
considered for the design. Refer also to:
Technical Informa-
tion: Installation & Application.
The current compensated choke LP183 has a high perme-
ability ring core with two identical separate windings. The
normal operating current will only see the small stray in-
ductance between the windings. However common mode
interference will be blocked by the full inductance of the
choke.
Fig. 7
Low-loss ring core choke with external capacitor (Cex
approx. 1000
F) used as output filter
Reduction of Output Ripple
Even though switching regulators have an inherently low
output ripple, certain sensitive applications need even fur-
ther reduction. In such cases, the low-loss ring core chokes
designed to reduce disturbances at the input can also be
used for reducing the ripple on the output voltage. The
chokes in combination with an external capacitor can
achieve even better results than the Filter Blocks with re-
gard to the ripple and dynamic regulation.
The formula for the remaining output ripple at the load
RL is
calculated as follows:
UR = uo ZC ext/ZLD
uo:
Output ripple of the regulator
ZCex:
The impedance of the capacitor at the regu-
lator's switching frequency (150 kHz) corre-
sponds to the equivalent series resistance
(ESR) of the capacitor (please refer to the
corresponding data sheet).
ZLD =2
π fS LD
fS:
150 kHz (regulator switching frequency)
Through the use of a common mode choke LP 183, the
common mode noise at the output can also be further re-
duced.
Consider that the filter not only affects the output ripple but
can also influence the voltage
UR across the load RL in the
event of load changes. The static regulation increases with
the ohmic resistance of the choke, i.e. 6 mV/A for the choke
L/LP20-7 and 20 mV/A for the LP34-3.
The dynamic regulation is dependent on the size of the ca-
pacitor. Generally, the bigger
Cex the smaller is the dy-
namic, however, recovery will be slower.
Typical Application
A voltage drop
UrGo = rGo (Io – Ii) is produced across the
ground loop resistance
rGo. It is superimposed upon the
regulators output voltage
Uo and generates the voltage UR
=
Uo – Ur Go across the load resistance RL. Without an input
inductance
Le the current Ii in the input circuit has a rela-
tively high AC component with a basic frequency
fs (regula-
tor's switching frequency of approx. 150 kHz). This alternat-
ing current produces an AC voltage component across
rGo
which is superimposed upon
URL.
To prevent this phenomenon, an inductance
Le can be in-
serted into the input circuit. This causes the AC component
of the input current to be supplied entirely from the input
capacitor
Ce; thus, Ii is a pure direct current. Ce should be
wired as close as possible to the regulator's input terminals
Vi+ and Gi–.
Le and Ce additionally provide protection against input tran-
sients and reduce radio interference voltages.
External connection of Gi– and Go– or connection via a
common ground is not recommended. The internal voltage
drop
UrG in the regulator would be superimposed on the
output voltage.
Vi+
Gi–
Vo+
Go–
PSR
Ce
Uo
U
12014
UR
RL
RD
LD
ZLD
ZC ext
Fig. 5
L/LP type chokes and capacitors used as input filter
Vi+
Gi–
Vo+
Go–
PSR
U
Cext 1
Cext 2
Cext 3
LP34-3 or
L/LP20-7
LP183
12013
Uo
RL
Vi+
Gi–
Vo+
Go–
PSR
RL
Uo
U
Ce
Le
UrG
rGo
rG
UrGo
Io
URL
12015
Fig. 6
Reduction of superimposed interference voltages in
grounded power supply systems, caused by ground loops
相关PDF资料
PDF描述
FP80 1 FUNCTIONS, 80 V, 4 A, DATA LINE FILTER
LP20-7 1 FUNCTIONS, 7 A, DATA LINE FILTER
LP34-3 1 FUNCTIONS, 3 A, DATA LINE FILTER
L20-7 1 FUNCTIONS, 7 A, DATA LINE FILTER
LP22.368MHZ-1961 TELECOM FILTER
相关代理商/技术参数
参数描述
FP-3800DPM 制造商:TE Connectivity 功能描述:
FP385 功能描述:钳型万用表及配件 FUSE .5A/500V 4 PACK RoHS:否 制造商:Fluke 准确性:2 % 测距:400 A
FP3-8R2 制造商:COOPER BUSSMANN 功能描述:Ind Power Wirewound 8.2uH 15% 100KHz 2.91A T/R 制造商:COOPER BUSSMANN 功能描述:Inductor Power Wirewound 8.2uH 15% 100KHz 2.91A 74mOhm DCR T/R
FP3-8R2-R 功能描述:固定电感器 8.2uH 3.4A 74mOhms RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm
FP39/841/HO/ECO 制造商:OSRAM 功能描述:39W, T5 PENTRON HIGH OUTPUT (HO) FLUORESCENT LAMP, 4100K COLOR TEMPERATURE, RARE