参数资料
| 型号： | FSL156MRBN |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 11/16页 |
| 文件大小： | 0K |
| 描述： | IC FPS POWER SWITCH 8-MDIP |
| 标准包装： | 1 |
| 系列： | FPS™ |
| 输出隔离： | 隔离 |
| 频率范围： | 61kHz ~ 73kHz |
| 输入电压： | 8 V ~ 26 V |
| 输出电压： | 650V |
| 功率（瓦特）： | 40W |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-MDIP |
| 包装： | 标准包装 |
| 其它名称： | FSL156MRBNFSDKR |
4.3. Output-Short Protection (OSP) : If the output is
shorted, steep current with extremely high di/dt can
flow through the SenseFET during the minimum turn-
on time. Such a steep current brings high-voltage
stress on the drain of the SenseFET when turned off.
To protect the device from this abnormal condition,
OSP is included. It is comprised of detecting V FB and
SenseFET turn-on time. When the V FB is higher than
2.0V and the SenseFET turn-on time is lower than
1.0 μ s, this condition is recognized as an abnormal
error and PWM switching shuts down until V CC
reaches V START again. An abnormal condition output
short is shown in Figure 22.
Figure 22. Output-Short Protection
5. Soft Burst-Mode Operation : To minimize power
dissipation in Standby Mode, the FSL156MRBN enters
Burst-Mode operation. As the load decreases, the
feedback voltage decreases. As shown in Figure 23, the
device automatically enters Burst Mode when the
feedback voltage drops below V BURL (350mV). At this
point, switching stops and the output voltages start to
drop at a rate dependent on standby current load. This
causes the feedback voltage to rise. Once it passes
V BURH (500mV), switching resumes. The feedback
voltage then falls and the process repeats. Burst Mode
alternately enables and disables SenseFET switching,
reducing switching loss in Standby Mode.
4.4 Over-Voltage Protection (OVP):
If the
secondary-side feedback circuit malfunctions or a
solder defect causes an opening in the feedback path,
the current through the opto-coupler transistor
becomes almost zero. Then V FB climbs up in a similar
manner to the overload situation, forcing the preset
maximum current to be supplied to the SMPS until the
overload protection is triggered. Because more
energy than required is provided to the output, the
output voltage may exceed the rated voltage before
the overload protection is triggered, resulting in the
breakdown of the devices in the secondary side. To
prevent this situation, an OVP circuit is employed. In
general, the V CC is proportional to the output voltage
and the FSL156MRBN uses V CC instead of directly
monitoring the output voltage. If V CC exceeds 24.5V,
an OVP circuit is triggered, resulting in the termination
Figure 23. Burst-Mode Operation
6. Random Frequency Fluctuation (RFF) : Fluctuating
switching frequency of an SMPS can reduce EMI by
spreading the energy over a wide frequency range. The
amount of EMI reduction is directly related to the
switching frequency variation, which is limited internally.
The switching frequency is determined randomly by
external feedback voltage and an internal free-running
oscillator at every switching instant. RFF effectively
scatters EMI noise around typical switching frequency
(67kHz) and can reduce the cost of the input filter
included to meet the EMI requirements (e.g. EN55022).
of the switching operation. To avoid undesired
activation of OVP during normal operation, V CC should
be designed to be below 24.5V.
4.5 Thermal Shutdown (TSD) : The SenseFET and
the control IC on a die in one package makes it easier
for the control IC to detect the over temperature of the
SenseFET. If the temperature exceeds ~135 ? C, the
thermal shutdown is triggered and stops operation.
The FSL156MRBN operates in Auto-Restart Mode
until the temperature decreases to around 75 ? C,
when normal operation resumes.
Figure 24. Random Frequency Fluctuation
? 2012 Fairchild Semiconductor Corporation
FSL156MRBN ? Rev. 1.0.0
11
www.fairchildsemi.com
相关PDF资料 |
PDF描述 |
|---|---|
| FSL206MRBN | IC FPS POWER SWITCH 8-MDIP |
| FSQ0265RLX | IC FPS PWR SWITCH VSC 8A 8-LSOP |
| FSQ0370RNA | IC SWIT PWM GREEN OVP UVLO 8DIP |
| FSQ0465RSWDTU | IC SWIT PWM GREEN OVP HV TO220F |
| FSQ0465RUWDTU | IC SWIT PWM GREEN UVLO HV TO220F |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FSL156MRIN | 功能描述:电源开关 IC - 配电 Green-Mode Fairchild Power Switch RoHS:否 制造商:Exar 输出端数量:1 开启电阻（最大值）:85 mOhms 开启时间（最大值）:400 us 关闭时间（最大值）:20 us 工作电源电压:3.2 V to 6.5 V 电源电流（最大值）: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-5 |
| FSL176MRT | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:Green-Mode Fairchild Power Switch (FPSa?￠) |
| FSL176MRTUDTU | 功能描述:电流型 PWM 控制器 GRN Mode PowerSwitch RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| FSL2 | 制造商:Cooper Crouse-Hinds 功能描述: |
| FSL206MR | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:Green Mode Fairchild Power Switch (FPSa?￠) |
发布紧急采购，3分钟左右您将得到回复。