- 您现在的位置：买卖IC网 > PDF目录19702 > FSL206MRN (Fairchild Semiconductor)IC PWM/SEMSEFET SMPS 0.6A 8-DIP PDF资料下载
参数资料
| 型号： | FSL206MRN |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 9/14页 |
| 文件大小： | 0K |
| 描述： | IC PWM/SEMSEFET SMPS 0.6A 8-DIP |
| 标准包装： | 50 |
| 系列： | FPS™ |
| 输出隔离： | 隔离 |
| 频率范围： | 61kHz ~ 73kHz |
| 输入电压： | 8 V ~ 26 V |
| 输出电压： | 650V |
| 功率（瓦特）： | 12W |
| 工作温度： | -40°C ~ 115°C |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-DIP |
| 包装： | 管件 |
Functional Description
Startup
At startup, an internal high-voltage current source
supplies the internal bias and charges the external
capacitor (C A ) connected to the V CC pin, as illustrated in
Figure 15. An internal high-voltage regulator (HV REG)
located between the V STR and V CC pins regulates the
V CC to 7.8V and supplies operating current. Therefore,
FSL206MR needs no auxiliary bias winding.
Feedback Control
FSL206MR employs Current-Mode control, as shown in
Figure 17. An opto-coupler (such as the FOD817A) and
shunt regulator (such as the KA431) are typically used
to implement the feedback network. Comparing the
feedback voltage with the voltage across the R SENSE
resistor makes it possible to control the switching duty
cycle. When the shunt regulator reference pin voltage
exceeds the internal reference voltage of 2.5V; the opto-
V CC
3
7.8V
V DC,link
V STR
I CH
HV/REG
2
coupler LED current increases, feedback voltage V FB is
pulled down, and the duty cycle is reduced. This
typically occurs when input voltage is increased or
output load is decreased.
C A
V REF
I START
UVLO
Figure 15.
Startup Block
Oscillator Block
The oscillator frequency is set internally and the FPS?
has a random frequency fluctuation function.
Fluctuation of the switching frequency can reduce EMI
by spreading the energy over a wider frequency range
than the bandwidth measured by the EMI test
equipment. The amount of EMI reduction is directly
related to the range of the frequency variation. The
range of frequency variation is fixed internally; however,
its selection is randomly chosen by the combination of
an external feedback voltage and internal free-running
oscillator. This randomly chosen switching frequency
effectively spreads the EMI noise near switching
frequency and allows the use of a cost-effective inductor
instead of an AC input line filter to satisfy world-wide
EMI requirements.
Figure 17. Pulse-Width-Modulation (PWM) Circuit
Leading-Edge Blanking (LEB)
At the instant the internal SenseFET is turned on, the
primary-side capacitance and secondary-side rectifier
diode reverse recovery typically cause a high-current
spike through the SenseFET. Excessive voltage across
the R SENSE resistor leads to incorrect feedback operation
in the Current-Mode PWM control. To counter this
effect, the FPS employs a leading-edge blanking (LEB)
circuit ( see Figure 17 ). This circuit inhibits the PWM
comparator for a short time (t LEB ) after the SenseFET is
turned on.
Protection Circuits
The protective functions include Overload Protection
(OLP), Over-Voltage Protection (OVP), Under-Voltage
Lockout (UVLO), Line Under-Voltage Protection (LUVP),
Abnormal Over-Current Protection (AOCP), and thermal
shutdown (TSD). Because these protection circuits are
fully integrated inside the
IC without external
components, reliability is improved without increasing
cost. Once a fault condition occurs, switching is
terminated and the SenseFET remains off. This causes
Figure 16.
Frequency Fluctuation Waveform
V CC to fall. When V CC reaches the UVLO stop voltage
V STOP (7V), the protection is reset and the internal high-
voltage current source charges the V CC capacitor via the
V STR pin. When V CC reaches the UVLO start voltage
V START (8V), the FPS resumes normal operation. In this
manner, auto-restart can alternately enable and disable
the switching of the power SenseFET until the fault
condition is eliminated.
? 2011 Fairchild Semiconductor Corporation
FSL206MR ? Rev. 1.0.5
www.fairchildsemi.com
相关PDF资料 |
PDF描述 |
|---|---|
| VI-24R-CY-F2 | CONVERTER MOD DC/DC 7.5V 50W |
| V72A12E400B3 | CONVERTER MOD DC/DC 12V 400W |
| VI-24R-CY-F1 | CONVERTER MOD DC/DC 7.5V 50W |
| ACC22DRAI-S734 | CONN EDGECARD 44POS .100 R/A PCB |
| V72A12E400B | CONVERTER MOD DC/DC 12V 400W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FSL214 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Radiation Hardened, SEGR Resistant N-Channel Power MOSFETs |
| FSL214D | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Radiation Hardened, SEGR Resistant N-Channel Power MOSFETs |
| FSL214D1 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Radiation Hardened, SEGR Resistant N-Channel Power MOSFETs |
| FSL214D3 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Radiation Hardened, SEGR Resistant N-Channel Power MOSFETs |
| FSL214R | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Radiation Hardened, SEGR Resistant N-Channel Power MOSFETs |
发布紧急采购，3分钟左右您将得到回复。