- 您现在的位置：买卖IC网 > PDF目录223808 > FT245BL (Future Technology Devices International Ltd) PDF资料下载
参数资料
| 型号： | FT245BL |
| 厂商： | Future Technology Devices International Ltd |
| 元件分类： | 微控制器/微处理器 |
| 中文描述： | SPECIALTY MICROPROCESSOR CIRCUIT, PQFP32 |
| 封装： | 7 X 7 MM, 0.80 MM PITCH, LEAD FREE, LQFP-32 |
| 文件页数： | 10/24页 |
| 文件大小： | 995K |
| 代理商： | FT245BL |
DS245B Version 1.7
Future Technology Devices Intl. Ltd. 2005
Page 18 of 24
FT245BM USB FIFO ( USB - Parallel ) I.C.
Figure 8
USB Self Powered Conguration
Figure 8 illustrates a typical USB self powered conguration. A USB Self Powered device gets its power from its own
POWER SUPPLY and does not draw current from the USB bus. The basic rules for USB Self power devices are as
follows –
a) A Self-Powered device should not force current down the USB bus when the USB Host or Hub Controller is
powered down.
b) A Self Powered Device can take as much current as it likes during normal operation and USB suspend as it has its
own POWER SUPPLY.
c) A Self Powered Device can be used with any USB Host and both Bus and Self Powered USB Hubs
The USB power descriptor option in the EEPROM should be programmed to a value of zero (self powered).
To meet requirement a) the 1.5K pull-up resistor on USBDP is connected to RSTOUT# as per the bus-power circuit.
However, the USB Bus Power is used to control the RESET# Pin of the FT245BM device. When the USB Host or
Hub is powered up RSTOUT# will pull the 1.5K resistor on USB DP to 3.3V, thus identifying the device as a full speed
device to USB. When the USB Host or Hub power is off, RESET# will go low and the device will be held in reset. As
RESET# is low, RSTOUT# will also be low, so no current will be forced down USBDP via the 1.5K pull-up resistor
when the host or hub is powered down. Failure to do this may cause some USB host or hub controllers to power up
erratically.
Note : When the FT245BM is in reset, the FIFO interface pins all go tri-state. These pins have internal 200K pull-up
resistors to VCCIO so they will gently pull high unless driven by some external logic.
VCC
27R
USB "B"
Connector
27R
USB DM
RSTOUT#
8
FT245BM
USB DP
7
5
V
C
V
C
V
C
I
O
3
26
13
1
2
3
4
1k5
33nF
3v3OUT
6
470R
A
V
C
30
0.1uF
G
N
D
G
N
D
A
G
N
D
9
17
29
RESET#
4
10k
4k7
Decoupling Capacitors
10uF
VCC
0.1uF
+
OBSOLETE
相关PDF资料 |
PDF描述 |
|---|---|
| FT245BQ | |
| FT245BM | |
| FTL-1419-3D | FIBER OPTIC TRANSCEIVER, 1290-1340nm, 1250Mbps(Tx), 1250Mbps(Rx), PANEL MOUNT |
| FTLF1321P1BTL | FIBER OPTIC TRANSCEIVER, 1270-1360nm, 2667Mbps(Tx), 2667Mbps(Rx), SURFACE MOUNT, LC CONNECTOR |
| FTLF1321P1WTL | FIBER OPTIC TRANSCEIVER, 1270-1360nm, 2667Mbps(Tx), 2667Mbps(Rx), SURFACE MOUNT, LC CONNECTOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FT245BL/TR | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB FIFO SMD LQFP32 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB FIFO, SMD, LQFP32, 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB FIFO INTERFACE, 480MBPS, LQFP-32; USB Type:FIFO; USB Version:1.1, 2.0; Supply Voltage Min:4.35V; Supply Voltage Max:5.25V; Digital IC Case Style:LQFP; No. of Pins:32; Data Rate:480Mbps; No. of Ports:2; MSL:MSL 3 - 168 hours ;RoHS Compliant: Yes |
| FT245BL-REEL | 功能描述:USB 接口集成电路 USB to Parallel FIFO IC LQFP-32 RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20 |
| FT245BL-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB FIFO ( USB - PARALLEL ) I.C. |
| FT245BM | 功能描述:先进先出 Obsolete See FT245RL RoHS:否 制造商:IDT 电路数量: 数据总线宽度:18 bit 总线定向:Unidirectional 存储容量:4 Mbit 定时类型:Synchronous 组织:256 K x 18 最大时钟频率:100 MHz 访问时间:10 ns 电源电压-最大:3.6 V 电源电压-最小:6 V 最大工作电流:35 mA 最大工作温度:+ 85 C 封装 / 箱体:TQFP-80 封装: |
| FT245BM-TRAY | 功能描述:USB 接口集成电路 Obsolete See FT245RL RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20 |
发布紧急采购，3分钟左右您将得到回复。