- 您现在的位置：买卖IC网 > PDF目录97427 > FTR-1519-V2 FIBER OPTIC TRANSCEIVER, REPEATER, 1540-1570nm, 1250Mbps(Tx), 1250Mbps(Rx), PANEL MOUNT PDF资料下载
参数资料
| 型号： | FTR-1519-V2 |
| 元件分类： | 光收发 |
| 英文描述： | FIBER OPTIC TRANSCEIVER, REPEATER, 1540-1570nm, 1250Mbps(Tx), 1250Mbps(Rx), PANEL MOUNT |
| 文件页数： | 3/8页 |
| 文件大小： | 158K |
| 代理商： | FTR-1519-V2 |
FTR-1519-V2 Extended GBIC Product Specification – November 2007
F i n i s a r
Finisar Corporation November 16, 2007 Rev. B1
Page 3
II.
Electrical Power Interface
Finisar FTR-1519-V2 GBICs have an extended power supply voltage range of 3.15V to
5.5V as described in Table 2. They are compatible with both 5V and 3.3V systems. The
GBIC specification calls for a range of only 4.75V to 5.25 volts. The 6V maximum
voltage is not allowed for continuous operation, however, TX_FAULT and
TX_DISABLE circuitry in Finisar GBICs will function at 6V.
Electrical Power Interface
Parameter
Symbol
Min
Typ
Max
Units
Notes/Conditions
Supply Current
Is
170
250
mA
Maximum Voltage
Vmax
6
V
Surge Current
Isurge
+30
mA
Hot plug, above steady
state current.
Input Voltage
Vcc
3.15
III. Low Speed Signals
RX_LOS, TX_DISABLE, and TX_FAULT are TTL signals as described in Table 3.
MOD_DEF(1) (SCL) and MOD_DEF(2) (SDA) are open drain CMOS signals (see
section VI, “Serial Communication Protocol”). Both MOD_DEF(1) and MOD_DEF(2)
must be pulled up to host_Vcc. If host_Vcc is 3.3V, then they must be pulled to 3.3V. If
host_Vcc is 3.3V, do not pull the MOD_DEF pins to 5V.
For more detailed information, see sections 5.3.1 – 5.3.8 in the GBIC Specification Rev.
5.4
1.
3.3, 5
5.5
V
Referenced to GND
Table 2. Electrical power interface
Low Speed Signals, Electronic
Characteristics
Parameter
Symbol
Min
Max
Units Notes/Conditions
GBIC Output LOW
VOL
0
0.5
V
4.7k to 10k pull-up to host_Vcc,
measured at host side of connector
GBIC Output HIGH
VOH
host_Vcc -
0.5
host_Vcc +
0.3
V
4.7k to 10k pull-up to host_Vcc,
measured at host side of connector
GBIC Input LOW
VIL
0
0.8
V
4.7k to 10k pull-up to Vcc,
measured at GBIC side of
connector
GBIC Input HIGH
VIH
2
Vcc + 0.3
V
4.7k to 10k pull-up to Vcc,
measured at GBIC side of
connector
Table 3. Low speed signals – electronic characteristics
相关PDF资料 |
PDF描述 |
|---|---|
| FTR-8519-3-2.5 | FIBER OPTIC TRANSCEIVER, REPEATER, 820-860nm, 2125Mbps(Tx), 2125Mbps(Rx), PANEL MOUNT |
| FU-60RDF-S5M1 | FIBER OPTIC DFB LASER DIODE EMITTER, 1530-1570nm, 2500Mbps, THROUGH HOLE MOUNT, LC CONNECTOR |
| FWSF-M/D-4-2-LC | FIBER OPTIC WAVELENGTH DIVISION MUX/DEMUX, 1491-1611nm, LC/PC CONNECTOR |
| FWSF-M/D-4-2 | FIBER OPTIC WAVELENGTH DIVISION MUX/DEMUX, 1491-1611nm, SC/PC CONNECTOR |
| GF-6-RA-AHS/312 | CABLE TERMINATED, MALE, RF CONNECTOR, CRIMP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FTR-1619-47 | 制造商:Finisar Corporation 功能描述:TX/RX OPTICAL FIBER 1250MBPS - Trays |
| FTR-1619-49 | 制造商:Finisar Corporation 功能描述:TX/RX OPTICAL FIBER 1250MBPS - Trays |
| FTR-1619-51 | 制造商:Finisar Corporation 功能描述:TX/RX OPTICAL FIBER 1250MBPS - Trays |
| FTR-1619-53 | 制造商:Finisar Corporation 功能描述:TX/RX OPTICAL FIBER 1250MBPS - Trays |
| FTR-1619-55 | 制造商:Finisar Corporation 功能描述:TX/RX OPTICAL FIBER 1250MBPS - Trays |
发布紧急采购，3分钟左右您将得到回复。