- 您现在的位置：买卖IC网 > Datasheet目录226 > FXP7000-48-S (Power-One)FRONT END 3PHASE 7000W 48V Datasheet资料下载
参数资料
| 型号： | FXP7000-48-S |
| 厂商： | Power-One |
| 文件页数： | 2/8页 |
| 文件大小： | 0K |
| 描述： | FRONT END 3PHASE 7000W 48V |
| 标准包装： | 1 |
| 系列： | FXP7000 |
| 类型： | 标准产品 |
| 输出数： | 1 |
| 输出电压： | 48V |
| 输入电压： | 180 ~ 264 VAC，342 ~ 528 VAC |
| 输出 - 1 @ 电流（最大）： | 48 VDC @ 145A |
| 功率（瓦特）： | 7000W |
| 电源类型： | 开关（封闭框架） |
| 应用： | 商用 |
| 安装类型： | 机架安装 |
| 尺寸/尺寸： | 16.96" L x 8.00" W x 5.00" H（430.8mm x 203.2mm x 127.0mm） |
| 工作温度： | 0°C ~ 40°C |
| 效率： | 91% |
| 电源（瓦特）- 最大： | 6960W |
| 批准： | CE，cULus，EN，IEC |
| 线路调节： | 0.15% |
| 负载调整： | 0.2% |
FXP7000 AC-DC Series Data Sheet
Output Specifications
PARAMETER
Output Voltage
DESCRIPTION/CONDITIONS
An additional 1.0 Volt is provided to the output terminals to provide for
MIN
45.6
NOM
48
MAX
50.4
UNITS
V
Adjustment Range
load lead losses.
Output Power
Output Current
Continuous duty rating.
Continuous duty rating.
7000
145
Watts
A
Efficiency
Full rated load (208Vac).
88
91
%
Regulation
Load, Maximum deviation with 0 to 100% load change:
With Remote Sense connected:
0.2
Ripple & Noise
With Remote Sense not connected:
Utilizing Droop Current Share:
Line, Under all specified operating conditions.
Measured at mating connector w/ 0.01μF + 10μF Tant.
20 MHz BW:
100 MHz BW:
0.75
2.0
0.2
1
2
%
% p-p
Overshoot / Undershoot
Minimum Loads
Output voltage overshoot/undershoot at turn-on.
Minimum loading required to maintain regulation.
0
0
%
A
Transient Response
Turn-On Delay
Turn-on Rise Time
Maximum recovery time, to within 1% of initial set
point due to a 25% load change, 1A/μS.
Time required for initial output voltage stabilization after power-up.
Time required for output voltage to rise from 10% to 90%.
Time:
Deviation:
800
3.2
3
100
μs
%
s
ms
Interface Signals and Protection
PARAMETER (NOTE 1,2)
AC Power Fail Warning
Auxiliary Power
DESCRIPTION/CONDITIONS
Warning provided prior to Vout dropping 5% after loss of AC input.
Output voltage - diode isolated. Inclusive of line, load, and initial tolerances.
MIN
4
11.6
NOM
12.0
MAX
12.4
UNITS
ms
V
Current Monitor
Output current.
Monitor output current over a compliance range of 0~10V.
Normal output:
0.10
500
mA
mA/A
Total error current:
0.5
0
0.5
mA
Current Share
Input Range Select Status
Loss of Phase Warning
Output Inhibit
Output Interlock
Static sharing deviation as a percent of full-load rating
for loads >10%.
Maximum signal resistance in high input voltage range selection.
Warning provided prior to protective reduction in current limit.
Voltage required to enable supply (0.5 mA sink). (NOTE 3)
Voltage required to enable supply (6 mA sink). (NOTE 3)
Active:
Passive:
500
5
10
0.10
1.0
1.0
%
ms
V
V
Output Overload Protection
Output Overload Warning
Straight line current limit (above approx. 5V Vout).
Signal level on overload.
149
2.2
156
A
V
Output Short Circuit Protection
Occurs on overload when Vout is below approx. 5V.
Iavg:
25
90
A
May operate in burst-mode.
Output Voltage Fault Signal
Output Voltage Margin
Overtemperature/
Deviation from adjusted Vout that is considered as a fault.
Output voltage swing available through Margin pin (analog).
Time between fault warning and shutdown.
±3
±4.8
100
±4
±5.0
±5
±5.2
%
%
ms
Fan Failure Warning
Latching shutdown.
Overvoltage Protection
Latch style overvoltage protection.
55.2
57.6
60.0
V
Power Supply Present Signal
Resistance to logic ground upon insertion of supply.
1000
Remote Sense
Maximum load lead loss compensation (round trip).
1.0
V
NOTES: 1) All logic outputs listed below feature a standard active pull-down output with 0.4V max at 40 mA sink capability, and a 100k pull-up to 5V.
2) In addition to those listed below, signals and front-panel LEDs are provided to indicate: overtemperature/fan fault, AC phase
imbalance, output good, interlock open, and supply inhibited. The FXP also provides 4 LED’s indicating output loading.
3) Both signals must be pulled to logic ground for the unit to operate. Enables are 100% redundant internally for applications where redundant inhibit is desirable.
Contact factory for additional design details.
MCD10162 Rev. 1.0, 04-Jun-10
Page 2 of 8
www.power-one.com
相关PDF资料 |
PDF描述 |
|---|---|
| G-RLX | SWITCH STRGHT LVR SPST 15A SOLDR |
| G002R | SWITCH CAP RECT RED FOR PHA |
| G10,WH | BOX 4.38"X3.25"X.885" WHITE |
| G10A,WH | BOX 4.38X3.25X.885 WHT W/INSERT |
| G13JPCF | SWITCH TOGGLE ILLUM SPDT .4VA PC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FXP7000-48SG | 制造商:Power-One 功能描述:FRONT END 3PHASE 7000W 48V |
| FXP7000-48-SG | 制造商:Power-One 功能描述:AC/DC Power Supply Single-OUT 48V 145A 7KW 制造商:Power-One 功能描述:- Bulk |
| FXP72.07.0053A | 功能描述:天线 2.4GHZ FLX PCB GRND 53MM 1.13 U.FL RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W |
| FXP73.07.0100A | 功能描述:天线 2.4GHZ FLX PCB 1.13 U.FL RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W |
| FXP73.09.0100A | 功能描述:天线 2.4GHZ FLX PCB ANT 100MM 1.13 MMCX(M)RA RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W |
发布紧急采购，3分钟左右您将得到回复。