参数资料
| 型号： | G6Y-1 DC5 |
| 厂商： | Omron Electronics Inc-EMC Div |
| 文件页数： | 4/6页 |
| 文件大小： | 0K |
| 描述： | RELAY RF SPDT 10MA 5V |
| 产品培训模块： | Medical Solutions |
| 产品目录绘图： | G6Y-1 Series G6Y Series High Freq Circuit G6Y Series High Freq Footprint |
| 标准包装： | 100 |
| 系列： | G6Y |
| 继电器类型： | RF |
| 线圈类型： | 无锁存 |
| 线圈电流： | 40mA |
| 线圈电压： | 5VDC |
| 触点形式： | SPDT（1 C 型） |
| 触点额定值（电流）： | 10mA |
| 切换电压： | 30VAC，30VDC - 最小值 |
| 关闭电压（最大）： | 3.75 VDC |
| 关闭电压（最小）： | 0.5 VDC |
| 特点： | 密封式 - 全部 |
| 安装类型： | 通孔 |
| 端接类型： | PC 引脚 |
| 包装： | 散装 |
| 触点材料： | 铜（Cu），金（Au） |
| 操作时间： | 10ms |
| 释放时间： | 5ms |
| 线圈功率： | 200 mW |
| 线圈电阻： | 125 欧姆 |
| 工作温度： | -40°C ~ 70°C |
| 产品目录页面： | 2590 (CN2011-ZH PDF) |
| 其它名称： | G6K 1062C G6Y-1-DC5 G6Y15DC G6Y1DC5 Z119 |
Precautions
■ Correct Use
Long-term Continuously ON Contacts
Using the Relay in a circuit where the Relay will be O N continuously
for long periods (without switching) can lead to unstable contacts
because the heat generated by the coil itself will affect the insulation,
causing a film to develop on the contact surfaces. Be sure to use a
fail-safe circuit design that provides protection against contact failure
or coil burnout.
Seal integrity during cleaning will last 1 minute at 70 ° C. Complete
cleaning within these conditions.
Micro Strip Line Design
? It is advantageous to use the Micro Strip Line in high–frequency
transmission circuits because a low-loss transmission can be con-
structed with this method. By etching the dielectric base which has
copper foil attached to both sides, the Micro Strip Line will have a
concentrated electric field between the lines and ground as shown
in the following diagram.
Lines with impedance Z
? For example, when creating 50- Ω lines using a glass epoxy base
with a thickness of 1.6 mm, the above graph will yield a w/h ratio of
1.7 for a dielectric constant of 4.8. Since the base thickness is
1.6 mm, the width will be h × 1.7 ≈ 2.7 mm.
The thickness of the copper foil “t” is ignored in this design method,
but it must be considered because large errors will occur in extreme
cases such as a foil thickness of t ≈ w.
Furthermore, with the Micro Strip Line design, the lines are too
short for the G6Y’s intended frequency bandwidths, so we can
ignore conductive losses and the line’s attenuation constant.
? The spacing of the Strip Lines and ground pattern should be
comparable to the width of the Strip Lines.
? Design the pattern with the shortest possible distances. Excessive
distances will adversely effect the high-frequency characteristics.
? Spread the ground patterns as widely as possible so that potential
differences are unlikely to develop between the ground patterns.
? To avoid potential short-circuits, do not place the pattern’s leads
near the point where the bottom of the Relay attaches to the board.
Bending the Micro Strip Line
Strip Line w ith impedance Z
El b o w
Clip the corners.
Ground pattern
Dielectric base
(dielectric constant: ε r )
? The characteristic impedance of the lines Z O is determined by the
kind of base (dielectric constant), the base’s thickness, and the
width of the lines, as expressed in the following equation.
45 ° C
W hen the lines m u st c u r v e, an el b o w can b e u sed as sho w n
in the diagram. A distance (D) b et w een the lines of approxi-
ε
1+ 2H
Z O =
r
W
H
377
π W
1+In
π W
H
mately t w ice the line w idth is s u fficient.
Relay Handling
W: Line width
ε r: Effective dielectric constant
H: Dielectric base thickness
The copper foil thickness must be less than H.
? The following graph shows this relationship.
Dielectric constant (ε r )
Micro Strip (w/h)
When washing the product after soldering the Relay to a PCB, use a
water-based solvent or alcohol-based solvent, and keep the solvent
temperature to less than 40 ° C. Do not put the Relay in a cold
cleaning bath immediately after soldering.
338
High Frequency Relay
G6Y
相关PDF资料 |
PDF描述 |
|---|---|
| 0395166015 | 3.81MM EURO HEADER RA GRN 15POS |
| 0395354012 | 5.08MM EURO HEADER STR BLK 12POS |
| L100J3R0 | RES VITREOUS POWER 3 OHM 100W 5% |
| 84140910 | RELAY DUAL 40A 240V ZC 17-32VDC |
| 0395126515 | 3.81MM EURO HEADER RA GRN 15POS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| G6Y-1-DC5 | 制造商:Omron Electronic Components LLC 功能描述:High Frequency PCB Relay |
| G6Y-1-DC6 | 制造商:未知厂家 制造商全称:未知厂家 功能描述: |
| G6Y1DC9 | 制造商:Omron Electronic Components LLC 功能描述:RELAY RF SPDT 10MA 9V |
| G6Y-1-DC9 | 功能描述:高频/射频继电器 900MHZ SPDT 9VDC FREQ RoHS:否 制造商:Omron Electronics 触点形式:2 Form C (DPDT-BM) 触点电流额定值: 线圈电压:5 VDC 线圈类型:Non-Latching 频率: 功耗:100 mW 端接类型:Solder Terminal 绝缘:20 dB to 30 dB at 1 GHz 介入损耗:0.2 dB at 1 GHz |
| G6Z | 制造商:OMRON 制造商全称:Omron Electronics LLC 功能描述:High-frequency Relay |
发布紧急采购，3分钟左右您将得到回复。